What inductance will give the same reactance as a capacitor of 2 µF when both are at 50 Hz? 5 H 10 H 15 H 20 H
Q: 5. Complete the timing diagram of the given Latch 3 S R S E R Q 오ㅏ
A: Given latch,
Q: The resistance between any two terminals of balanced star connected load is 12 ohms. Find the…
A:
Q: Find the capacitor voltage at t= 0.5 ms that is associated with the current shown graphically in the…
A: Given: Current through capacitor with respect to time, Capacitance, C=0.71 μF
Q: Q2. Consider an ideal low pass filter (LPF) with h[n] con со sin(@con), where cutoff frequency @co=…
A: Given,For a idel low pass filter,h[n] =sinωconπnWhere,ωco=0.5πandx[n]=cos0.25πn
Q: For over modulation, the value of modulation index m is
A: The correct option along with the explanation is provided in the following section.
Q: The spectrum of the sampled signal may be obtained without overlapping only if a. fs > 2fm b. fs fm…
A:
Q: A TDMA network of five earth stations shares a single transponder equally. The frame duration is 2.0…
A: Given, Frame length = 2ms =2000μs Preamble Time = 20μs Guard Time =…
Q: 1. Design a buck converter (L = ? C = ?) with the following parameters: Vin = 34 V, Vo = 12 V, f =…
A:
Q: R₁ 22 ΚΩ VIN- R₂ www 220 ΚΩ -VOUT Figure 15.4: A non-inverting amplifier circuit. Consider the op…
A: Given data, Gain bandwidth = 220 kHz Circuit diagram is given as,
Q: 2. Consider the following pulse, T (0) A a Write down the analytical form for this pulse Sketch a…
A: According to the question, for the given pulse x(t) as shown below (a) We need to find the…
Q: VBB 5 V RB Μ 12 ΚΩ Rc • 120 Ω H11 lg Vcc 12 V
A: We need to select correct option for region of operation
Q: An electron (charge -1.6 × 10-¹9 C) is moving at 3 ×105 m/s in the positive x direction. A magnetic…
A:
Q: small induction motor with power factor of 0.8. The effective currents flowing through the bank of…
A:
Q: RLC Series. In an AC series circuit containing resistance R, inductance L and capacitance C, the…
A: For a given series RLC circuit Z=R+j(XL-Xc) Detailed solution is shown as follows:
Q: Write a MATLAB script to solve the given problems below. 1. The voltage across a 5 µF capacitor is…
A: The required parameters can be calculated by using the general expression of capacitor and the same…
Q: 3. For the AC network shown in Figure 3, the source voltage is 120V (RMS). 4Q2 j6Q ww a) 120/10° V…
A: Given:
Q: A 132 KV line with 2 cm diameter conductors is built so that corona takes place if the line voltage…
A:
Q: find the value of Z₁ in order that Z₁ absorbe the maximum average power -j10 Ω 40 Ω Τε Select one:…
A: Given, ZL=? for maximum power transfer.
Q: No. R1 R2 R3 R4 No. F1 F2 F3 F4 Semiconductor Diode - Reverse-Bias Condition (VD 0 V) 9.04 mA 23.6…
A: We know that Diode: It is a two terminal device which conducts only in one direction and doesn't…
Q: PRACTICE PROBLEM 11.5 -j4 9 892 Figure 11.10 j10 92 m 2 A 592 For Practice Prob. 11.5. ZL For the…
A:
Q: Design a non-inverting amplifier that has a gain of 12. Assume value for Rf then find Ri.
A: The required resistor value for the non inverting amplifier can be obtained by using the expression…
Q: A3-phase, 220 KV, 50 Hz transmission line consists of 1.2 cm radius conductors spaced 2m at The…
A:
Q: 3. The sequence component of phase a currents are: Iao = 0 A; Ia1 = 10 + j5 A; Ia2 = 8 -j5 A.…
A:
Q: The current through a resistor is 1.5A but measurement yields a value of 1.46A. Compute the: a)…
A: Given: Actual current through resistor, Ia=1.5 A Measured current through resistor, Im=1.46 A
Q: Solve the maximum effective aperture of a microwave antenna whose operating frequency is 1GHz and…
A: The maximum effective aperture of a microwave antenna is, Aea=λ2D04πD0=900λ=cfc=3×108 msf=…
Q: 2000 25: 1:50 II Ideal Ideal 35 ΚΩ I want to find the average power delivered to the 5 k ohm…
A: The circuit diagram is shown below, Where,Vin =250∠0° Vrms
Q: 100V Y₁ = 0.2-j0.1 S Y₂ Y3 = 0.2-j0.1 S Y₁ = 0.1 S Y = 0.25 + j0.25 S Y1 0.125-j0.25 S Y2 Y3 Y4 Y5
A:
Q: the total resistance of the figure below is R₂ ਸਿੰਘ ਸਿੰਘ ਸਿੰਘ ਸਿੰਘ ਸਿੰਘ Re R₂ R₂ 6kn ॥ 1 kn 700 12…
A: Given data, Figure is
Q: The total current through the supply?
