Water is pumped to a storage tank from a pool by a centrifugal pump. The elevation difference between the pool and the storage tank is 60 m. The stórage tank and the pool are open to atmosphere. 50 meters of 6 in Sc 40 steel pipe is used between pool and pump. After the pump 6 in Sc 40 pipe with a length of 22 m is suddenly contracted to 4 in Sc 40 pipe, that is 70 m. The flow rate of water is 2.5 m/min and the temperature is 20°C. If the pump efficiency is 0.6 and the cost of electrical energy is 0.40 TL/kWh,calculate daily cost of electricity used for this system.

Water is pumped to a storage tank from a pool by a centrifugal pump. The elevation difference between the pool and the storage tank is 60 m. The stórage tank and the pool are open to atmosphere. 50 meters of 6 in Sc 40 steel pipe is used between pool and pump. After the pump 6 in Sc 40 pipe with a length of 22 m is suddenly contracted to 4 in Sc 40 pipe, that is 70 m. The flow rate of water is 2.5 m/min and the temperature is 20°C. If the pump efficiency is 0.6 and the cost of electrical energy is 0.40 TL/kWh,calculate daily cost of electricity used for this system.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Question 2) The centrifugal pump in the figure is in his preference Passing water at 25°C from the tank through the 1.22 m exchange store pumping. Inner diameter of the suction channel is 101.6 mm, in total it is 0.0306 and its length is 3.2 m. It the local coefficients of the user in the pipe are 7.4. If the pump works at a flow rate of 109 m3/h ENPY=1.52 is m. Does the pump work without cavitation at this flow? Show the calculation. For water, p=997 kg/m3 and Pb=3.169 kPa. Piping system at the entrance (Suction pipe) pump 22 Patm=101.3 kPa and 0.2=1.05. van
When a pump with a suction and discharge pressure of 125 kPa and 409 kPa are used, the flow rate is 30L/s into a pipe with a diameter of 4 cm. Approximately 10cm in diameter, the suction diameter. What is the energy added to the water by the pump in meters
A garden hose is connected to raise a narrower hose wherein the diameter of the bigger is twice the diameter of the narrower hose. The fluid flowing is a fresh water having an entrance velocity of 1.2 m/s and a pressure of 143 kPa find the the pressure in KPa and velocity in m/s at the exit point. Note; h or Ay = 20.0 cm (Express or round off your answer to one decimal place.) 20.0 cm Answer:
A pump draws water from a reservoir and conveys it to another reservoir 30 m above. The suction pipe is 100 mm in diameter and 10 m long while the delivery pipe is 100 mm in diamter and 150 m long. if the the velocity in the pipe is 3 m/s, the friction factor of the pipe 0.008, and the pump and motor efficiencies are 85 % and 92 %, respectively. Assume height of pump/motor negliglible. Q1. Calculate the gauge pressure at the pump's inlet (at C) (kN/m2) Q2. Calculate the gauge pressure at the pump's outlet (at D) (kN/m2) Q3. Calculate input power to motor (kW)
Read the question carefully and give me right solution according to the question
In Fig. is shown a plot of pump net head as a function of pump volume flow rate, or capacity. On the figure, label the shutoff head, the free delivery, the pump performance curve, the system curve, and the operating point.
pump rated at 700W is used to transfer water from an open tank at ground level, to another open tank 18m above ground at a rate of 3.25 kg/s. Neglecting friction losses, determine the efficiency of the pump. 81:98% 67.42% 88.29% 58.94% Which among the following is an assumption made by the Bernoulli equation? the pump must operate at 100% efficiency the flow is comppletely horizontal. friction is negligible in the flow the pressure on one side must be atmospheric
Water from a reservoir is pumped over a hill through a pipe 450 mm in diameter and a pressure of 1 kg/cm2 is maintained at the summit. Water discharge is 30 m above the reservoir. The quantity pumped is 0.5 m3/sec. Frictional losses in the discharge and suction pipe and pump is equivalent to 1.5 m head loss. The speed of the pump is 800 rpm what amount of energy must be furnished by the pump, kW?
Include a fre body diagram Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in which the pressure is reduced and electricity is produced. The shaft power input to the pump is 1 KW snd the shaft power output the turbine is 1 kW. Both the pump and turbine are 90% efficient. If the elevation and velocity of the water remain constant through out the flow and irreversible headloss is 1 m, the pressure of water in kPa at the turbine exit isA. 126B. 131C. 127D. 129
In oasis Water Company to purify the water, it is flowing through a reducer in a horizontal pipe where the diameter is reduced from 35 cm to 25 cm. The pressure in the 35 cm pipe just upstream of the reducer is 3 150 kPa. The fluid has a vapor pressure of 50 kPa and a specific weight of 5 kN/m . Neglecting frictional effects, calculate flow rate of water through this pipe in lit/s. Draw diagram neatly.
answer first item only