Water at 20 degree C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to the open top of an experimental absorption tower. The point of discharge is 5m above the floor and friction losses in the 50 mm pipe from the reservoir to the tower amount to 2.5 J/Kg. At what height in the reservoir must the water level be kept if the pump can deliver only 0.1 K.W?

Q: Water at 60 deg. F is pumped from a reservoir to the top of a mountain through a 6-in SCH 120 pipe…

A: Given:Water temperature, T=60oFPipe=6 in Schedule 120 Average velocity of water, V=12 ft/sElevation…

Q: A pump receives 8kg/s of water at 230kPa and discharges it at 1200 kPa. Compute the power required…

A: It is required to choose correct answer

Q: You wash your roof with a water hose at a height of 8.0 m above the ground. You connect two garden…

A: Given- P1 = Atmospheric pressure = 1.01 x 105 Pa v1 = 6 m/s height from datum 2 to 1 = (h) = 8 m By…

Q: 2. A pump is used to move water (p = 1000 kg/m³) from a lake into a large tank as shown below. The…

A:

Q: Oil is pumped from a very large tank (z1 = 150 m) to another tank (z2 = 200 m), located higher and…

A:

Q: The water is flowing through a pipe having diameters 45 cm and 15 cm at sections land 2…

A:

Q: A cylindrical tank is being filled with water flowing with constant velocity V1 through a tap (Tap…

A: Given, Diameter of the tap  1= d1 Velocity through the tap = V1 Diameter of the tank = DT. Diameter…

Q: A pump which consumes 25 KW of energy (n = 0.73) is hooked to the outlet from the tank shown below.…

A: Here we will apply Bernoulli equation to get the height of jet.

Q: Write what you now about Bernoulli's equation and why it is very important in our life

A: This question is based on the concept of Bernoulli's equation.As per the guidelines of Bartleby, we…

Q: pump, u =7 motor = (0.70)(3 kW) = 2.1 kW pump electric he inlet diameter of the pump, Di = 50 mm and…

A:

Q: The water is flowing through a pipe having diameters 45 cm and 15 cm at sections tand 2…

A: Given data diameter at section 1 (d1) = 45 cm  diameter at section 2 (d2) = 15 cm  discharge rate…

Q: 5. Water is pumped at a rate of 6 x 10-4m³/s in a horizontal pipe of 0.04 m diameter and 150 m…

A: Flow rateDaimeter of the pipeLength of the pipePressure drop in the is 150.15 KPaHeight of the…

Q: Water from a reservoir is pumped over a hill through a pipe 900 mm in diameter and a pressure of one…

A: Given:Pipe diameter, d=900 mm=0.9 mPressure at the pipe discharge, P2=1 kg/cm2=1*98.1 kPa=98.1…

Q: There exists a sharp entrance (Ken= 0.5) from the tank to the pipeline, shown in the figure. Also, a…

A:

Q: Two long pipes in parallel are used to carry water between two reservoirs. The diameter of one pipe…

A:

Q: Water flows between two reservoirs A & B. The water level in A is 400 m AOD and in B is 385m AOD.…

A:

Q: 2) A pump is being used to transport apple juice from an open tank to a second tank as shown below.…

A: Given:Mass flow rate of apple juice, m˙juice=1 kg/sInside diameter of suction pipe, d1=4 cm=0.04…

Q: through a U-section pipe as shown in Figure 1.2. At flange (1) the total absolute pressure is 240…

A:

Q: The water is flowing through a pipe having diameters 40 cm and 15 cm at sections Tand 2…

A: As per our guidelines, we are supposed to solve only three sub-parts if multiple sub-parts are…

Q: Water is to be pumped from the bottom of a well 20 ft deep with a specific heat of 1 BTU/lbm F is…

A: Given Data1hP=764WTs=35°Fc=1 BTU/lbm°FQ=500 BTU/minh=20 ft=6.096m

Q: Water is pumped up through an inclined pipe to supply water on to a ridge. The diameter of the pipe…

A: This steps contain all the given data.

Q: A water discharge 8 m^3/s is to flow through this horizontal pipe, which is 1 m in diameter. If the…

A: Given Data Discharge, Q=8m3/s Pipe diameter, D=1m Velocity, V=QA=8π4(1)2=10.19 m/s

Q: Flow takes place between three reservoirs, as shown in Figure 1. The volume flow rate out of…

A:

Q: Water is to be moved from one large reservoir to another at a higher elevation as indicated in the…

A: GivenQ=6.2 ft3/shL=61V22   ft2/s2d=8inz=56ft

Q: The variation of pump head, efficiency, and required ENPY parameters with flow rate obtained from…

A:

Q: Water is flowing through a U-section pipe as shown in Figure 1.2. At flange (1) the total absolute…

A:

Q: 09. Water is supplied at 150 ft/s and 60 psi to a hydraulic turbine through a 3-ft inside diameter…

A: The power loss from inlet to exit of turbine is required to be calculated. The power loss is the…

Q: A 300 mm diameter pump rotating at 600 rpm develops a head of 150 m. Determine the peripheral…

A: Answer: The peripheral velocity factor for the pump is 0.1737.

Q: Kerosine at 20°C flows through the pump in the figure given below at 2.3 ft³/s. Head losses between…

A:

Q: The pump whose characteristics are: H, = 80 – 6o0v² n = -1500V² + 700V Elevation = 230 m |(2) (1)…

A: Given- d = 40 cm = 0.4 m L = 1000 m

Q: The water level in a tank open to the atmosphere is 20 m above the ground. A hose connected to the…

A:

Q: If the diameter at section 1 in a pipe, is 20 cm and the diameter at section 2 is 30 cm. The mean…

A: Write the expression for the continuity expression.

Q: Water at 60 deg. F is pumped from a reservoir to the top of a mountain through a 6-in SCH 120 pipe…

A: Givend=6in=6×0.0254=0.1524 mV=12 ft/s=12×12=144 in/s=144×0.0254=3.6576…

Q: A 20 hp pump with a suction from an open reservoir (10 m above the pump) has a flow rate of 125…

A:

Q: Water with density of 998 kg/m3 flows from a lake through a device inside the building at rate of…

A:

Hydronics