Write a MATLAB script to solve the given problems below. 1. The voltage across a 5 µF capacitor is given by v(t) = 50 sin(1000t). Using MATLAB, find expressions for the current, power, and stored energy. Sketch the waveforms to scale versus time.

Write a MATLAB script to solve the given problems below. 1. The voltage across a 5 µF capacitor is given by v(t) = 50 sin(1000t). Using MATLAB, find expressions for the current, power, and stored energy. Sketch the waveforms to scale versus time.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1RQ: An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in...

See similar textbooks

Related questions

Q: An RC High-pass filter consists of 5 nF capacitor and a 50 K 2 resistor. The output voltage is taken…

A: Given: An RC high-pass filter consists of Capacitor, C=5 nF Resistor, R=50 kΩ

Q: In a house there is a three-wire system configured as follows: A refrigerator with an impedance of…

Q: 7.2Ω THE 6V 8 Ω R₂ 12 Ω R3

Q: The following are alphanumeric codes except: (A) EBCDIC (B) Hollerith C Gray code (D) ASCII

A: EBCDIC It is extended binary coded decimal interchange code which will be used for alphabet code…

Q: Use K-map to obtain the minimized sum of products form of the function f (x,y,z,w) = SEGMA…

A: Since given function is of 4 variable We need arrange kmap with 16 entries By identifying all…

Q: Find the Norton Equivalent Circuit at terminal a-b.

Q: In a baseband communications link, frequencies upto 3500 Hz are used for signalling. Using a raised…

A: Given a base-band communication link, Frequency used for signalling, W = 3500 Hz The excess…

Q: Find the line current, shaft speed, load torque, induced torque and rotor frequency of an induction…

A: The given information about an induction motor is Number of poles P=6. Rated shaft output power…

Q: Problem 9-AC phase shifts: The voltage and current waveforms shown below were measured across either…

A: The given waveform is shown below:

Q: When a pentavalent impurity is added to a pure semiconductor, it becomes 1. An insulator 2. An…

Q: 9. Which of the following is correct about the power consumed by R₁ and R₂ connected in series if…

A: Given that R1 and R2 are connected in series. Also given that R1 > R2 Relationship between power…

Q: An analog video signal has maximum frequency of 6 MHz. We want to send this analog video signal in…

A: Given an analog video signal has, Maximum frequency, fm=6 MHz Required data rate, Rb=216 Mbps

Q: Explain about line communication and radio communication

A: In line communication, the receiver and sender are connected via a physical link which is a…

Q: A stepper motor has a resolution of 500 steps/rev. If the motor control circuit pulse rate is 10000…

A: Given information about a stepper motor is Resolution, R=500 steps/revolution. Control circuit pulse…

Q: The cutoff frequency, in Hz, for a low pass filter with R = 105 kiloOhms, and C = 20 nanofarads is…

Q: The above op-amp acts in a non ideal manner such that R₂ R₁ Av(CL) = 1 1+ Av(OL) 1+R²₁. Given Av(OL)…

A: Given: AVCL=-R2R11+1AVOL1+R2R1

Q: If we want to obtain the QUIESCENT VALUE OF BASE EMITTER VOLTAGE, which analysis type/technique in…

A: With the help of Multisim, we can easily simulate the input and relevant output response of a…

Q: Determine the total input resistance of the emitter-follower. Also find the voltage gain, current…

A: The given circuit diagram is shown below:

Q: A balanced load consists of three coils with each coil having a resistance of 10 Ω and an induction…

Q: What is the current through the zener diode? V₁ 13 V Select one: a. 0 mA b. 7 mA c. 13 mA d. 8.3 mA…

A: Given circuit:

Q: Q3/ Consider a satellite receiver as shown in the figure below, if the operating frequency is 4GHz…

A: The given figure is shown below: It is given that: Fin=0.69 dBFrf=1 dBFin=4.48 dBFif=7.9 dBTo=290 K

Q: 16.A DC compound short-shunt motor draws a current of 50 A at a voltage of 220 V. if the armature…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: Question 1 1 0 1 1 0 1 0 1 ... Đ 1 1 D CLK PS FF CLR Q Figure 1 Sketch the timing diagram based on…

Q: PRACTICE PROBLEM 11.15 Find the value of parallel capacitance needed to correct a load of 140 kVAR…

A: In this question we will find capacitance required to improve power factor....

Q: What is universal charge? How does missionary electrification conducted and where does its budget…

A: Electricity is an basic form of energy. The electricity is produced by conversion of the primary…

Q: The intrinsic impedance of the medium whose, σ = 0, ε, = 4, μ, =1 40 ΠΩ 9Ω 120 ΠΩ 60 ΠΩ

Q: In the circuit of figure Nº A, the secondary voltage Vs is 15 volts rms with a frequency of 60 Hz, R…

A: Given data: Frequency f=60 Hz Resistance R=100 Ω Capacitance C=1000 microfarads Secondary RMS…

Q: A lamp having a specification of 220 V/100 W is connected in series with resistance 516Ω, then…

A: Taking unit of Voltage mounted as Volts,since W(Watt) is unit of Power.

Q: What distinguishes a mobile app from others?

A: For example, iOS for the Apple iPhone or Android are the platforms for which mobile apps are…

Q: In The capacitance per unit length of a coaxial cable was calculated as Now assume that the region…

A: Using analogy between D and J , we can obtain equations in terms of D by relating D with J and ∈…

Q: In the figure below, q1 = +2.00 nC and q2 = -8.00 nC. At what postion can an electron be placed and…

A: To find the position of electron such that electron experiences zero net force from q1 and q2 .

