Answered: Using the given circuit, calculate: 1)…

Using the given circuit, calculate: 1) Equivalent capacitance 2) Charge across each capacitor 3) Voltage across each capacitor C, SnF V 24V

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: Problem 2 Draw the waveform of vo of the op-amp circuit shown for the given waveform of vi. Label al...

Q: 50V 10 N Va Vc 30 V 10Ω. 10Ω. GA

Q: Calculate the percent power saved (%) in an amplitude modulated wave when it is transmitted with 45%...

Q: Theoretical calculations: 3. How dose the bandwidth change in relation to increasing signal amplitud...

Q: 10.12. An LTI diserete-time system has the impulse response (0.9Y"u[n]. (n) Determine whether this s...

A: The solution is given below

Q: he rotor is star connected and has an impedance of (0.8 + j6) ohm per phase. Find the rotor current ...

A: Solution- Given, Rotor impedence = 0.8+j6 ohm Stator impedence = 4+j3 ohm Voltage = 65 V sl...

Q: For the circuit in Figure 1, set up the supernode equation. Response format: Ava ± Bvb ± Cvx = D 2)...

Q: Еxample Determine (a) the peak frequency deviation, (b) minimum bandwidth, and (c) baud for a binary...

Q: Use superposition theorem in solving the brabch currents

A: In this question, Use superposition theorem in solving the brabch currents? Here 2 independent ene...

Q: 1: On a 460-volt supply, a DC Shunt motor operates at 10 rps when drawing a line current of 30A. Its...

Q: a. The total vector voltage in rectangular coordinates. b. The magnitude of the voltage that a voltm...

Q: An RLC circuit has a resistance of (2.66x10^2) S2, an inductance of (1.93x10^1) mH, and a capacitanc...

A: For a RLC circuit -The value of resistance is,R=2.66×102 ΩThe value of inductance is,L=1.93×101mHL=1...

Q: 3. Determine the node voltages V1 and V2 using nodal analysis. 6A 2 loA 48n 242 (↑)18A

A: Given:

Q: 3. Determine the node voltages V1 and V2 using nodal analysis. 6A 2 l0A 482 $ 24 (1) 1BA

Q: When should a dense index be preferred over a sparse index? Your response should be explained.

A: Dense index : Index is related to data base system in any data base system if index will be dense in...

Q: SaR Suppose that the signals xfm], x[m] and x,[n] are given by and xfn] ='220 25 2mn 2mn ala) = cos)...

Q: 1. F(W,X,Y,Z) = Em(0,3,5,6,7,10,12,13) + Ea(2,9,15)

A: Given minterm function, FW,X,Y,Z=∑m0,3,5,6,7,10,12,13+∑d2,9,15

Q: What is the difference between wound rotor induction machines and squirrel cage machines

A: The wound rotor (also called as slip ring) and squirrel cage machines are the type of rotor in induc...

Q: 3. Consider open-loop transfer function: 10K(s + 1) G(s) = s2(s² + 12s + 20) a) Apply Nyquist Stabil...

A: Root locus: This is a graphical representation of the system in the S-plane for all possible locatio...

Q: A carrier wave is modulated by two sine waves resulting to modulation indices of 0.3 and 0.5. Find t...

Q: which of the following does not increase resistance.

Q: An audio signal has an amplitude of 10V and frequency 5KHZ, if the carrier frequency of FM signal is...

Q: 2. For the following circuit assume r 8.7 I6 V a. Draw the small signal equivalent circuit. b. Find ...

A: Brief description : Here they have mentioned a common collector amplifier circuit. The characterist...

Q: A balanced 3 phase load draws 75 amperes line current at 230 volts line to line and 0.848 lagging po...

A: In this question, A balanced 3 phase load draws 75 amperes line current V=230 volts line to line Po...

Q: 9.1. Determine which of the following discrete-time functions is different: (a) x[n] = u[n] + u[-1 -...

Q: Given Ig=1.3 mA, B= 100, and r.= 40 k2, sketch: 1. The CE and CB hybrid equivalent models. 2. The CE...

Q: 5Ω 5vO 10 Ω 10 Ω 2Ω Vx +1 6V

Q: In the following RLC circuit, the source E is 200 V z 0°, f = 2.5 kHz, R=400 2, C = 100 nF and L = 2...

Q: 2. Repeat using Thevenin’s method :

Q: An FM transmission has a frequency deviation 28 kHz. Determine the percent modulation of this signal...

A: The maximum deviation in FM broadcast is 75KHz. The percent modulation is percentage of actual to th...

Q: . Contribution of load flow studies to erect new power station?

Q: 4. What is the application of AM-SSB?

A: (i) AM-SSB is used for long distance transmission of voice signals. (ii) AM-SSB is used in the trans...

Q: Calculate the percent power saved (%) in an amplitude modulated wave when it is transmitted with 45%...

Q: Three similar coils, each of resistance 10 Q and reactance 10 Q, are connected in star across a 400-...

Q: Given: The input to a voltage regulator circuit varies from 11.4 to 12.2 V. The load voltage is to b...

A: Given, Vs(max) = 12.2 v , Vz = 9.1 v , I(max) = 95 mA. We need to find the power rating of the zener...

Q: 3. Given, C(s)/R(s) = 36/ s²+4.8s+36. Draw the step response of this system and mark all the time do...

Q: What is the approximate voltage amplitude and frequency of the waveform below? Trig Vertical Pos Hor...

Q: 3. Determine the node voltages V1 and V2 using nodal analysis. 6A 2 loA 482 24n (1)18A

Q: Consider the circuit diagram below. If two identical capacitors must be used to smooth the output, w...

