What is the importance of time ratio? And explain the performance of four bar chain mechanism and conditions with neat diagram used in pump jacks in oil and field industries

2 Pressure gauge 4 1 FR the hydraulic cycle in figure -consist of:2 5 6 X www. M 3 Feed direction accumulator double acting cylinder double rod double acting cylinder single acting cylinder O

Explain in detail and don't copy from google

Identify the Pump which increase the pressure due to squeezing action and explain its workingprinciple with neat diagram.

Please solve it

A power shift crawler dozer is working in tough clay and pushing it 150 feet. The blade capacity is 10 LCY. Maximum reverse speeds are as follows: first range, 3 mph; second range, 5 mph; and third range, 8 mph. The job efficiency is 55 minutes per hour. Find the expected dozer production per hour

5. Mark the correct statement for Flight computer architecture. a. Neither the ELACS nor the SECS provide the only control to either the pitch or the roll axis. b. Both ELACS and SECS provide the control to pitch and Yaw Axis. c. Both ELAC and SECS Have full control or Pitch and Roll Аxis. 6. To increase the redundancy and safety the power supplies to individual control surfaces (Actuators/Motors) are signaled by a. Different lanes but same hydraulic system. b. Same lane and Different hydraulic system. c. Different lane and Different hydraulic system. 7. Communication between the FBW system computers is done via a. ARINC 429 data bus. b. Normal twisted wire cables. c. No communication happens. 8. The ELACS control the aircraft in pitch and they do so by sending commands to the left and right elevators and also by sending longer term trim commands to the "Trimmable Horizontal Stabilizer". Which law is this a. Direct Law b. Normal Law c. ELACS never control Horizontal Stabilizers, No Law…

Batch-5 1973: Ford Pinto : Fuel System design  write about fuel lines and fuel filter in detales.

What are the Terms Used in Cams? Explain that with suitable sketch.

Take your time for solving problem. Please solve the Below problem using 'Design data book'. And while solving problem add some table or figure reference number before taking each reference value. If answer is right then I will give you upvote/like.