Water is used as the working fluid in an ideal Rankine cycle. Saturated liquid enters the pump with a specific volume of 1.2720 X 10³m³/Kg and exits (the pump) at 1.7530 X 10³ m³/Kg and a temperature of 380°C.The internal energy at the exit of the turbine is 2,500KJ/Kg. Determine:

Water is used as the working fluid in an ideal Rankine cycle. Saturated liquid enters the pump with a specific volume of 1.2720 X 10³m³/Kg and exits (the pump) at 1.7530 X 10³ m³/Kg and a temperature of 380°C.The internal energy at the exit of the turbine is 2,500KJ/Kg. Determine:

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 1. Consider the following schematic of a power plant (operating in what is called a 'Rankine Cycle')…

A: Given data: Mass flow rate (m) =25 kg/s Write thermal property value at the corresponding points…

Q: What is the difference in the saturated vapor pressure for refrigerant R-134aat the two given…

A: given: What is the difference in the saturated vapor pressure for refrigerant R-134aat the two given…

Q: Determine the temperature rise of 20.615 degrees F in the water-cooled condenser in degrees C

A: Given Data : Temperature rise in the water cooled condenser(∆TC) =20.6150

Q: In a surface condenser, O cooling water and steam passes over the tubes. O steam and cooling water…

A: The correct answer to the above question is steam and cooling water never mix to give condensate.…

Q: 1. The condenser in the refrigeration system is used for -of the superheated gas. (a) Absorbing the…

A: Heat Pumps: The devices that transfer heat from cold bodies to hot bodies are called heat pumps.…

Q: Give the relationship between the vapour pressure and boiling point of a liquid and use these…

A: Boiling point is the temperature at which the vapour pressure is equal to the local pressure.

Q: 10kg/sec of steam enters a condenser with enthalpy of 2300kJ/kg and velocity of 350m/s , the…

Q: The food storage room requires a cooling system with a capacity of 10 tons of refrigeration that…

A: The P-h diagram is as:

Q: 1. Refrigerant 134-a enters an adiabatic compressor as saturated vapor at 0 °C and is compressed to…

A: Given data: R-134a refrigerant enters an adiabatic compressor as: Saturated vapor at T1=0 °C and is…

Q: The food storage room requires a cooling system with a capacity of 10 tons of refrigeration that…

Q: 2. An exchanger is used to sub-cool a condensate from a methanol condenser from 95°C to 40°C. Flow…

Q: 5) A saturated liquid refrigerant R22 at the condenser pressure corresponding to a saturation of…

A: Given: Evaporator temperature, Te=-20o CCondensor temperature, Tc=35o C

Q: The values for the evaporator and condenser side of the air conditionercompressor system are given.…

A: Since 1-2 is a compression process i.e., reversible adiabatic process and according to question:- At…

Q: Determine the type of steam, given: Pressure: 60kPa Interal Energy: 360 kl/kg O Saturated Liquid…

A: Given: Pressure P=60kPa Specific internal energy u=360kJ/kg

Q: Determine the refrigerant name and chemical formula of R-22 2.) An ice plant produces 20 tons of ice…

Q: 1 atm steam (sat.) preheats CO2. If 2.26 MJ heat is released from 1kg of condensing steam, How much…

A: GivenQ=2.26MJ/kg m=21kg/sT1=303.15KT2=353.15KCp=4.5RR=8.314 J/mol.K

Q: derive the general formula for the intercooling related to the number of stage of compressor

A: Intercooling, which is used in most multi-stage compressors, increases the moisture in the air.…

Q: the highest pressure of water in the power plant cycle is located a. after the boiler b. at the…

A: Given: The highest pressure of water in the power plant is at the.......

Q: Calculate the logarithmic mean temperature difference for a condenser if the temperature difference…

A: temperature difference between condensing steam and water inlet, ∆T1= 650∘C temperature difference…

Q: An engine operating on the air standard heat engine has 13 KJ heat added at isochoric process, heat…

A: given; heat addition (Q)=13KJheat ratio(k)=1.35minimum…

Q: 21: Steam at a pressure of 28kpa is passed into a condenser and it leaes as condensate at…

Q: A. What is the effects of different input parameters on evaporator operating pressure. B. How does…

A: given; A. What is the effects of different input parameters on evaporator operating pressure. B. How…

Q: The reheat process is O decreases the turbine work increases the pump efficiency O decreases the…

A: Reheating Process: In the Rankine cycle when superheated steam two times expanded in two turbines,…

Q: -p-h diagram is .10 used to determine the refrigeration сарacity. used to determine the refrigerant…

A: what is the use of p-h diagram for refrigerant.

