You are a journeyman electrician in an industrial plant. You have been assigned the task of connecting a 25-kW electric heater to a 240-V, single-phase panel. The heater is located in an area with an ambient temperature of 90°F. The conductors are to be copper with Type TW insulation. The heater is expected to operate for more than three hours at a time. What size conductors would you use to connect this heater?

You are a journeyman electrician in an industrial plant. You have been assigned the task of connecting a 25-kW electric heater to a 240-V, single-phase panel. The heater is located in an area with an ambient temperature of 90°F. The conductors are to be copper with Type TW insulation. The heater is expected to operate for more than three hours at a time. What size conductors would you use to connect this heater?

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter19: Special-purpose Outlets-water Pump, Water Heater

Section19.2: Water Heater Branch Circuit

Problem 17R: a. If both elements of the water heater in this residence are energized at the same time, how much...

See similar textbooks

Similar questions

You are a journeyman electrician in an industrial plant. You have been assigned the task of connecting a 25-kW electric heater to a 240-V, single-phase panel. The heater is located in an area with an ambient temperature of 90°F. The conductors are to be copper with Type TW insulation. The heater is expected to operate for more than three hours at a time. What size conductors would you use to connect this heater? Is this correct? I=P/EI=25000 W/ 240 VI= 104.17 amps x 125%I= 130.21 amp/ .96I= 135.63 amp2/0 AWG conductor will be needed
Please kindly help me to answer this question. Please provide all the solutions, givens, and formulas used. Thank you very much! The exciting current of an electromagnet is rated at 12 amperes. When connected across a 122 - volt source the current is 14 amperes. Determine the ohms in a resistor which must be connected in series to limit the current to (a) rated value, and (b) 9 amperes.
1.The exciting current of an electromagnet is rated at 12 Amperes. When connected across a 122-Volt source, the current is 14 Amperes. Determine the ohms in a resistor which must be connected in series to limit the current to (a) rated value, and (b) 9 amperes.
Type your question here Explain the important functions of the condenser in a thermal power station.
match column a to b. Electricity flows from the power plant Through wires to the step-up transformer. The transformer raises the voltage so it can travel long distances - it is raised as high as 756,000 volts. Electricity is generated in the power plant by hydroelectric, nuclear, wind or geothermal energy. The electric current then runs through the power lines to the substation transformer where voltage is lowered to between 2000 and 13000 volts. The turbine spins a huge magnet inside a copper wire. Heat energy converts to mechanical energy which then converts to electrical energy in the generator. From there, electricity comes into your home through a service box, where your heter IS located to electrical consumption. measure your Wires Taice electricity around your home, powering your lights and all your other electrical appliances. Electricity is then taken through the lines to a pole transformer or transformer box if underground then the voltage is lowered again to 120 or 220…
1. Bus bars in electrical substation are made of aluminum because it has i Low cost ii. Low Density ii. High Resistivity iv. Low Melting Point 2. is the greatest demand of load on the power station, during a given period. 3. The arc resistance in circuit breakers doesn't depend on i. Length of Arc ii. Degree of Ionization iii. Cross section of the Arc i. Cross section of the Conductor 4. List out any two limitations of fuse. 5. A 2-wire DC ring distributor is 375m long and is fed with 300V at point A. At point B, 200m from A, load of 150A is taken and at point C, 100m in the opposite direction, a load of 100A is taken. If the resistance per 100m of single conductor is 0.03, find: i. Current in each section of distributor iü. Voltage at points B and C ii. Point of minimum potential
a. If both elements of the water heater in this residence are energized at the same time, how much current will they draw? (Assume the elements are rated at 240 volts.) b. What size and Type THHN wire is required for the load of both elements? Show calculations.
3. Explain how/why the pull-up resistor conducts and under which conditions
9. When making a high energy measurement: a. Attach the meter to the energized line first, then to ground. b. Attach the meter to ground first, then to the energized line. c. Attach both meter leads concurrently. d. Remove power completely, attach the meter, then restore power.
Ohm's Law states that the electric current flowing though a ________ is directly proportional to the ________. Select one: a. closed circuit --- total resistance b. closed circuit --- switch resistance c. open circuit --- supply voltage d. closed circuit --- supply voltage
The amount of heat generated in a conductor or other electrical equipment is a matter of how much current flows and? A. The type of insulation b. For how far c. For how long d. The ocpd
Discuss briefly the classification of electrical heating method