Q: Determine all DC and AC values and the quiescent power dissipation for the CE amplifier shown. Use…

A: Given, Resistance R1=22KΩ,R2=4.7KΩ , RC=2.2KΩ,RE=1KΩ Capacitor=C1=C2=1μF VCC=15V re=25mVIE Here, we…

Q: File Edit Draw Scopes Options Circuits +5V. 100 10μF 1k 1k 10μF 100 t=460.22 ms time step = 5 us 3…

Q: Pumped storage hydro is one of the most effective energy storage option available to the electricity…

Q: What is the typical value of refractive index for an ethyl alcoh 1 1.36 2.6 3.4

A: The correct option along with the explanation is provided in the following section.

Q: A led is required to turn on when a switch is closed. The necessary illumination is obtained when…

A: The circuit is as shown below, Given, LED forward drop, Vd=1.2V, LED current, ID=20mA, Current…

Q: What is the function of MCB? Write two advantages and disadvantages of MCB?

Q: A capacitor permits a continuous flow of current in an AC circuit because: the dielectric material…

Q: 5. From the figure, calculate the average voltage. V 10 -10 5 сл 10 ω!

Q: 1. Positive clipper with positive bias 2. Positive clipper with negative bias 3. Positive clamper…

A: A brief about Clipper and Clamper:- Clipper:-A clipper circuit clips or removes a portion of an AC…

Q: 3. A three phase motor canbe regarded as Balanced "Delta" load. A three motor draws 6 KW when the…

A: Given data: The motor draws power = 6 Kw The line voltage VL=225 V The line current IL=20 A

Q: Write the mesh-current equations only (don't solve) for the circuit shown below: 40 2) 4.5 A 2.2 V…

A: Given:

Q: Fig. 1 shows a resistive circuit with one DC voltage source and one DC current source. Apply…

A: Given: To determine the current I1 using superposition.

Q: Find Fourier transform of rectangular pulse as shown in Fig. 3.22.. x(1) -T A FIG. 3.22 T

Q: An RLC series circuit consists of a 50-Ω resistor, a 200-μF capacitor, and a 120-mH inductor whose…

A: The impedance of the given RLC series circuit is, Z=Req+jωL+1jωCReq=50+20…

Q: 1. An ammeter has an internal resistance of 9Ω with a maximum measuring limit of 5 mA. Then the…

Q: Theoretically, calculate all the currents and the voltages for the circuit shown in Figure 11

A: In this question, We need to determine the current and voltage across the elements. We are solving…

Q: No energy is stored in the circuit at the time that the switch is closed. a. Find Vo(s). b. Use the…

Q: Convolve the x(n) with h(n) * x(n) * and h(n) are given by, x(n) = (1, 2, 3) h(n) = (1, 2, 1)

Q: 3) Draw the schematics of a HVDC and of a HVDC light, compare the systems evidencing advantages and…

A: HVDC means high voltage direct current is a method of electrical power transmission which uses…

Question

Please solve number 1.

Write a MATLAB script to solve the given problems below.
1. The voltage across a 5 µF capacitor is given by v(t) = 50 sin(1000t). Using
MATLAB, find expressions for the current, power, and stored energy. Sketch the
waveforms to scale versus time.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
The current through a 50 mH inductor is given below. Use Ohm’s Law to find the voltage. Convert to polar form, find the impedance and complete the math, then convert back to the waveform at i1 = 7.5sin(2500t – 20°) mA and i2 = 5.9sin(200t + 40°) mA
What impedance vector (0- j15) Ohms represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a capacitance.
An AC voltage source is connected to a circuit. The current in the circuit leads the voltage by 90°. The circuit comprises of a: Select one: A. Pure inductor B. Inductor with resistor C. Pure capacitor D. Capacitor with resistor
a) The voltage across a 20uF capacitance is v. = 50 sin( at - 80) volts and Frequency equal to 100 Hz. Determine the current through the capacitor i and sketch its waveform. b) Define phasor
how do i calculate the inverse capacitance and its uncertainty if the capacitance value 1.8748+/- 0.0006. please show steps im using this example to do my other values.
. An inductance of 15mH has a current drawing I = 15sin(650t - 300) A. Determine the equation of voltage in the circuit
a. Show how you would connect all five capacitors to get a maximum capacitance and find the maximum capacitance in terms of C. b. Show how you would connect all five capacitors to get a minimum capacitance and find the minimum capacitance in terms of C.
QUESTION 5 E-05, PC-01. Capacitor can store energy in form of? Current. Electrical charge. Power. QUESTION 6 E-06, PC-03. An Inductor's time constant is given by? LR. O L/R. L2 /R.
The time taken by the series RL circuit having an inductance of 0.6 H and resistance of 30 Ohms to reach a steady-state value.
Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 11.80 Volts and is running at a frequency of f = 147000 Hz. The resistor has a resistance of R = 3910 Ω, the capacitor has a capacitance of C = 4.01e-10 Farads, and the inductor has an inductance of L = 5.97e-03 Henries.Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit ?Ztot = Determine the numerical value of Ztot = ΩDetermine the numerical value of ?Ztot = degreesDetermine the current through the circuit: I(PEAK) = Amps I(RMS) = Amps Determine the voltage across the inductor: VL(PEAK) = Volts VL(RMS) = Volts Determine the voltage across the capacitor: VC(PEAK) = Volts VC(RMS) = Volts If a second circuit were connected in parallel with the resistor, this circuit would be considered as: a high-pass filtera flux capacitor a radio tunera phase…
.A series RLC circuit contains a 4-kN resistor, an inductor with an inductive reactance (X,) of 3.5 kn, and a capacitor with a capacitive reactance (Xc) of 2.4 kN. A 120-Vac, 60-Hz power source is connected to the circuit. How much voltage is dropped across the inductor?