The air entering the turbine with 1200 K and 1200 kPa expands to 100 kPa pressure in twostages. When the air is reintroduced to 1200 K at a constant reheat pressure of 350 kPa andboth expansion stages are ideally realized:a) Total expansion work (kJ/kg)b) Intermediate heating amount (kJ/kg)c) Calculate the rate of increase in work according to the stepless (without reheating)expansion.Features for air:k=1,4, R=0,287 Jkg K,F1,005 klkg Kk = 1.4R = 0.287 kJ/kgKCp = 1.005 kJ/kgK%3D

For solution refer below images.

Answered: a) Total expansion work (kJ/kg) b)…

a) Total expansion work (kJ/kg) b) Intermediate heating amount (kJ/kg) c) Calculate the rate of increase in work according to the stepless (without reheating) expansion.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Steam flows isentropically through a nozzle from 1550 kPa, 288°C to 980kPa. For 453 g/s determine a) t2 in K b) A v in m³/s c) A H in kj/kg d) Draw T-S and Pv diagram.
None
40 - A 1.7 m³ constant volume container initially contains air at a pressure of 98 kPa and a temperature of 21ºC. From a tank with a pressure of 610 kPa, air is provided to flow into the container through a valve. The valve is closed when the vessel pressure is equal to the tank pressure. If the temperature inside the container is 85°C, which of the following is the mass of the air entering the container? a) 11.5kg B) 9.2kg NS) 10.2kg D) 11.1 kg TO) 8.1 kg
25. Steam at 2.6 MPa, 400 deg C expand isothermically until its pressure becomes 4.36 MPa. Calculate a)delta H, b)delta U, c)delta S, d)delta V, & e) WNF.
2 .A two-stroke four-cylinder ideal Otto engine operates at 4800 rpm. Air is taken in at 101 kPa and 20C. The volume in each cylinder is 500cm^3 before compression and 90 cm^3 after compression. If 2500 J/g air of heat is added, determine a) Compression ratio b) p, V, and T at the four corners c) Entropy change during heat addition process d) Wkcycle e) Qrej f) Power of engine g) Sketch the p-V and T-s diagrams
12-The saturated vapor refrigerant - 134a (refrigerant, R-134a) is compressed in a compressor from a temperature of 28°C to a pressure of 0.9 MPa. If the compressor efficiency is 89%, which of the following is the compression power? A) 13,57 kJ/kg B) 14,63 kJ/kg C) 3,90 kJ/kg D) 4,92 kJ/kg E) 4,38 kJ/kg
Calculate the net work per cycle, in kJ; B) the power developed by a motor, in kW and C) the thermal efficiency if the cycle is executed 1500 times in one minute. To answer the above, consider that the displacement volume of a Diesel internal combustion engine is 3 liters. The cutoff ratio is 2, and the conditions at the start of compression are set to 100 kPa, 22°C, and 3.17 liters.
A building has a total heating load f 200,000 Btu/hr. The sensible heat factor for the space is 0.8. The space is to be maintained at 72°F and 40% RH. Outdoor air at 40°F, 20% RH in the amount of 1000 CFM is required. Air is supplied to the space at 100°F. Find a) the conditions and amount of air supplied to the space b) the amount of water at 50°F required by the humidifier section c) the capacity of the heating equipment needed d) the temperature rise of the air through the heating unit.
At a pressure of 0.8 MPa and a degree of dryness x = 0.65, the refrigerant R-134a is heated to saturated steam at constant pressure. Calculate the work done by the refrigerant during the phase change A) 9,7 kJ/kg B) 9,1 kJ/kg C) 65 kJ/kg D) 19,4 kJ/kg E) 6,9 kJ/kg
11.) A heat engine with &=0.450 operates between two heat reservoirs at 300K and 700K. During each cycle of operation the engine takes in 200J of heat from the 700K reservoir. Th a) Find the magnitudes of the Wk, Qh, and Qc for one cycle of operation of the engine. b) Draw the energy flow diagram for one cycle of operation on a figure like the one shown to the right. Show an arrow and the value from part a) for: Wk, Qh, and Qc. c) Is this engine real, reversible, or impossible. Explain why. Engine Te
37 - Water vapor enters a continuous flow adiabatic nozzle at a temperature of 350ºC and a pressure of 4.5 MPa. What is the specific volume at the inlet? a) 0.07343 m³/kg B) 0.05784 m³/kg NS) 0.06647 m³/kg D) 0.05842 m³/kg TO) 0.05197 m³/kg
4- 0.5 kg of air in an insulated closed system is heated from 17°C to 427°C at constant pressure with the help of an electric heater. Given that specific heats change with temperature, which of the following is the entropy change of air? A) 0,429 kJ/kgK B) 0,452 kJ/kgK C) 0,905 kJ/kgK D) 0,521 kJ/kgK E) 0,435 kJ/kgK