16. Find the value of impedance which absorbs a complex power of 2300 VA with a 30 degrees angle at 115 V rms.
Q: For the power amplifier a) Calculate the power input and power output if the input signal results i...
A:
Q: out R, R,= 10KO = 2KO
A:
Q: Given the differential input signal between V1 and V2 is 1mV. calculate the expected peak to peak am...
A: According to the question, for the given circuit as shown below If V1-V2= 1 mV, then we need to cal...
Q: design a circuit for a digital lock that unlocks for all the even numbers put in as a 4-bit input.
A: As per our guidelines we are supposed to be answer the first question only. Kindly repost the other ...
Q: Using re model, compute for the AC characteristic of below circuit. a. Zi b. Zo c. Av d. Ai
A: The required parameters of collector DC feedback configuration of CE amplifier can be calculated by ...
Q: A LPF has cutoff frequency of we = 100 rad/s. The filter is repeated three times. Find the new cutof...
A: Given: A LPF has a cutoff frequency of ωc = 100 rad /sec The filter is repeated 3 times. To find: Fi...
Q: Find the time constant for the RC circuit. Take C= 700 mF. 120 2 12 Ω 50 V (+ 80 Ω C The time consta...
A: Given circuit, Capacitance, C = 700 mF
Q: 3/What is the Confficient by which it is multiPlied RA 2 RY= .. RA --- -
A:
Q: 1. Calculate the current in J3 ohm inductor; compute the power of J3 ohm. Use Nodal analysis - j22 l...
A:
Q: Q2.2 Concatenation in the Frequency Domain Two LTI systems are concatenated. This time, the first sy...
A: Concatenation means series connection of the two systems
Q: Consider a Wheatstone bridge circuit that has all resistances equal to 900 ohms. The resistance R1 i...
A:
Q: Determine Vas, ID and UDs-
A:
Q: 1) What is the advantage of diode D1?
A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve first three sub-...
Q: 2. Which momentary voltage occurs when the conductor loop is in a uniformly rotating generator at 45...
A: When a conductor of length (l) moving with velocity (v) in Magnetic field of density (B) Then it exp...
Q: Material GAAIAS GaP Color Wavelength (nm) V-forward 1.8 Super Red Green 660 565 Red GAASP AllnGaP 64...
A: The solution is given below
Q: What is the voltage amplitude and frequency of the waveform below. Trig Vertical Pos Hprizontal Pos ...
A: From The CRO waveform settings we can calculate peak to peak voltage and frequency.
Q: 6. A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armat...
A: The solution is given below
Q: cample 3: Using KVL, Find VI, V2, and V3 in the following circuit. 18V V3 25 V 10V V2
A:
Q: . A battery charger meant for a series connection of ten nickel-cadmium batteries (total emf of 12.5...
A: (a) Consider the relation between the turns and the voltage of the transformer is, V1V2=N1N2
Q: * Question Completion Status: Determine the magnitude of the total current labeled lo for the circui...
A: The solution is given below
Q: A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature...
A: The solution is given below
Q: Single 1. Wavelength is the distance traveled by an electronic wave during the time of one cycle. Gi...
A:
Q: 1. Consider the CRC generator shown below. Determine the output of the CRC circuit (i.e. Q4 Q3 Q2 Q1...
A:
Q: Calculate the reactance of a coil of inductance 0.2H when it is connected to a 50Hz supply. A. ...
A: The solution is given below
Q: How many GPS Satellites are present?
A: In this case, the number of GPS satellites present should be found.
Q: If w = 2n · 60 = 377 rad find the time-domain functions for the following phasor %3| voltage and cur...
A: 1st convert the complex representation into the Euler representation. That is r angle theeta.
Q: average ac resistance for
A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is revers...
Q: 3. Use nodal analysis to solve the circuits below.
A:
Q: Determine the current using the practical model. 20 V Si Si 102 202
A: The solution is given below
Q: The voltage across by a voltmeter connected across it. a resistance R5 in the circuit of Figure is t...
A: The given circuit is shown below:
Q: (a) [3] Write 1101012 in decimal form. (b) [4] Calculate 110102 – 11012 in binary form. [Do not conv...
A:
Q: For the given circuit and input waveform determine the output waveform 2.2 kn 20 5 V -5
A: Given circuit is a series negative clipper with positive reference voltage This reference voltage te...
Q: -1 Synthesis of nanomaterial from larger bulk Top-Down method Select one: O True O False
A: Generally in Top- Down method , the synthesis of nano materials from larger bulk .
Q: 4. Show that for all R>0, C>0, and w>0, the power factor of a series RC circuit and of a parallel RC...
A: Power factor: It tells how much active power is utilized by the circuit from the apparent power.
Q: WHAT IS THE AVERAGE LOAD VOLTAGE OF THE CIRCUIT? D2 D3 中中平 220 V ka 本平本 D4 DS DC
A: Lets us assume given diodes are ideal . Forward voltage drop of ideal diode is VD(on)= 0 V It act as...
Q: 6- Find z transform of the signal x(n) which x[n] =(%)" sin(¾n)u[n]
A:
Q: Given : The system shown 400 customers at 500 KWh/month LOAD 1 600 customers at 300 KWh /month Power...
