Which of the following is the code of installation (single core single wire) cable? Tesisat kablosunun kodu aşağıdakilerden hangisidir? O A) YVW (NYY) B) NV (NYA) O C) NYCY YVMV) O D) NVV (NYM) E) NYMHY (HO5VV-F)

Which of the following is the code of installation (single core single wire) cable? Tesisat kablosunun kodu aşağıdakilerden hangisidir? O A) YVW (NYY) B) NV (NYA) O C) NYCY YVMV) O D) NVV (NYM) E) NYMHY (HO5VV-F)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter7: Symmetrical Faults

Section: Chapter Questions

Problem 7.21MCQ

See similar textbooks

Related questions

Q: What is the minimum-size supply-side bonding jumper required if installed on the line side of a…

A: The supply-side bonding jumper is installed on the line side of a 300-ampere service disconnecting…

Q: A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60 A,…

A: Given data, The value of area is A = 1 cm2. The value of resistivity for double conductor is ρL =…

Q: What are the precautions that have to be followed while handling the resigns during cable joining…

A: The cable joints are made in this way that the joints are accessible for inspection, when fault is…

Q: Larger conductors should be used for long runs to minimize the? A. Current B. Voltage drop c.…

A: for the long runs the larger conductors are generally used.

Q: Why make two wire, three wire or four wire connection in RTD connection

A: Why make two wire, three wire or four wire connection in RTD connection?

Q: The NEC requires the grounded conductors to be routed to the service disconnecting means enclosure…

A: According to the NEC article code 250.186 (B), "System with a grounded conductor at the service…

Q: Which type of conductor is not used in cables for Transmission Lines? A. Lead B. Steel C. Aluminium…

A: conductor is the most important component of a transmission line. A good conductor should have the…

Q: Give the raceway size required for each of the following conductor combinations: 1. Five, 10 AWG,…

A: The raceway size required for each of the following conductor combination is given as per the…

Q: Service-lateral conductors are required to be insulated except for the grounded neutral conductor…

A: According to NEC 230.30 (A), underground service conductors are insulated for the applied voltage.

Q: 3. The towers of height 35 m and 95 m respectively support a transmission line conductor at water…

Q: How do voids in the insulation cause breakdown of the cable?

A: For the transmission and distribution purpose of electric power, high voltage cables are used. The…

Q: 1-DO you need a repeater station if we used optical cable under the sea level? And why?

A: If we used optical cable under sea level then there is a chance that it lose or reduce its signal.…

Q: What are two advantages of using twisted pair cabling over coaxial cabling on a network? a. Twisted…

A: In this question, Choose the correct options What is advantage of the twisted pair cabling over…

Q: In terminating the coaxial cable, if the present procedure is to cut part of the braided shield and…

A: Procedure for terminating coaxial cable Step 1: The tools you will need: Compression tool Cable…

Q: 1.A. When a grounding electrode conductor is connected to the grounded conductor within a…

A: (1.A) According to Section 250.24(B) of National electricity code (NEC) , When ground electrode…

Q: 11. Which of the following statements about the use of structural steel as an equipment grounding…

A: We are authorized to answer the first question since the exact one wasn’t specified. Please submit a…

Q: 8- Generally as of the operating voltage which of the following options are the correct words that…

Q: What is granding of cables? Explain.

A: to explain grading of cables

Q: A(n) _________ is a reliable conductor used to ensure the required electrical conductivity between…

A: The explanation is as follows.

Q: Label the parts of Tubular Steel Poles

A: Steel tabular poles are not commonly used poles these poles are used when there is need of low cost…

Q: Which type of conductor is not used in cables for Transmission Lines? О А. Соррer O B. Aluminium O…

A: A conductor is the most important component of a transmission line. A good conductor should have the…

Q: The floating power supply is a method for anti-interference in which neither of the conductors is…

A: The floating power supply is nothing but neither of the conductors is connected to the line carrying…

Q: Where nonmetallic-sheathed cable is run at angles with joists in unfinished basements, it shall be…

A: According to article 334 nonmetallic -sheathed cable . Where nonmetallic-sheathed cable is run at…

Q: 14. If the center conductor of a coaxial cable is made to have smaller diameter, all other things…

Q: 14.a. Section 250.94 requires that an IBT be accessible for inspection and termination and have the…

A: 14.a. IBT stands for Intersystem Bonding Terminal. According to NEC Section 250.94 (B) An IBT be…

Q: What's the required bend radius for three-conductor, 3/0 AWG service entrance cable that's…

A: Given, Three-conductor, 3/0 AWG service entrance cable that's approximately 1 inch in diameter.

Q: How many conductor volume allowances should be applied for the equipment grounding conductors in the…

A: We need to answer how many conductor volume allowances should be applied for the equipment grounding…

Q: Discuss Suspension insulators are recommended in high voltage transmission lines.

A: Pin encasings become excessively cumbersome an uneconomical past 33 kV. Thus, for voltages higher…

Q: What is the percentage voltage drop for a 208V, three-phase feeder serving a load of 200A at a…

A: Given data, Voltage V = 208 V Load current i = 200 A Distance l=290 feet = 88.4 m For 4/0 copper…

Q: a) High Voltages are preferred for Transmission of Electricity. Why?

