"What will be the generated rms voltage of 4-pole generator with 6 turns rotor coil, if its voltage wave isrepresented by the expression e = 110 sin(50.t)"T TTArialTE EABC3 (12pt)

Answered: Image /qna-images/answer/cbe6fc90-240e-4fed-ab7d-8491ecfe1bba.jpg

Answered: "What will be the generated rms voltage…

"What will be the generated rms voltage of 4-pole generator with 6 turns rotor coil, if its voltag represented by the expression e = 110 sin(50.t)" T TTArial ABC 3 (12pt) T E II

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2P: Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your...

See similar textbooks

Related questions

Q: The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A,…

A: Alternator voltage V = 300 v Alternator current I = 20 A Voltage leads the current by an angle ¢ =…

Q: QI) For the circuit of Fig. I: a. Draw the admittance diagram. b. Draw the phasor diagram. c. Verify…

A: In the circuit, Draw the admittance diagram, phasor diagram and verify with KCL. Average power…

Q: A two-pole three-phase 50 Hz Y-connected AC generator has 9 slots per pole and 6 conductors per…

A: This question belongs to electrical machine . It is based on the concept of induced voltage in a.c.…

Q: C is ↑ 7.5 mH 12 Ω For the circuit shown above, what is the maximum average power that can be…

Q: Calculate the average power, the reactive power and the apparent power absorbed by the load in the…

A: The given current is, ig=30 cos 100t mA In phasor form, Ig=30∠0° mAXL=ωL=jXLXC=1ωC=-jXC The circuit…

Q: A series generator delivers a power of 6.25kW and a load resistance of 25Ω. If RA=0.05Ω and…

Q: Determine the complex power, S, absorbed by the load, ZL. (Remember: S = Pav + jQ). Assume the…

A: Given circuit shown

Q: 27. A coil in the radio transmitter has an inductance of 150 milli henry. At what frequency will it…

A: To find frequency at which inductive reactance is 1884 ohm Given L = 150 mH

Q: 50 -j22 1:2 a 36 0 1:3 V 20° V rms For the circuit shown, if V= 66, the average power dissipated in…

A: Equivalent resistance from the primary side is calculated as, R(primary ) =R(secondary )a2, where a…

Q: The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A,…

A: r

Q: 1. The voltage applied to a coil having R=200 2, L= 638 mH is represented by e= 20 sin 100 t. Find a…

A: First calculate impedance of the coil and using ohms law calculate expression for current flowing…

Q: Q1. A 550-V is supplied to a plant comprising of a parallel-connected induction motor drawing 75 kW…

A: NOTE: Since you have asked multiple questions, we will solve the first question for you. If you want…

Q: Question 1: A240-V rms 60-Hz source supplies a parallel combination of a 5-kW heater and a 30-kVA…

A: In this some load is given...For power factor improvement ,capacitor is connected...We have to find…

Q: In Fig. 11.12, the resistor R₁ is adjusted until it absorbs the maximum average power. Calculate R₁…

A: Given here a electrical circuit and assked to find the find the RL and maximum average power.

Q: Determine the rms value of v(t)=5+10 cos(20πt).

Q: 10.2 Calculate the average power absorbed by the resistor and inductor. Find the average power…

Q: The voltage v = 207 sin(100t+50°) V is connected acroos a 5-H inductor. Determine the inductive…

A: Inductive reactance = wL Where w is the frequency in rad/second and L is the frequency.

Q: Calculate the average power transferred by the source in the circuit given below. 2 H 50 cos5t 1 H :…

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Q: Given a load in which V=15e^(jπ/6) and I=7.5e^(j5π/3) calculate the (peak) reactive power in…

Q: An AC The voltage is represented by e = 141.4 sin 628 t .So do the following calculation. (1)…

A: Solution: A voltage is represented by; e = 141.4 sin 628 t Find: the following calculation: -Maximum…

Q: 44. Calculate the average power delivered to each resistor shown in Fig. 13.66. 50 Ω 38 Ω 1:9 1:4 5…

A: In this question we need to find a average power absorbed by each resistance in the given circuit.

Q: An electrical system has a load of 5,000 kw at a lagging power factor of 0.67. If a 3,000-kva…

Q: (c) A 240 V rms 50 Hz supply serves four resistive loads that is 10 kW each, an inductive load of 75…

A: In this question we need to find a current supply by source for the given load , KVAR rating and…

Q: Find the rms value of the current waveform of Fig. 11.15. If the current flows through a 9-…

A: given here a waveform and asked to find the rms value and average power dissipated through the…

Q: The voltage and current for a device (using the passive sign convention) are periodic functions with…

Q: A generator is supplying a load of 500 kW at a power factor of 0.8 lagging. If the power factor is…

Q: If there is 300 (phase 0) V rms voltage at the terminals of the loads given below, how many amps rms…

Q: Find the value of parallel capacitance needed to correct a load of 120 KVAR at 0.75 lagging pf to…

Q: Given the voltage equation 270 sin (100t – 67o ) V, what will be the instantaneous voltage at 33ms?…

A: we need to find out instantaneous voltage at 33ms.

