What power must be supplied by the pump to the flow if water (T =20°C) is pumped through the 300 mm steel pipe from the lower tank to the upper one at a rate of 0.314 m^3/s?

Q: With reference to the figure below a power station uses a condensor in order to condensate steam for…

A:

Q: to pump water from lower reservoir to upper reservoir, a centrifugal pump is used. if the length of…

A: Given:Suction head=3 mdelivery head=30 m

Q: An effluent with a density of p = 990 kg/m³, is pumped from the wet well using a 40- mm diameter…

A:

Q: A pump is used to transfer crude oil from a non-pressurized oil tanker to a storage tank at a…

A: As all the units of the parameters in the given problem are irregular, convert all the units into SI…

Q: A pump is to be placed at the beginning of a 30 m long piping system consisting of 1-1/2 inch…

A: Release head differs with pull tank level. The response is yes. Assuming you bring down the pull…

Q: Water issues from the-14 nozzle of a horizontal hose- pipe. The hose has an internal diameter of 70…

A: Find the flow rate through the pipe.

Q: 1. Water (p = 1000- kg H = 10-3 flows in a horizontal constant-area pipe; the pipe cross ms section…

A:

Q: A fertilizer delivery system is shown in the figure. The hose is made of a material whose…

A: Solution: Given Data: CR=0.12d=25 mmD=30 mmR=1.3 mV=5.4 m/sη=75%SG=1.1h=10 m - 1.2 m = 8.8 m

Q: Water enters a turbine through a 320mm diameter pipe at the rate of 215 lit/s at a pressure at A of…

A: given data  diameter at A = 320mm flow rate = 215 lit/s pressure at A = 150kpa pressure at B = -35…

Q: The diameter of an open topped tank 1.5 m high increases uniformly from 4.2 m at the base to 6 m at…

A:

Q: Water is circulated from a tank of large proportions through a filter and then back to the mentioned…

A: Given, Power added to the water by the pump, Wp' = 200 ft.lb/a KL elbow = 1.5 KL Exit = 1 KL Valve =…

Q: 3.- A swimming pool has a partial filtration system, the water whose temperature is 75 °F, is pumped…

A: The water temperature, T = 75 FThe discharge through the pump, Q1 = 30 GPMThe pressure inside the…

Q: Problem 4: During the daytime, water is drawn from an upper reservoir and is run through a turbine…

A: Step 1:Step 2: Step 3: Step 4:

Q: Water is retained in a small mountain lake whose surface is 280 ft above the inlet to the turbines…

A: Bernoulli's theorem is used in fluid dynamics and gives the relationship between the pressure,…

Q: Problem 3. Water flows at 800 GPM (gal/min) through the 8-in-diameter pipe. As it passes through a…

A: Given data the pressure drop= 0.15 psi water flows at =800 gpm Diameter of pipe= 8 inch

Q: ater must flow over a distance of 2 800 m from a large catchment dam to a turbine. I The water level…

A:

Q: 8. Given the following venturi meter and the two pressures shown, calculate the mass flow rate of…

A: As per given question we have defind Mass of flow rate of in the circular pipe?

Q: A vented 50-gallon cylindrical reservoir (diameter = 18 inches) is used to supply ambient…

A: Given: Here is the given image, To determine: The required height (m) of water in the reservoir…

Q: The centrifugal pump in the figure pumps the water at 25°C from the tank 1.22 m above its inlet…

A:

Q: Following the pump, the pressure in a 6-inch inner smooth pipe conveying water is 20 pounds per…

A: SOLUTION : Given Data: Inside diameter of the pipe (d) = 6 inch = 0.1524 m Pressure (ΔP) = 20 psia =…

Q: 2. Gas (p = 0.0022 lb/ft³) flows through duct shown in fig. At A flow rate is 60 ft³/s under a…

A: Given Data The density of the gas is: ρ=0.0022 lb/ft3 The flow rate of the gas is: 60 ft3/s The…

Q: Determine the maximum allowable volume flow rate in L/min that can be carried through a standard…

A: To find-: The maximum allowable volume flow rate in Lmin. Given-: The outside diameter is D=1.25 in.…

Q: long rges has an open globe valve and four threaded elbows; h₁ = 3 m and h₂ = 15 m. What is the…

A: Given data as per question Diameter of Galvanized steel pipe, d=10 cm=0.1 m Length of pipe , L=1000…

Q: A centrifugal pump was purchased to pump the water from an open tank to a water jet spray cleaner.…

A: Given Datagauge pressure=75kN/m2d=0.64mh=15m

Q: Water must flow over a distance of 2 800 m from a large catchment dam to a turbine. The water level…

A: In parallel combination of pipes, their frictional head losses are the same but the power…

Q: In the following figure, a machine is installed in the water drainage system. Knowing that the…

A:

Q: Following the pump, the pressure in a 6-inch inner smooth pipe conveying water is 20 pounds per…

A:

Q: The velocity of the liquid flowing through the rusty iron pipe having a 150 mm diameter is 2.5 m/s.…

A:

Q: The axial flow pump produces a discharge of 0.095 m³/s. The impeller is rotating at w = 110 rad/s,…

A: Given: Discharge, Q=0.095 m3/s ω=110 rad/s Mean radius, r=75 mm To find: Velocity of water at exit

Q: What power must be supplied by the pump to the fl ow if water (T = 20°C) is pumped through the…

A: Power of pump is 633.56 kW.

Q: For the system shown below, calculate the vertical distance (in meters) between the surfaces of the…

A:

Q: 3. A water from Agno River is pumped at 13.3 L/s using a submerged pump at an efficiency of 78% that…

A: Consider Bernoulli’s equation for steady flow between the points (1) and (2).…

Q: Water flows through the piping junction, entering section 1 at 20 US gallons/min (1 US gal = 3.78…

A: Given data: Q1=20 US gallons/min=12.62×10-4 m3/sv2=2.5 m/sdh=1 mm Need to determine the exit…

Q: Problem 5: Given a Crucible with a base diameter (Din)of 8 mm and the length (L) of the attached…

A: Given : D - 8 mm H- 16 mm L - 10 mm To find: Volume flow rate

Q: Determine the pump work of the oil piping system. The oil has kinematic viscosity of 0.0001 m²/s and…

A: Given:Kinematic viscosity of the oil, ν=0.0001 m2/sSpecific gravity of the oil, SGoil=0.79Pipe…

Q: Water with a constant density 62.4 lb/ft^3 is flowing at a rate of 50gal/min through a horizontal…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.