Answered: What is the maximum size Grounding…

Engineering

Electrical Engineering

What is the maximum size Grounding Electrode Conductor regardless of the size of the

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter4: Conductor Sizes And Types, Wiring Methods, Wire Connections, Voltage Drop, And Neutral Conductor Sizing For Services

Section: Chapter Questions

Problem 7R: What is the voltage rating of the conductors in Type NMC cable? _______________

See similar textbooks

Related questions

Q: What is the smallest square box that will accommodate four No. 12 conductors and four No. 10…

A: conductor A conductor is any piece of material that easily allows heat or electricity to pass…

Q: What is the cross-sectional area and diameter of a wire that has a length of 1,500 mm and a…

A: Given data: Length = 1500 nm R = 0.43 ohms Resistivity of silver =1.59 x 10-8 Resistivity of…

Q: What is the common type in electricity in underground cables

A: In this question , we will see common types of underground cables..

Q: : Mention and explain any 4 the differences between conducting and Non-conducting wires

A: Conducting wire allow electric current to flow through it easily. Non conducting wires do not allow…

Q: 21/ Which Insulators can be used for both horizontal and vertical positioning? A. PIN TYPE…

A: Given Which Insulators can be used for both horizontal and vertical positioning?

Q: Four wires of equal length and of resistances 10 ohms each are connected in the form of a square.…

A: Given: Four wires of equal length and resistances R=10 Ω each are connected in form of squares. So…

Q: What is the diameter in inches of a no. 26 AWG wire?

A: 26AWG = 0.0159 inches diameter wire .

Q: list three factors that affect the resistance of conductors

A: The three factors that affect the resistance of conductors are - Length of conductor, l, Area of…

Q: Explain the working of the Potential meter float gauge with a neat diagram

A: Draw the Potential meter float gauge: Based on the displacement of the float, the float gauge…

Q: Which Insulators can be used for both horizontal and vertical positioning? A. SUSPENSION TYPE…

Q: what are the ballast resistors used for?

A: when the current in the circuit increase above the predefined value, the value of the resistnae also…

Q: What units is plate thickness specified

A: Given: 6. In what units is plate thickness specified?

Q: Resistivity of a wire depends on length material O all of the above. O O O

A: Resistivity of the wire calculated as : R=ρlAwhere,ρ = resistivityL = LengthA= area

Q: Name two types of conductor insulation designed to be underground

Q: Name two types of conductor insulation designed to be used underground, and two other types of…

A: Insulator- To prevent unwanted current flow to the ground from its supporting points, an electrical…

Q: Compare Insulators

A: Insulator in transmission line- The device used to protect transmission line and prevent the…

Q: 1. What should be the minimum cross-sectional area of each conductor in a two-core cable 100 m long…

A: Given voltage drop = 4% of 250 V Length = 100 m Current= 60 A Resitivity = 2.845μ ohm metre we…

Q: What is factor of a cable at 5 degrees celcius when calculating resistance

A: The solution is provided in the following section.

Q: A string insulator has 6 units. The voltage across the bottom most until is 20% of the total…

Q: Draw the connection diagram for 3-wire d.c supply

Q: Is there any iron lost in the short circuit test? If there is, why is it omitted

A: Yes, in short circuit test, iron losses or core losses are not absent (or zero) but they are…

Q: A(n) blank is a device,or group of devices, by which the conductors of a circuit can be disconnected…

A: A circuit breaker is a device,or group of devices, by which the conductors of a circuit can be…

Q: What factors explain the ampacity of the wire

A: The ampacity is defined as the property of the conductor which will carry the maximum amount of the…

Q: 38. The radius of bends in mineral-insulated cable with a %" external diameter shall be not less…

Q: A length of square conductor that is 0.25 in. on a side has a resistance of 0.0756 ohm. What will be…

A: Resistance is an electrical property of a material that opposes the flow of electrons or current in…

Q: What ampacity must all branch-circuit conductors used for wiring a ceiling outlet box be de-rated…

A: Dear student as per our guidelines we are supposed to solve only one question .kindly repost other…

Q: What are the type of circuit breaker

A: There are mainly four types of circuit breakers 1. Air blast Circuit Breaker 2. SF6 circuit…

Q: f. If the lower sphere is replaced with a sharp needle, is the breakdown voltage going to be higher…

A: Here it is asking that if the lower sphere is replaced with a sharp needle then what will happen to…

Q: Wire sizing indicates the diameter of the metal conductor of the wire and is based on the American…

A: Wire sizing indicates the diameter of the metal conductor of the wire and is based on the American…

Q: What should be the minimum cross-sectional area of each conductor in a two-core cable 100 m long to…

A: Write the expression for the potential difference.

