What analogRead() value is equivalent to the voltage output of analogWrite(pin, 255)?

Q: Select a suitable example for for combinational logic circuit. O a. None of the given choices O b.…

A: The given questions are from the digital electronics subject.  A circuit which remains unaffected by…

Q: 6. The logic circuit: (From minimum SOP (Y2)) Number of gates used in the circuit: 2-Input AND…

A: We need to draw the logic circuit for minimum SOP form of Y2 expression & need to fill the…

Q: ROM

A: ROM Computer-Read only memory, is a memory in which we can read but not write on it, it is a…

Q: LDS DX, [BX] – this instruction copies - successive words from memory pointed by BX register. a. Two…

A: The instruction given is LDS. The syntax is LDS destination, source. Given LDS DX, [BX]

Q: Microprocessors and microcontrollers are two independent types of electrical equipment. What…

A:

Q: What is the meaning of a digital image?

A: Image: It is a visual representation of anything that is present in the world or in the imagination…

Q: Q#03) Explain ISA (Instruction Set Architecture), Types of ISA (Instruction Set Architecture),…

A: 3) An (ISA) characterizes the arrangement of fundamental activities a PC should uphold. This…

Q: QUESTION 25 Each of the following will improve a memory chip except more memory locations longer…

A: The solution is given below

Q: advantages of digital system over the analog system

A: In 1870, the first analog system was developed than developed and modified up to 2000. But the world…

Q: 1. Study thiS program, then answer the questions that follow: MOV AL, 64H ADD AL,27H DAA a) What…

A: Since it has sveral sub-parts, we will answer the first one. Given that MOV AL, 64HADD AL,…

Q: Assume that memory location $c100 holds a data byte =$37, [ACCA]= $B8 and [ACCB]=$FE. For each of…

A: Given data: $37 data at memory location $C100ACCA=$B8ACCB=$FE

Q: A XY plotter pen control mechanism

A: One type of motion generation case is the XY plotter pen control mechanism. In this case, the…

Q: Microprocessors and microcontrollers are two independent types of electrical equipment. What…

A:

Q: What is the device address used by the instruction OUT A4, AL

A: OUT is a mnemonic that stands for OUTput Accumulator contents to an output port whose 8-bit address…

Q: What will be the BCD equivalent of decimal number 25?

A: The solution is provided in the following section:

Q: What Is programmable logic arrays?

A: Given: Programmable logic arrays: Programmable logic arrays are used in digital circuits. It is a…

Q: I. Definition. Define the following terms. 1. Logic Design – 2. Logic Diagram – 3. Truth Table – 4.…

A: Definition :  1) Logic design : logic design is the process of designing combinational logic gate…

Q: Assume that memory location $c100 holds a data byte =$37, [ACCA]= $B8 and [ACCB]=$FE. For each of…

A: Note: As per our policy, I have attempted the first three subquestions. Given data: $37 data byte at…

Q: Microprocessors and microcontrollers are two independent types of electrical equipment. What…

A:

Q: 1. Design a combination circuit and write a logic circuit when there are 3 switches and 1 lamp, the…

A:

Q: a)  State the mode of operation of flip flop forthe given timing diagram in figure 1

A:

Q: An 8051 subroutine is shown below: SUB: RO, #20H LOOP: MOv @RO,#0 MOV INC RO CJNE RO, #80H, LOOP RET…

A: The 8051 is a microcontroller designed by intel in 1980 with 4 KB ROM and 128 KB RAM. These types of…

Q: show the classification of semiconductor memories.

A: Please refer the attached images for the complete answer..

Q: If R0 = 0x20008000, after run STMDB r0!, {r3, r9, r7, r1, r2} command what is the r7 register memory…

A: According to the question, we need to find the memory start address for the resister r7.

Q: What are the two primary categories of output circuits that are used in TTL?

A: TTL The Transistor-Transistor Logic is a logic family made up of bipolar junction transistors.…

Q: e. Due to fabrication errors, lines d and fwere shorted to the supply voltage. What happens to the…

A: If the lines d and f were shorted to the supply voltage due to the fabrication errors. If the supply…

Q: Assuming that DI=10016, DS= 140016, SI=FF0016, BX= AE0016, AX=100616 and the memory contents…

A: 1. Consider the given program, MOV SI, [BX+33H] This instruction used based indirect addressing…

Q: What function do you use to output an analog voltage from a digital pin?

A: The Digital pin in particular gives digital output. i.e. either logic high or logic low.  So we…

Q: Implement the logic circuit in Figure 2 using only NAND gate A B C X

A: The given question is solved in step by step process.Explanation:

Q: Use IC 74151 as shown in Figure 1 to create a logic circuit to operate as an equation.

A:

Q: Identify the IC that performs logic “NOT” operation. IC 7408 IC 7402 IC 7404 IC 7432

A: Need to find correct IC for NOT operation

Q: 2) Convert Hexa-decimal to Octal a. 7E6A(16)=?(8) b. C350(16)=?(8) c. 9E36.7A(16)=?(8)

A: According to guideline we need to solve only first 3 sub part according to question convert hexa to…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.