When filled to capacity, the unpressurized storage tank shown contains water to a height of h- 21 ft. The outside diameter of the tank is 8 ft and the wall thickness is 0.625 in. Determine the maximum shear stress at the base of the tank (Weight density of water 62.4 Ib/ft) O 311 psi O 441 psi O 292 psi O 221 psi O 345 psi

Determine the largest internal pressure that can be applied to a cylin-drical tank of 5.5-ft outer diameter and 5/8-in. wall thickness if the ulti-mate normal stress of the steel used is 65 ksi and a factor of safety of 5.0 is desired

The resulting stress distribution along section AB for the bar is shown. From this distribution, determine the approximate resultant axial force P applied to the bar. Also, what is the stress concentration factor?

88tc AB has o weight of mine the minimum depth o 0pen it. The gate is. s rubber seal at 4.

Using the information obtained about the stress-concentration factors in the member, determine the maximum applicable axial force PP that can be applied to the member. Express the maximum applicable axial force in kilonewtons to three significant figures. Required information in the attachment.  Thanks!!

A cross-section of a beam is shown in Figure Q2. If the shear force in this section is V = 281 KN, determine the value and the location of the maximum shear stress in the section. In Figure Q2, a = 72 mm and the origin of the coordinate system is at centroid of the cross section. Z A a AY 2a O 4a Figure Q2 J.L B 3a a

A trough whose cross section is a trapezoid is b = 4 m across at the bottom, a = 6 m across at the top, and 3 m deep. If the trough is filled to 1 m with water, what is the force due to water pressure on one end of the trough? с b (Hint: Using SI units, pg = 9800 N/m³.) (Use decimal notation. Give your answer to two decimal places.)

The 500-kg load on the hydraulic lift shown in the figure on the right is to be raised by pouring water into a thin tube. Determine how high h should be in order to begin to raise the weight

The pressure tank is fabricated from spirally wrapped metal plates that are welded at the seams in the orientation shown. The tank has an inside diameter of 700 mm and a wall thickness of 8.9 mm. For a gage pressure of 1.27 MPa, determine (a) the normal stress perpendicular to the weld (use positive for tension, negative for compression) and (b) the shear stress (absolute value) parallel to the weld. Assume = 51. s Answers: (a) Normal stress= (b) Shear stress - MPa MPa

As shown in the figure below, oil is inside the hydraulic press with SG=0.82. What force F is required to support a load of 10KN if we are to neglect the weight of two pistons. (Answer must be in N) 8. 10 kN 25 mm 400 mm 75 mm0 Hinge 25 mm 0