Q: 3. A conductor whose diameter is 0.175 inch has a resistance of 0.5 ohm. The wire is drawn through a…

A: Resistance is the opposition to the flow of current. Its unit is ohm. Formula to calculate…

Q: How can lighting fixture be ground and what size of the conductor can be used

A: There are so many things that come in our mind which is related to light. It may be an artificial…

Q: What is the nonconductive covering around a wire? Select one: A. DUCT BANK B. INSULATION C.…

A: Insulation is a nonconductive material, or a material resistant to the flow of electric current.…

Q: Each of the 19 strands of copper cable has a diameter of 59 mils. Calculate the resistance of a mile…

A: According to the question we have to find the value of resistance of a mile of such cable at a…

Q: What are the nominal resistance and tolerance of a resistor with color bands in the order of…

Q: How to put this on a breadboard without jumper

A: When the same current flows through all they resistors, they are said to be in series. In series…

Q: 1. What should be the minimum cross-sectional area of each conductor in a two-core cable 100 m long…

A: Referring to the questions, the given data are:

Q: A set of conductors is used to supply a water pump with a rated current of 30 A at a supply voltage…

A: Given data, Length of conductor, L=250 ft Rated current, I=30 A Supply voltage Vs=120 V

Q: A conductor has a size of 500 MCM, what will be its size in square m?

Q: Five pieces of copper wire have the following description, rank the following resistance from lowest…

Q: The resistance of a wire

Q: Diods clippers give me the details of the following topic immediately please

A: Here are some examples of diode clipper

Q: What are the law's applied in series and parallel cicuits?

A: In series circuit, the current flows through all the elements are equal where as voltage across all…

Q: Answer the question Electrical circuit

A: So from the given question we need the voltage expression for capacitor.

Q: 1. With respect to conductor insulation, interpret the following insulation designations: а. Т b. N…

A: a) T - Wire wrapped in thermoplastic insulation for protection below 32oF to 150oF. b) N - made by…

Question

What is the maximum size Grounding Electrode Conductor regardless of the size of the service?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

What is the voltage rating of the conductors in Type NMC cable? _______________
The following problems refer to grounding requirements. 1. What is the minimum size copper grounding electrode conductor for a service with three sets of parallel 350 kcmil conductors (three conductors per phase)?
Three 10 AWG, type THW conductors are to be installed between poles on individual insulators. What will the conductor ampacity be?
Electrical Engineering What is the smallest square box that will accommodate four No. 12 conductors and four No. 10 conductors if a. These conductors are pulled through without a splice? b. These conductors are all spliced in the box?
The three bus-bar conductors in an outdoor sub-station are supplied by units of post insulators. Each unit consists of a stack of 3-pin insulators fixed one on the top of the other. The voltage across the lowest insulator is 8-45 kV and that across the next is 7-25 kV. Find the bus-bar voltage of the station.
A. Discuss the arcing phenomenon in a circuit breaker. B. Discuss the types of oil circuit breakers. With references
What is the minimum trade size PVC conduit to contain 201 #12AWG TW75 Copper conductors.
In stranded conductor of 6 layers what will be the total number of individual wire ? (a) 75 (b) 85 (c) 84 (d) 74
Most residential general lighting circuits are wired with 14-AWG copper conductors and are protected by 15-amp circuit breakers. However, there are many electricians who install 12-AWG copper conductors and protect them with 20-amp circuit breakers. How will you know which conductor size and which circuit breaker size will be used for the general lighting branch circuits in the house you are wiring?
3. The three bus-bar conductors in an outdoor sub-station are supplied by units ofpost insulators. Each unit consists of a stack of 3-pin insulators fixed one on the top of the other. The voltage across the lowest insulator is 8-45 kV and that across the next is 7-25 kV. Find the bus-bar voltage of the station. [38-8 kV]
How does the skin effect phenomenon affect the performance of copper cables?
h.1. In an alternating-current system, the maximum size for a copper grounding electrode conductor isA. 250 kcmil.B. 3/0.C. 500 kcmil.D. 4/0. h.2. The figure shows a fault condition in an ungrounded electrical system. Which of the following will occurbecause of the fault in this system?A. Only the overcurrent protector at Point A will trip open.B. The ground fault will heavily damage the service.C. Nothing will happen until a second ground fault occurs.D. The overcurrent protection will trip, shutting off all the line side power.