Answered: What is the value of the force (F) in…

What is the value of the force (F) in the unit of N required to balance the system in the figure? M=13 kg and F makes an angle (e =37°) below horizontal. g = 10m/s2. 3 m 2 m F

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 25AP: A bridge of length 50.0 m and mass 8.00 104 kg is supported on a smooth pier at each end as shown...

See similar textbooks

Related questions

Q: Modelled after problem 5 in the Problems_Torque_Statics: A 16.19-m-high and 11.44-m-long wall under…

Q: An 800-N billboard worker stands on a 4.0-m scaffold weighing 500 N and supported by vertical ropes…

Q: A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 4.72 g coins…

A: As the stick balances without anything extra at the 50 cm mark, we can take it that the weight is…

Q: A 120-kg man balances the boy on a teeter-totter as shown. Note: Ignore the weight of the board. boy…

A: Given that:Mass of the man : M=120 kgWeight of the man : W1=mg =120…

Q: a = 4 m, b = 5 m, c = 3 m, k1= 5000 N/mm and k2= 4000 N/mm. Mass= 400 kg How many cables supporting…

A: In the given diagram there are three fixed joints. The given mass M is connected with these three…

Q: A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 5.66 g coins…

A: Given: mass of coin, m=5.66 gm A meter stick balances horizontally on a knife-edge at the 50.0 cm…

Q: A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 5.37 g coins…

Q: A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 3.59 g coins…

A: mass of each coin = 3.59 g total mass = m = 2x3.59 = 7.18 g

Q: The arm in Figure P8.17 weighs 41.5 N. The force of gravity acting on the arm acts through point A.…

A: Draw the free body diagram of the arm and show the components of the forces Ft and Fs as well.

Q: Ivana Alawi placed a 50.0 g mass at the 20 cm mark in meterstick as shown in the figure. what is the…

A: Correct option is 4. i e 93 grams

Q: A uniform, 100-lb beam is held in a vertical position by a pin at its lower end and a cable at its…

Q: A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 5.52 g coins…

Q: The 3 m long uniform plank is supported by a fulcrum at the midpoint. Where should a 45 kg student…

A: Given: The mass of the student is 45 kg. The length of the plank is 3 m. The free-body diagram is…

Q: The 3.0-m-long, 96 kg rigid beam in the figure is supported at each end. A 72 kg student stands 2.0…

Q: The masses of the blocks are ma= 30kg and mb= 70kg. Between all of the contacting surfaces, ps=…

A: Given information: The masses of the blocks are mA=30 kgmB=70 kg The coefficient of static friction,…

Q: A uniform 4 m, 60 N horizontal plank is shown with a 40 N weight resting on top, 1.0 m from the…

Q: You place a 10 kg brick 0.75 m to the right of a fulcrum. You then place a flower pot 1.5 m to the…

A: according to mechanical advantage . we have brick weightflower pot weight=distance from fulcrum to…

Q: Fw mg AFiy Frx e f.x Axis The ladder in the picture has a mass of 39 kilograms and a length 3…

A: As per guideline we are suppose to do only 3 subpart from multipart question please post the rest of…

Q: A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 5.00 g coins…

A: The expression for the required mass of the meter stick is,

Q: A uniform beam is 5.0 m long and is supported as shown in the figure. At the center of the beam, a…

Q: 300 kN 50 kN 180 kN 90 kN 60°

Q: .Estimate where a pivot should be placed beneath the lowest block so that the system would balance…

Q: 2. A boy weighting 600 N sits 2.5 m from the center of the see-saw. If his friend weighs 750 N, how…

Q: The mass center G of the 1345-kg rear-engine car is located as shown in the figure. Determine the…

A: Given Mass of car, M = 1345 kg Acceleration due to gravity, g = 9.81 m/s2 Also, 1308 mm = 1.308…

Q: The downward forces represent the weights of machinery on the beam shown in (Figure 1). Assume the…

Q: 6 kg 30 kg 12 1 1.25 1.5/ 1.75 0.25 0.5 0.75 0.75 0.5 0.25 Meters 1 1.75 1.5 1.25 Meters Check 15 kg

A: Torque is the rotational analog of linear force. The torque is given by the cross product of the…

Q: The figure shows a 1280 kg car that has slipped over the edge of an embankment. People are trying to…

Q: A 4.0- m-long iron bar of uniform cross section is held perpendicular to the wall by a wire from the…

Q: A 5.0 kg cat and a 2.0 kg bowl of tuna fish are at opposite ends of a 4.0 m long seesaw. How far to…

A: In order to keep the seesaw in balance, the moment about the pivot point must be equal. Let the 4 Kg…

Q: A man and a child sit on a seesaw, as shown in the diagram. The seesaw consists of a plank with…