A:
Q: Explain the difference between transformer equivalent circuit and IM equivalent circuit.
A: Equivalent circuit- An equivalent circuit is a simplified circuit (or model) that is easier to analy...
Q: Answer the question briefly. 1. What is Alternating Current (AC)? Draw a simple graphical representa...
A:
Q: Voice information with a frequency range of 0.3 - 4 kHz is sampled according to Nyquist requirements...
A: It is given that: fm=0.3~4 kHzL=256 levelsn=log2256=8 bitsd=0.5M=16
Q: he rotor is star connected and has an impedance of (0.8 + j6) ohm per phase. Find the rotor current ...
A: Solution- Given, Rotor impedence = 0.8+j6 ohm Stator impedence = 4+j3 ohm Voltage = 65 V sl...
Q: Evaluate the integral: 3 I= ƒ (t + 8) [S (t) + 98 (t – 1)] dt. Express your answer using three signi...
A: Given, I=∫-13t5+8δt+9δt-1dt
Q: Consider the following separately – excited DC generators the terminal voltage (VL)= 200 V short cir...
A: The solution is given below
Q: 3. When the bandwidth of x(t) is Qn , find the bandwidth of x²(t).
A:
Q: SHOW YOUR SOLUTIONS. In a BJT, the emitter current is 15 mA and the emitter current is 1.08 times th...
A:
Q: determine q and i in rld with l=2 hr=4 and c=0.05 with emf=100 and initial conditions q=i=0 at t=0. ...
A: The data given in question are: L=2H, R=4Ω, C=0.05F, E=100V, q=0, i=0 We assume it to be series RLC ...
Q: Consider Figure 2.9 of the text. Let the nodal equations in matrix form be given by Eq. (2.4.1) of t...
A: This problem comes under power system . It is based on the concept of formation of Y bus matrix and ...
Q: Find the phase angle between i1 = -4sin(377t + 25°) and i2 = 5cos(377t - 40°). a. 155 degrees b. 1...
A: The solution is given below
Q: 2. A couple of systems move electrons on conductor (a material that allows the flow of electrons). S...
A:
Q: Why do we need maximum power transfer? Explain
A: The maximum power theorem states that the source will deliver maximum power to load in two cases: (1...
Step by step
Solved in 2 steps with 2 images
- Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?For a given series RC circuit with resistance R= 50 ohm and capacitance C= 1.5uF connected to an ac voltage source of 60V, 2500 Hz, then the magnitude of current through the circuit is Select one: Oa. 3.45A Cb.0915A Oc.None of these O d. 5.45A Next pag umn tr ere to searchFor a given series RC circuit with resistance R= 50 ohm and capacitance C= 1.5uF connected to an ac voltage source of 60 V, 2500 Hz, then the magnitude of current through the circuit is Select one: a. 5.45A b. 3.45A c. 0.915A d. None of these
- The rms value of the resultant current in a wire carries a dc current of 10 A and a sinusoidal alternating current of peak of value 20 A is-A parallel circuit has 10 ohms of resistance and a capacitive reactance of 15 ohms, An ac rms voltage of 200 V isapplied across it. What is the magnitude of the total current?Describe the resulting waveforms when the capacitors (initially 20uF and then replaced with 100uF) were connected in parallel with the load
- can you please give me the comple solution for this question, thanks. A certain voltage function contains a constant term, a fundamental and third harmonic. The maximum value of the fundamental is 85 % of the constant term and the maximum value of the third harmonic is 55 % of the constant term. If the effective value of this function is 180.3V, find the magnitude of the two harmonics. A.IstHarmonic = 75 V , 3rd Harmonic = 120V B. Ist Harmonic = 80 V , 3rd Harmonic = 125V C. IstHarmonic = 120 , 3rd Harmonic = 75V D. Ist Harmonic = 125 V , 3rd Harmonic = 80V E. NOTATransform from sinusoid to phasor 5cos4t + 7sin4tShown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 9.35 Volts and is running at a frequency of f = 113000 Hz. The resistor has a resistance of R = 1980 , the capacitor has a capacitance of C = 1.08e-09 Farads, and the inductor has an inductance of L = 3.71e-03 Henries. mm Vps Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit øztot Determine the numerical value of Ztot = 2384 Determine the numerical value of @Z tot Determine the current through the circuit: ● R www I(PEAK) = I(RMS) = ● ● Determine the voltage across the inductor: • VL(PEAK) = Volts Volts VL(RMS) = Amps Amps Determine the voltage across the capacitor: Vc(PEAK) = Volts Volts Vc(RMS) = = 33.85 a capacitive switcher Ω degrees C If a second circuit were connected in parallel with the resistor, this circuit would be considered as: O a high-pass filter a radio tuner O…
- In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage4. Find Idc, Vdc and the capacitance that will force the Vr(pp) to 2mV. Draw the output waveform across the capacitor. Fin=60HZ. TX1 D1 Ge Vac Lst 230V Lp 1 RL 12-0-12 Center tapped CL 1k D2 Ge 2Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 Vusing a single 14 V dc voltage source