A: Given circuit,
Q: A generator operating at 50 Hz delivers 1 pu power to an infinite busbar through a network with…
A: Given that Pmax1 = 2.0p.u, Pmax2 = 0.4p.u, Pmax3 = 1.5p.u, Pm = 1.0p.u…
Q: If the capacitor in an RC ci find the CORRECT stateme Select one: a. The time constant b. The time…
A: Time constant of RC circuit is given by, τ=RC........eqn 1 Now, capacitor is replaced by two…
Q: If 50 J of energy are available for every 10 C of charge, what is the voltage? 10 V 6 V 4 V 5 V
A: Given: Energy, E=50 J Charge, Q=10 C
Q: Standard intermediate frequency used for AM receiver is
A: The correct option along with the explanation is provided in the following section.
Q: A) A B C + A B C
A: a) Given, Y=ABC¯¯+A¯ B¯C¯
Q: The total power absorbed by a certain 3-phase load is 60 kW, the reactive power being 100 kVAR. Find…
A: Given,For a 3-phase load,Absorbed power, Pab=60kWandReactive power, Pre=100 kVAR
Q: Determine VGS, ID, and VDS for the amplifier in the figure where ID(on) = 18 mA at VGS = 10V,…
A:
Q: B(jo) Determine gain margin and phase margin of the system shown above if the loop gain magnitude…
A: Given: 0
Q: Find the equivalent resistance of the circuit in the Figure P18.9 3.00 Ω 10.0 Ω www 5,00 £2 www 4.00…
A: Given data, Circuit diagram is given as,
Q: Sketch and label the even and odd components of the signals shown below. 4 x (1) 0123 4 5 (a) 4 x{n}…
A:
Q: The minimum spectrum allocation required for W-CDMA is
A: The correct solution is provided in the following section.
Q: Q1. A core with three legs is shown in Figure. Its depth is 5 cm, and there are 100 turns on the…
A: Given:
Q: Find the sum of all numerical coefficient of the expansion (a+b)6 a. 86 c. 82 b. 76 d. 64
A:
Q: The open-loop gain of a system is 0.6 when the phase angle is -180⁰. What is the gain margin of the…
A:
Q: Find the equivalent resistance. Please show work, thanks! 2Ω 6N 4.3 Ω 6Ω
A: Given data, Circuit diagram is given as,
Q: 4. The switch has been open for a long time and is closed at t = 0. The circuit parameters are…
A:
Q: Q31. If the no load voltage of a certain generator is 210 and the rated voltage is 200 V, then the…
A: Given data, No load voltage Vnl=210 V Rated voltage Vfl=200 V
Q: 1. A four-pole, lap wound DC machine is having 500 conductors on its armature and running at 1000…
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: A 230/230V, 3 KVA transtormer gave the following results: O.C Test 230 V, 2amp, 100 W 04 S.c.…
A: Given: Transformer of rating 230 V/ 230 V, 3KVA Open circuit test : 230 V, 2 A, 100 W Short circuit…
Q: Q31. If the no load voltage of a certain generator is 210 V and the rated voltage is 200 V, then the…
A:
Q: If the Zener diode in the figure has a knee voltage of 0.7 V and a Zener voltage of 3 V, find the…
A:
Step by step
Solved in 2 steps with 2 images
- What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?What is the minimum AC voltage rating of each capacitor in Question 11?
- A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450a)For the inductive element of Figure 1 , the current in phasor form is B) the voltage in phasor form for figure 1 is C)the impedance of the inductor for figure 1 is
- Convert -20 sin (wt + 10°) to cosine. Convert 20 sin (wt + 10°) to cosine.• The relationship between voltage and current in pure inductive circuit is, The current lags the voltage by 180 degrees The voltage lags the current by 90 degrees The current lags the voltage by 90 degrees The current and the voltage travel the same angleHow much inductance would an inductor have to posses in order to provide 5409hms of reactance at a frequency of 400hz