A: Torque equilibrium: When the system is in the static equilibrium than the total algebraic sum of…

Q: Two children of mass 21 kg and 26 kg sit balanced on a seesaw with the pivot point located at the…

A: Let r be defined as the distance from the pivot point of the small child. Then the distance of the…

Q: Three children are trying to balance on a seesaw, which consists of a fulcrum rock, acting as a…

Q: 2.0 kg 4.0 kg d 2.0 m The wooden beam has a mass of 20 kg. What is the distance d that balances the…

Q: A 10.0 m long rod, with a mass which acts at its center, supports three weights as shown. Where is…

A: Three mass x = 5 Kg, y = 27 Kg, z = 22 kg at distances 0m, 5m, 10m on the rod Find: center of…

Q: A uniform 1200 N beam that is 3.50 m long is suspended horizontally by two vertical wires at its…

Q: A uniform beam of length L = 7.10 m and weight 4.05 × 10² N is carried by two workers, Sam and Joe,…

A: FSam = 148 NFJoe = 253 NExplanation:Approach to solving the question:Please see attached photos for…

Q: You build a shelf by putting a 0.90 m board across two supports. One support is at the left end of…

Q: A horizontal 8 kg plank is 3.0 m in length and has its center of mass at the geometrical center. A 2…

Q: A 3.0-m-long ladder, as shown in (Figure 1), leans against a frictionless wall. The coefficient of…

Q: 32. I| A 5.0 kg cat and a 2.0 kg bowl of tuna fish are at opposite ends of the 4.0-m-long seesaw of…

Q: Three children are trying to balance on a seesaw. The seesaw is 4.1 m long and pivots about a rock…

A: From figure Louie sit on left and Laura sit on right,Since the weight of Louie is 50 kg, and Laura…

Q: A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 3.07 g coins…

Q: 13. Freddy who weights 20kg, sits on one side of the seesaw which is 3.5m away from the center. His…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

What is the value of the force (F) in the unit of N required to balance the system in the figure? M=13 kg and F makes an
angle (e =37°) below horizontal. g = 10m/s2
3 m
2 m
F
A. None
B. 650
C. 325
325
D.
E. 5. V13

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

2. In figure no. 2, if W1=W2= W2 20Newton, 0=30° and Hk = 0.4, find the weight of the third block (W:) in Newton. The system is in equilibrium. W; FIGURE NO.2
1. P = 101.937 N, F = 0, V = 9.8 m/s
A uniform, 100-lb beam is held in a vertical position by a pin at its lower end and a cable at its upper end. Ahorizontal force (magnitude P) acts as shown in the figure. If P = 75 lb, what is the tension in the cable?a. 54 lbb. 69 lbc. 47 lbd. 61 lbe. 75 lb
A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 3.10 g coins stacked over the 15.7 cm mark, the stick is found to balance at the 19.0 cm mark. What is the mass of the meter stick? Number i Units
22. A 2.50 [kg] block is positioned 2.25 [m] from the center of a long uniform beam. At what distance x must a 3.25 [kg] block be positioned in the beam for it to balance if the beam is supported at its center of mass? A. 1.21 [m] -2.25 m -x-> B. 1.73 [m] 2.50 kg C. 2.92 [m] D. 3.56 [m] 3.25 kg
A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 3.89 g coins stacked over the 31.9 cm mark, the stick is found to balance at the 40.9 cm mark. What is the mass of the meter stick? Number i Units g
32. I| A 5.0 kg cat and a 2.0 kg bowl of tuna fish are at opposite ends of the 4.0-m-long seesaw of FIGURE EX12.32. How far to the left of the pivot must a 4.0 kg cat stand to keep the seesaw balanced? 2.0 m 2.0 m FIGURE EX12.32 1/1
17
A uniform plank of length 2.00m and mass 30.0kg is supported by three ropes, as indicated by the blue vectors in figure p8.27. Find the tension in each rope when a 700-N person is d=0.500m from the left end.
A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 5.86 g coins stacked over the 32.1 cm mark, the stick is found to balance at the 42.9 cm mark. What is the mass of the meter stick? Number i Units eTextbook and Media
24. A uniform, horizontal plank, having a weight of 254 N, is held in static equilibrium by a frictionless pin at A and a cord tied at the plank's left end. The length of segment PA is 20.0 cm, and the length of AC is 70.0 cm. What is the tension in the cord? 58.0 mg gravity a. 1050 N b. 444 N c. 524 N d. 318 N e. 374 N 2013 Regional
A uniform beam is 5.0 m long and is supported as shown in the figure. At the center of the beam, a baby mobile is attached. a. If m1 = 12 g and m2 = 10 g find the value of mg in order for this mobile to sit in equilibrium. 45° 2 m 3 т m2 m1 m3