What is Fusion and Fission in Nuclear Physics? And what are its fundamentals?

Sketch typical thermistor V-I characteristics with and without a heat sink. Explain why there is a difference.

Relationship of the two - direct relationship, inverse relationship, no effect Atomic Packing Factor – Slip Process Elastic Modulus – Bond Strength Temperature (Superconductor) – Diamagnetism Vacancies of Si – Charge carriers Stress Amplitude – Fatigue Life

Cyclic Voltammetry and Charge-discharge The given figure is the Galvanostatic Charge-discharge curves of a supercapacitor made with MnO2 coated on a CNT electrode.  Potential is measured with respect to time by applying different current densities. Based on the plot, answer the following questions   4. Is it possible to estimate maximum power of the device with this charge-discharge curve? If possible, explain how you would do it. (calculation is not necessary)

Question No. 24 A three phase diode bridge rectifier is feeding a constant DC current of 100 A to a highly inductive load. If three-phase, 415 V, 50 Hz AC source is supplying to this bridge rectifier then the rms value of the current in each diode, in ampere, is

Choose the correct answer and show your solution. *Kindly provide a COMPLETE and CLEAR solution* (Answer should be typewritten) *Please answer it ASAP if you can

please answer with written solution. thank you

Diode circuit...do it...

DA shunt generator is used to charge a battery of 100 cells in series. If each cell has a terminal p.d. of 2.5V at the completion of charge and is of internal resistance 0.001 Q calcu- Cate the e.m.f. to be generated to give a charging current of 15A at the end of charge. Assume that the armature and field resistances are 0.2 2 and 200 2 respectively and the cables onnecting the generator to the battery have a resistance of 0.6 Q.

Why are these versions of diode circuits called clamping circuits? What is the meaning of clamp?