Q: a) Total expansion work (kJ/kg) b) Intermediate heating amount (kJ/kg) c) Calculate the rate of…

A: For solution refer below images.

Q: The food storage room requires a cooling system with a capacity of 15 tons of refrigeration that…

Q: QUESTION 2 The refrigerant undergoes a change of phase during the heat-transfer process, the…

A: Since we only solve upto three subparts at a time, we will solve the first three. Please specify the…

Q: For a hydroelectric plant, a hydraulic turbine-generator is installed at the site below the free…

A: Hydraulic Power is defined as the power available with fluid at entry to turbine or it is the power…

Q: What is the major difference in the way water is heated in firetube and watertube boilers?

A: The boiler in which water flows inside the tube, and hot gases flow outside the tube, is called…

Q: Determine the temperature rise of 21.593°F in the water-cooled condenser in °

Q: For a simple piping system of an industrial process and sugar and alcohol, what would be, on…

A: In an industrial process involving sugar and alcohol, the appropriate pressure and flow in the…

Q: Compare the diffence in number of gallons used to heat a home with natural gas compared to oil under…

A: The answer is given below

Q: 15. A test tube for boiling water has a diameter of 25 mm. Water at a rate of 1000 kg/h enters the…

A: The enthalpy of steam during phase change a the given pressure and temperature can be calculated…

Q: I am confused about this answer. I somewhat understand the method, however they use the saturated…

A: In general, when working with refrigeration systems, it's important to use the appropriate…

Q: Refrigerant flows in a evaporator with enthalpy of 259 kJ/kg and flows out the evaporator with…

Q: _is the amount of heat transferred to water to produce the required quantity of steam Quality of…

A: Quality of steam is nothing but dryness fraction. Quantity of steam is the amount produced in kg.

Q: The food storage room requires a cooling system with a capacity of 10 tons of refrigeration that…

Q: A steam boiler has the following data: - Steam output: 8000 lb/hr - Steam pressure: 135 psia - %…

A: Note: Since you have posted a question with multiple sub-parts, we will solve first three sub- parts…

Q: The food storage room requires a cooling system with a capacity of 15 tons and refrigeration that…

Q: what is the developed boiler horsepower if the steam rate is 0.85 kg/s and the factor of evaporation…

A: Factor of evaporation is given by, factor of…

Question

Determine the heat transfer to cooling water passing through the condenser in KJ/Kg of steam condensed

Water is used as the working fluid in an ideal Rankine cycle. Saturated liquid enters the pump
with a specific volume of 1.2720 X 10³m³/Kg and exits (the pump) at 1.7530 X 10³ m³/Kg and a
temperature of 380°C.The internal energy at the exit of the turbine is 2,500KJ/Kg. Determine:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

I need the answer as soon as possible
6.1) A boiler produces 25 kg/s of steam at 3 MPa and 600 °C, cools the condenser with seawater so that the outlet is at 45 °C, then a reheating at 500 kPa up to 400°C is carried out, then a low-pressure expansion is carried out in the turbine. Determine: A) The net power output B) The total heat transfer in the boiler Boiler Pump www اپنا Be Turbine Condenser آلفا Ans= A) 34820 kW B) 91733 kW
Write the name of the law relates with isothermal process
I think its Chemisty... If an evaporator outlet temperature on an R-410A system is 50f and the evaporator superheat is 10f, what is the evaporating pressure of the refrigerant in the system?
What comes up next to the Heat value of natural gas? Q is what? Also, in Fuel Oil, where does the heat required come from?
Every closed feedwater heater generates a condensate. Determine:a) If it is sent to the high pressure line, what device (or machinethermal) is required to be used for this purpose.b) It would be required to install a mixing chamber. Why or for what?
3. Name the principal parts of a simple vapour compression system
thermodynamics
What is the critical pressure of R-134a, in kPa?
1