A: Above shown is the circuit of full wave bridge diode rectifier with Capacitive filter which reduces ...

Q: A capacitor is made with a dielectric layer of mylar film that is 12μm thick. The effective area of ...

Q: Problem 1 10 K D3 The diodes in the circuit are Silicon with forward voltage of 0.7 V. Fill up the t...

A: Brief description: In the above question they want to know the value of current and voltages across ...

Q: Identify and illustrate the all various types of clampers and diode clippers (series and parallel).

Q: 5. How does the bandwidth change in relation to increasing signal amplitude ? 6. What are the types ...

Q: Note: Value of X=1. Value of Y=3 For the circuit in the figure, set up the supernode equation, the a...

A: In this question, We need to write the node voltage equation, Here 3 nodes are consist. One node ...

Q: 1- Explain the operation of the PCM encoder used in module ED-2960F. 2- Discuss the advantages and d...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Homework1 • Given first order LCCDE y(n)=ay(n-1)+x(n) 1) find the transfer function. • 2) find impul...

Q: Registrants at a large convention are offered 8 sightseeing tours on each of 4 days. In how many way...

Q: QUESTION 25 Each of the following will improve a memory chip except more memory locations longer acc...

A: The solution is given below

Q: For the circuit in the figure obtain the contribution of the sources of (Y)V and (X)V to vz. Note: V...

A: This problem comes under electrical network theory . It is related to super position theorem . In th...

Q: Example Determine (a) the peak frequency deviation, (b) minimum bandwidth, and (c) baud for a binary...

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

Using the given circuit, calculate:
1) Equivalent capacitance
2) Charge across each capacitor
3) Voltage across each capacitor
C, SnF
V 24V
2nF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
For a given RC charging circuit with R 82KOhms, C 150UF and Vs 18 V, i. Calculate the capacitor charging voltage at t- ii. Specify the charging current at 2T where T= RC. iii. Explain the effect in the charging period if the value of R is doubled with the capacitance value of C kept constant. Prove your answer by computing the resulting full-charge periods when R is 82KOhms and when R is doubled with C kept constant. %3D (1 mark) (1 mark) 3D3T. (2 marks)
Fill in the blanksadd, capacitance, charge capacity, dielectric, dissipate, electrical circuits, , passive, plates,proximity, storesA capacitor is a 1 …………. two-terminal electrical component that 2 ……… potential energy in anelectric field. The effect of a capacitor is known as 3. …………... While some capacitance exists betweenany two electrical conductors in 4. …………… in a circuit, a capacitor is a component designed to 5.…… capacitance to a circuit. The capacitor was originally known as a condenser.The physical form and construction of practical capacitors vary widely and many capacitor types are incommon use. Most capacitors contain at least two electrical conductors often in the form of metallic 6.………… or surfaces separated by a 7. ………medium. A conductor may be a foil, thin film, or anelectrolyte. The nonconducting dielectric acts to increase the capacitor's 8. ………… ………. Materialscommonly used as dielectrics include glass, ceramic, plastic film, paper, mica, and oxide…
Determine the total capacitance, total charge, individual voltage drop and charges across each capacitor. Use two decimal places for your answer. Put your answer for the individual voltage and charge for each capacitor in a table for faster checking.
QUESTION 1 a) State two (2) main properties or acts of each capacitor and inductor in RL and RC cireuit analysis ( voltage and current ). b) Define what is capacitor and inductor. Support the answers with an appropriate illustration of capacitor and inductor basic structure. c) Natural response happens to all passive storage element component. Explain natural response for circuit behaviour for a capacitor with an appropriate illustration. d) The switch in circuit Figure 1 has been closed at t 0. 6 A 10 0 i(t) 7.5 H Figure 1: First Order RL Circuit
Describe the voltage across and the current through the inductor combination in both charging and discharging phases. Calculate the total capacitance and inductance of the circuits and verify your results by simulating the circuit.
Please derive this equation for capacitance at flat band:
A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0, there is no charge on the capacitor. Find the capacitance if the current at t = 5 seconds is 3/e^s amperes. Ans. 0.05 Farads
how do i calculate the inverse capacitance and its uncertainty if the capacitance value 1.8748+/- 0.0006. please show steps im using this example to do my other values.
K2 A/2 Say you have given the above schematic diagram of internal layout of a capacitor. Here, the dielectric constants are k1 = 50, k2 = 68, k3 = 68. The plate area of the capacitor is A = 24 cm? and plate seperation is 20 mm. a) Identify series and parallel connections and find the equivalent capacitance of the capacitor. equivalent capacitance Give your answer up to at least three significance digits. b) We want to replace three materials with just one material such that the eguivalent capacitance remains the same. Find the numerical value of dielectric constant of the new material k'. Value of k' Give your answer up to at least three significance digits.
At a potential of 7000 V, a simple parallel-plate capacitor will be built to store charge. The capacitor has a separation distance of 0.21 mm between plates and a plate area of 0.030m2.The dielectric constant of a material with a dielectric constant of 6.5 is positioned.in the space between the plates Compute the capacitance of the capacitor and compute the magnitude of the charge stored on each plate.Then,If the capacitance in above has to be increased, choose one acceptable dielectric material from Table 2 below to use between the plates.Justify your mathematical decision.
Please determine if each question is True. If false, please explain why a) A fully charged capacitor behaves identically to a break in the wire (i.e. no current passes through it).b) An uncharged capacitor behaves identically to a break in the wire (i.e. no current passes through it).c) Whether charging or discharging a capacitor, the charge on the capacitor can be modeled using an exponentiallyincreasing function.