3. The towers of height 35 m and 95 m respectively support a transmission line conductor at water crossing. The horizontal distance between the towers is 550m. If the tension in the conductor is 1550 kg, Weight of conductor is 1-75 kg/m. Bases of the towers can be considered to be at water level. Estimate: i. distance between lowest point on conductor and each tower ii. sag at each tower iii. the minimum clearance between ground and conductor

3. The towers of height 35 m and 95 m respectively support a transmission line conductor at water crossing. The horizontal distance between the towers is 550m. If the tension in the conductor is 1550 kg, Weight of conductor is 1-75 kg/m. Bases of the towers can be considered to be at water level. Estimate: i. distance between lowest point on conductor and each tower ii. sag at each tower iii. the minimum clearance between ground and conductor

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The towers of height 45 m and 85 m respectively support a transmission line conductor at water crossing. The horizontal distance between the towers is 550m. If the tension in the conductor is 1550 kg, Weight of conductor is 1·65 kg/m. Bases of the towers can be considered to be at water level. Estimate: i. distance between lowest point on conductor and each tower ii. sag at each tower iii. the minimum clearance between ground and conductor
A 60 Hz, three-phase, transposed transmission line, is designed with three bobolink conductors per phase, in horizontal arrangement as shown in the figure below. Distance between consecutive phases is D = 6.2 m and distance among bundle conductors is h =0.5m. Each conductor has a radius of 18 mm and a GMR of 14.39mm. The per phase resistance is 1.677x10-5 2/m. r= 18 mm GMR= 14.39 mm a b h D D The per phase shunt admittance assuming zero conductance in µO/km is: О a., 5.4347 O b. j5.3316 О с /4.2266 O d. j4.0973 O e. 59630.2922 + j10.9770
An overhead line has span of 260m. The tension in the line is 1200kg while the conductor weighs 650 kg per 100 meters. Calculate the maximum SAG in the conductor. If the height of the tower is 13 meters, estimate the clearance of conductor to the ground. Draw a figure and mark values of sag, clearance, span, height of conductor etc.
A three-phase transposed line is composed of one ACSR Bobolink conductor per phase with a horizontal spacing of 11 meters as shown in the figure. phase with a horizontal spacing of 11 meters as shown in the figure. The conductors have a diameter of 3.625 cm and a RMG of 1.439 cm. Calculate the inductance and capacitance to the neutral of the line.
a) The conductor shown in the figure below is composed of five strands. The diameter of each strand is 2.5 mm. Find the GMR (Geometric mean radius) of the conductor. b) The distance between conductors of a single-phase line is 3 m. Each conductor is composed of five strands as shown above. Find the inductance of the line.
Problem #1 • An overhead line has span of 260m. The tension in the line is 1200kg while the conductor weighs 650 kg per 100 meters. Calculate the maximum SAG in the conductor. If the height of the tower is 13 meters, estimate the clearance of conductor to the ground. Draw a figure and mark values of sag, clearance, span, height of conductor etc.
Q4(a) The differences between TWO unequal towers 60 m support a transmission line conductor at road crossing. The given span length is 499.5 m as show in Figure Q4(a). If the tension in the conductor is 1700 kg, determine the minimum clearance of the conductor and road and clearance mid-way between the supports. Weight of conductor is 1-5 kg/m. Bases of the towers can be considered to be at road level. Given height of the tower A is 35 m from the ground level. Span Length= 499.5 ROAD Figure Q4(a)
Problem: A three phase transmission line is being supported by 3 disc insulators. The potential across top unit (near the tower) and middle unit are 8 kV and 11 kV respectively. Determine; i) ratio of capacitance between pin and earth to self capacitance of each unit, ii) the line valtage and iii) string efficiency.
7. Two towers of height 40 m and 30 m respectively support a transmission line conductor at water crossing. The horizontal distance between the towers is 300 m. If the tension in the conductor is 1590 kg, find the clearance of the conductor at a point mid-way between the supports. Weight of conductor is 0-8 kg/m. [59 m] Bases of the towers can be considered to be at the water level. heed taonamiggien li
Consider the 500 kV, three phase bundled conductor line as shown in the figure below. Find the line to neutral capacitance. 0.5 m 30 mm (0) (O to Ine 15 m 15 m
An over head transmission line has a cross area of conductor of 4 cm and supported from two towers. The distance between the towers is 200 m. If the two supported point are location at the same level. The conductor is cover by ice layer of thickness of 1.5 cm. The wind pressure is 200 N/m?. The weight of one meter of the conductor is 6 N. Let point D is location at the conductor has a vertical distance of 2 m far from the upper limit level of the towers. Find the horizontal distance between this point and point o (the middle point between the towers).
The towers of height 45 m and 85 m respectively support a transmission line conductor at water crossing. The horizontal distance between the towers is 550m. If the tension in the conductor is 1550 kg, Weight of conductor is 1.65 ky/m. Bases of the towers can be considered to be at water level. Estimate: i) distance between lowest point on conductor and each tower ii) sag at each tower iii) the minimum clearance between ground and conductor