The list of input transducer along with their use should be explained. Concept introduction: Transducers play a vital role in analysis process. The real physical world data can be converted into a measurable form with the help of these devices. Basically, transducer is a device which convert any form of signal into electrical signals or vice versa. They can either be used at input or output of a system. There are many factors which are considered while selecting a type of transducer to be used for a task. They are sensitivity, range, accuracy, precision, linearity, size and cost.

Question

Real life applications of standardization of NaOH.

Answer 1

Question

Chapter 1, Problem 1.7QAP

Interpretation Introduction

Interpretation:

The list of input transducer along with their use should be explained.

Concept introduction:

Transducers play a vital role in analysis process. The real physical world data can be converted into a measurable form with the help of these devices. Basically, transducer is a device which convert any form of signal into electrical signals or vice versa. They can either be used at input or output of a system. There are many factors which are considered while selecting a type of transducer to be used for a task. They are sensitivity, range, accuracy, precision, linearity, size and cost.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

Real life applications of standardization of NaOH.

An aquifer contaminated with petroleum is found to have the following component concentrations at a particular site: benzene 158 ppm toluene 124 ppm ethylbenzene 91 ppm xylene 45 ppm n-heptadecane 161 ppm pristane 84 ppm Provide an estimate for the age of the spill at this site using (a) BTEX ratio and (b) nC17:Pr ratio. Show your calculations and use units throughout. Give proper s.f. for the answer.

The protein concentration of a protein isolate was determined using the Bradford assay. Five dilution of bovine serum albumin (BSA) were prepared from a 5.00 mg/mL BSA stock solution. To these dilutions, 100 µl of Bradford reagent were added. After 5 minutes, the absorbance was taken at 595 nm. Standard # BSA, in mg/mL Volume of Bradford reagent, A595 in mL 1 5.0 0.000 1.00 5.0 0.134 3 2.00 5.0 0.265 4 3.00 5.0 0.388 4.00 5.0 0.497 The supernatant dilution was prepared by mixing 49 µL of the protein isolate with 16 µL water. The absorbance was taken 5 minutes after addition of 100 mL Bradford reagent. Calculate the protein concentration (in mg/mL) of the original isolate if the absorbance at 595 nm was 0.413. Note: Final answer format must be x.xxx (three decimal places). Round off only in the final answer. Do not round off in the middle of calculation.