Q: Calculate the instantaneous power and average power absorbed by the passive linear network if v(t) =…

A: Given values are - vt=80cos10t+20oVoltvt=80sin10t+110oVoltit=15sin10t+60oA

Q: 2 that absorbs the naximum average power. Calculate that maximum average power. -J4 2 j10n 2/0 A Z.

Q: A 2 pole 50 Hz, 13 kv, 200 MW alternator has moment of intertia 20000 kg-m2. What is the value of…

A: Given values are - Moment of inertiaJ=20000kg-m2RatingG=200MWf=50Hz

Q: A 240 V rms 50 Hz supply serves four resistive loads that is 10 kW each, an inductive load of 75…

Q: A 230V, 50HZ single-phase alternator supplies a fully-loaded 15kW induction motor. The full-load…

A: (i) The real power is the input power. The efficiency and the output power of the alternator are…

Q: An alternator is supplying a load of 300 kW at a power factor of 0.6 lagging. If the power factor is…

A: Given, Active power rating, P1 = 300 kW Power factor, cosϕ1 = 0.6 lagging At power factor, cosϕ2=1…

Q: The voltage and current at the terminals of a network are: v = 100 + 50sin(500t) + 10cos(1500t) V, i…

A: first we will split given signals into dc , fundamental , third hormonic then Total power = power…

Q: 1. Calculate the RMS value of the current waveform and determine the average power absorbed by a…

Q: 40 mH (15.1 2) 120 L0 Rms Ve 120 µF (-j22.1 2) 102 b) Current I delivered by the voltage source

Q: d.) Average power e.) f.) Power when t=1/480 sec, 1/240 sec, 1/90 sec. Draw voltage, current and…

A: In this question, We need to calculate the average power, power at different different time and…

Q: Determine the average power delivered to networks having the following input voltage and current as…

Q: The equation for 60 cycles current sine wave having RMS value 30 amperes, will be ____. Kindly…

A: The solution is given below

Q: An alternating voltage is given by v = 278.6 sin 324t volts. Find the instantaneous value of voltage…

Q: The equations of current in two parallel-connected electric devices are i, = 11.3 sin(377t + 45°)…

A: In this question we need to find a RMS value of resultant current.

Q: 16. Find the value of impedance which absorbs a complex power of 2300 VA with a 30 degrees angle at…

Q: cted to a motor. Calculate the real power, reactive power P= Q= Calculate the power and reactive…

A: In this question , power factor is improved by connecting capacitor bank ...We have to determine…

Q: An industrial plant consisting primarily of induction me 0.85 power factor lagging. Compute the…

A: Given Power S = 1200 KVA at 0.85 pf Ti determine the shunt capacitor required to improve power…

Q: A battery is connected in series with a small generator to supply a purely resistive load of 5 ohms.…

Q: A 5000 hp 3-phase, induction motor operates at 80% efficiency and 0.85 power factor lag. The…

A: Given values are -

Q: 11.) A single phase inductive load at 0.70 power factor lagging takes 32 kVA power. Compute the…

A: The solution is given below

Concept explainers

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.

Question

"What will be the generated rms voltage of 4-pole generator with 6 turns rotor coil, if its voltage wave is
represented by the expression e = 110 sin(50.t)"
T TTArial
TE E
ABC
3 (12pt)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The voltage regulation of alternator can be regulated by changing its rotational speed. O True O False
2, In a circuit, the capacitance of a capacitor is 3.2 microfarads and the rms voltage of the generator is 50 volts. Frequency (a) 100 Hz and (b) what is the rms current in the circuit when it is 1000 Hz?
A triangle waveform with following specifications in Table B1. Table B1 RMS Voltage 50mV Number of cycles/second 100 i) Sketch the approximate triangular waveform with all specifications. ii) A transformer has primary coil with 100 turns and secondary coil with 120 turns. Estimate the current in the secondary coil, If the current in the primary coil is 4 Ampere
The reactive power output of an alternator is limited by load angle True False
The rotor of a 4-pole ac generator is wound with a 200 turns coil. If the flux per pole is 5 mWb and the rotor runs at a speed of 1500 rpm, the rms value of the induced voltage for this AC generator is nearly?
The alternator frequency is direct function of rotational speed and number of poles. O True O False
A synchronous generator generates 370 V at 55 Hz when the field current is 4.4A. The e.m.f generated when the frequency is 35HZ and the field current is 2.9A is ..... .......
Due to mutual inductance between two coils, there is an induced emf in one coil due to a change in current in the other coil. O True O False O Hard to say
6. Determine the rms current I as shown in figure 1. Source voltage is already in RMS value (Answer must be in polar form and should be in 4 decimal places). -j4 N j1.5 A B 4 0 A 200/30° V -j2 N: jIN Figure 1.
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
A Star 3Phase source with phase voltage of 400V at 50HZ is connected to a delta connected 3Phase AC Motor. The transmisson line resistance from source to load terminal is 1 Ohm. The internal resistance of each winding of motor is 9 Ohm and the inductance of each coil is 38.2 mH. What is the true power delivered to load? O A) 15999 B) 14999 C) 13999 O D) None