We can make an energy dense capacitor by stacking layers of conductors separated with a dielectric, as shown below. Then, every other layer is connected together and held at the same voltage. V₁ V2 Suppose that all layers are identical and a single pair of plates has a capacitance of 21 F. What is the equivalent capacitance of this setup? Enter your answer in units of [Farads (F) ), rounded to the nearest one.

We can make an energy dense capacitor by stacking layers of conductors separated with a dielectric, as shown below. Then, every other layer is connected together and held at the same voltage. V₁ V2 Suppose that all layers are identical and a single pair of plates has a capacitance of 21 F. What is the equivalent capacitance of this setup? Enter your answer in units of [Farads (F) ), rounded to the nearest one.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.71P: 1.71 The thermal conductivity of silver at 212°F is 238 Btu/h ft °F. What is the conductivity in SI...

See similar textbooks

Similar questions

Q2/ semiconductor at T, has conductivity of 2.5 x 106 s/m. number of electrons of 3x 103 Numbers of holes 3x 103 ,charge of 1.602 x 10 -19 c, and at T2 has conductivity of 3.6 x 10 s/m , number of electrons of 4.5x 1014 , Numbers of holes 2x 102 ,charge of 1.602 x 10-19 c. Calculate the mobility of electrons and holes
You are given a number of 32 Q resistors, each capable of dissipating only 1.8 W without being destroyed. What is the minimum number of such resistors that you need to combine in series or in parallel to make a 32 Q resistance that is capable of dissipating at least 14.0 W? Number i Units
11. Athermally insulated battery is being discharged at atmospheric pressure and constant volume. During a 1 hour test it is found that a current of 50 A and 2 V flows while the temperature increases from 20°C to 32.5°C. Find the change in internal energy of the cell during the period of operation. [Ans.-36 x 104 J]
A wire of radius 1 mm and conductivity 5x [10] ^7 S/m if an electric field of 5 mV/m is applied. Determine the current in the wire * 0.943 0.628 0.785 O 0.393
In an electrical discharge machining process, the breakdown voltage across inter electrode gap (IEG) is 200 V and the capacitance of the RC circuit is 50 μF. The energy (in J) released per spark across the IEG is T
A 4.0-nm-diameter protein is in a 0.050 M KCl solution at 25° C. The protein has 9 positive and 20 negative charges. Model the protein as a sphere with a uniform surface charge density. Part A What is the electric potential of the protein at the surface? Express your answer with the appropriate units. μA ? Vsurface = Value Units Submit Request Answer Part B What is the electric potential of the protein 2.0 nm from the surface? Express your answer with the appropriate units. με V2 nm = Value Units Submit Request Answer
In a transistor, IC = 100 mA and IE = 100.5 mA. The value of B is * 100 50 about 1 200
3. Design a Voltaic cell in which the addition of solid NaCl to the cathode cell will cause the voltage to decrease. Label the diagram below and explain why the addition of NaCl(s) reduces the voltage. KNO anode metal _cathode metal anode solution cathode solution overall balanced equation: 4. Write the balanced overall equation for a combination of metals and standard solutions whose anode [ion] increases at half the rate that the cathode [ion] decreases as the cell runs. Use the circles below to draw a particulate view of what is occurring at the surface of each electrode. Overall equation: cathode anode solution solution cathode anode metal metal Page
4. A pocket dosimeter (Air wall chamber) of volume 9.02 cm³is filled with air at atmospheric pressure. The capacitance of dosimeter is 12pF. If 250V are required to fully charge the chamber, how much voltage is droped when the chamber reads 50 uC/kg, and what is the voltage across the chamber at that reading?[ pair 1.29 x 10-6 kg/cm2]
3- The voltage 2,000,000 V can be expressed in powers of 10 as: (a) 2 mV (b) 2 kV (c) 2 MV (d) 2 GV
1.71 The thermal conductivity of silver at 212°F is 238 Btu/h ft °F. What is the conductivity in SI units?
RC-2 A half ring of charge lies in the x-z plane with its center at the origin as shown to the right. There are λ coulombs per meter of charge evenly distributed along the ring, which has radius 'a'. a) Sketch on your paper figures like the figures shown to the right. On your figures show an arrow representing the electric field at the point P that is produced by source charge element dq. b) Use Coulomb's law to calculate the magnitude of the x, y and z components of the total electric field at P due to the half ring of charge. If any component is equal to zero, you may use the symmetry argument to explain why it is zero instead of doing the calculations. 3D view: ZI (C/m) X dq b View looking from point P toward the origin: Z dq 0