A: As per bartleby expert policy, only one individual question is to be answered. Higher voltages are…

Q: b) Why Generation Voltage Levels are low in the range of 11 kV/ 33 kV etc? c) Why ACSR Conductors…

A: b) we know that the voltage drop in line depecds upon various factors such as:- Load value, load…

Q: Explain some of the factors that have contributed to the delays in undersea cable maintenance.

A: Communication is the exchange of information. Information can be imparted to either individuals or a…

Q: A set of conductors is used to supply residential unit with a total load current of 60 A at a…

Q: Explain the working of LVDT with neat diagram.

A: LVDT : LVDT is divice which translates linear motion into electrical signal

Q: separable

A: Given that Which of the following conductors in a typical separable connection plug and receptacle…

Q: 13. If the largest ungrounded service-entrance conductor for a service is 750-kcmil copper, what is…

A: Choose the correct option, If the largest ungrounded service-entrance conductor for a service is…

Q: What is grading of cables, explain.

A: Grading is defined as the process of equalizing the stress in the dielectric of the cable.…

Q: (i) List any three factors to be considered for mechanical design of overhead lines

A: List of the factor to be design overhead transmission line

Q: What Cable Color-Coding is typically used for the Earth Wire in the Sultanate of Oman? A. GREEN AND…

A: Sultanate of Oman the following colour coding is used

Q: what is the voltage between neutral and protective earth conductor in the TN-S earthing schemes…

A: In TN-S earthing scheme, T stands for solid earthing, N denotes the presence of the conductor having…

Q: In terminating the coaxial cable, if the present procedure is to insert the BNC connector, length…

A: Important tools for making a coaxial cable: Compression tool Cable Stripper Compression Connectors…

Q: What is need of using copper conductors instead of aluminum in underground transmission system?

A: In this question , we will write the reason why copper conductor used in underground transmission…

Q: a) High Voltages are preferred for Transmission of Electricity. Why? b) Why Generation Voltage…

Q: How many 14 AWG THHN conductors, including an equipment grounding conductor, can be installed in a…

A: Here we have to refer standard tables, When determining the maximum number of conductors permitted…

Q: Airframe Electrical System Question: Which wire installation type has the best rating and is the…

A: The wire installation type with best rating and most resistive to breakdown in a chemical…

Q: procedure for UG cable Joining?

A: It is asked to explain the procedure underground (UG) cable joining.

Q: 4.a. An intersystem bonding termination will typically be used as a ground junction for a/an A.…

A: Answer 4.(a) According to 214 NEC, Intersystem bonding method is only one bonding method permitted…

Q: Why do multiple conductors in dc, 1-phase, and 3-phase power cables not disturb the magnetic compass…

A: Multiple conductors in DC, 1- phase, or 3 phase power cables do not disturb the magnetic compass…

Concept explainers

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.

Question

Which of the following is the code of installation (single core single wire) cable?
Tesisat kablosunun kodu aşağıdakilerden hangisidir?
A) YW (NYY)
B) NV (NYA)
C) NYCY (YVMV)
O D) NVV (NYM)
E) NYMHY (H05VV-F)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate the self-GMD of stranded wire with 2 strands. a. Radius of each strand is 0.001 inch. b. The radius is doubled.c. The radius is halved
In a string of suspension insulator with three units, the line unit has 20kV and k=0.35. The voltage across tower unit is........ and across middle unit is.......
3. What are the classifications of Core Loss and Copper Loss?
1)What is a twisted pair cable?What are its two types and draw the sketch?
5.a.Which organization determines allowable maximum fill ratios for different cables?A. IEEEB. IECC. ANSID. NEC5.b. When should corner pull boxes be used in an installation?A. At all 90 degree bendsB. At all bends less than 90 degreesC. At all bends greater than 100 degreesD. At all bends
The ---_characteristi cs shows the relation between the generated e.m.f at no load and the field current. O a. internal b. non-magnetic C. external d. magnetic
1 - Why make two wire, three wire or four wire connection in RTD connection?A) To be a backup connection lineB) To increase the magnetic fieldC) Because the resistance of the long connecting wires causes errorD) To increase the costE) For better cooling
Which of the following Surge Diverter use non-linear resistances in its fabrication? Rod - Gape SD. Lightning Arrester SD. Expulsion Tube SD. O All of the above.
What is load line and what is duty cycle?
Single core cable design for 25 kV. The radius of conductor is 0.5 cm. The insulation material consists of two layers. The thickness of each layer is 2 cm. The voltage of first and second layers are 20 kV, 5 kV respectively. The maximum Electric stress of the cable is
The three bus-bar conductors in an outdoor sub-station are supplied by units of post insulators. Each unit consists of a stack of 3-pin insulators fixed one on the top of the other. The voltage across the lowest insulator is 8-45 kV and that across the next is 7-25 kV. Find the bus-bar voltage of the station.
Write in Briefly about circuit breaker, current transformer and voltage transformer