Two horizontal plates are spaced 3 in. apart. The space between the plates is filled with mercury at 90 ° F . The upper plate is moving at 3 ft /sec, (a) Why does the liquid velocity vary linearly between the plates ?  (b ) Calculate the shear stress at a plane 1 in. from the slower moving plate. (c) Calculate the momentum flux at the surface of the faster moving plate.

Q: The laptop consumed a total of 20 kW per month. This is equivalent to how many BTU/hr?

A: Given data Power (P) = 20KW

Q: to be enlarged by blowing air into it. If the surface tension of the soap solution is 0.0038 lbf/ft,...

A:

Q: Problem 5. Both ends of a 1-foot organ pipe are open. What are the frequencies of the fundamental an...

A:

Q: Two designs for a beam are to be considered. Determine which one will support a moment of M= 150 kN....

A: GivenM=150kNm=150×103Nm=150×106 Nmm

Q: A rigid bar is supported by three non-rigid rods, as shown. There is no initial strain and the lengt...

A:

Q: What kind of crankshaft should you use for a v-type engine with 12-cylinder assembly?

A: Common crank shaft is used in a v-type engine.

Q: 1) A wall section composed from the outside to inside, of concrete brick 100mm thick, an air space o...

A: Conduction convection heat transfer through composite wall The composite divider is a divider that c...

Q: find (a) T V, T3, V3, Tạ, and p4 (b) WNet, (c) e and p and (d) the bp for 300 Then 16 Btu/cycle are ...

A: Given:  For this idea diesel engine it is using standard cold air which has the specific heat capaci...

Q: A block slides on the inclined plane as shown with friction given between the surface %3D and the bl...

A:

Q: 4. In the figure below, a 100 kg block rests on an incline with a coefficient of friction is 0.30. F...

A:

Q: A small ship capable of making a speed of 6.3 knots through still water maintains a heading due east...

A:

Q: A closed system undergoes a thermodynamic cycle with three steps: process 1-2 (from state 1 to state...

A:

Q: Water vapour at 135 kPa and 183 is compressed isothermally until half the vapour has condensed. How ...

A: GIVEN DATA - WATER VAPOUR AT 135KPa AND 183'C COMPRESSED ISOTHERMALLY WE HAVE TO FIND WORK

Q: Nitrogen flows steadily through a converging tube. Near the inlet, the nitrogen is at 8.0 psia, 40 °...

A: The cross section area at the downstream section is 0.926 ft2.

Q: Two Carnot heat engines run in series with the efficiency of first engine is k times the second. If ...

A:

Q: If Rx = -5√3/2 and Ry= 7.5 , find the direction and resultant

A: Given that, forces in x and y components are,  Rx= -(5√3)/2  Ry= 7.5

Q: 6. Starting from a point P, a car travels 20 km due east and then travels in the direction N50°W unt...

A:

Q: State 1 for a dual combustion engine is p = 1 atm and T1= 60.3°C; r = 18; at the end constant volume...

A: Disclaimer:Since you have posted a question with multiple subparts, we will solve the first three su...

Q: 2. Find the magnitude of the force F2 and the angle if the acting on

A: Need to find Magnitude of force and angle 

Q: In a pumping system handling water, the level in the suction tank is 3.2m below the pump shaft cente...

A:

Q: Is there a flaw in the pipeline design as shown in Figure 4? (select one): (A) The strainer and foot...

A: Option (a) If strainer and foot valve will be used in combination, then this combination obstructs t...

Q: Compute the pressure at point B if Pa=2 m of H20 if the manometer has oil with specific gravity = 0....

A: As per given question  PA=2m Spefic gravity= 0.9 We have to determine pressure at point B  

Q: Given data Mass=18 kg Velocity=3 m/s Determine kinetic energy

A: Given data : Mass of object=m m=18 kg Velocity of object=V V=3 m/s   Find : Kinetic energy  

Q: 9.12 (a) Derive the equations for the circumferential and longitudinal stresses in a thin cylindrica...

A:

Q: 2.4 Application of Steady Flow Energy Equation (S.F.E.E)

A: GIVEN DATA - STEADY FLOW ENERGY EQUATION GIVEN WE HAVE TO EXPLAIN APPLICATION OF IT

Q: A constant volume process 2-3 and a polytropic 3-1 with n - 1.2 complete the cycle. Grculation is a ...

A: Given that: Process 1-2: Isentropic compression process P1 = 103.4 kPa, T1 = 27 oC = 300 K, P2 = 608...

Q: thermodynamic cycle with three steps: process 1-2 (from state 1 to state 2), process 2-3 (from state...

A:

Q: Fill in the blanks: Compute the difference in pressure (Pa-PR) if pipe A contains oil with sg = 0.92...

A:

Q: A composite beam is made of two brass (E = 107 GPa] plates bonded to an aluminum [E = 65 GPa] bar, a...

A:

Q: A vacuum gauge mounted on a condenser reads 0.56 m Hg. What is the absolute pressure in the condense...

A:

Q: I.m with the least amount o

A:

Q: Four kilogram of steam is initially at 1MPa and y=40% inside the piston cylinder. There is a 30C sup...

A: In the case of pure substance, when heat is removed or given to steam, it can achieve saturated liqu...

Q: A steering system of a car operates on the Ackermann steering gear. The wheel base of the car is 4.2...

A:

Q: determine the pressure of superheated steam at 250 °c and specific volume of 0.05970 m3 /kg.

A:

Q: Q2/ An object of mass 15 kg is moving with a uniform velocity of 4 ms. What is the kinetic energy po...

A: Given: The mass of an object, m = 15 kg The velocity of the object, v = 4 m/s  

Q: A worker is exposed to the following time varying noise profile in Table Q2 (b), determine the Leq f...

A:

Q: Determine the indices for the directions shown below: +z A D -/2 -/2 ~/3

A: Miller indices is the representation of planes or parallel planes of crystal

Q: Q2/ An object of mass 15 kg is moving with a uniform velocity of 4 m s. What is the kinetic energy p...

A:

Q: Determine the relationship which governs the velocities of the three cylinders, and state the number...

A:

Q: The laptop consumed a total of 20 kW per month. This is equivalent to how  many BTU/hr?

A:

Q: How many even numbers of 3 digits can be made with the digits 0,2,3,5,7,8,9 if no digit is repeated

A:

Q: a) A 6600V, 3 phase, star connected synchronous motor draws a full load current of 80 A at 0.8 power...

A:

Q: Given: Cables with loads as shown. Neglect cable self-weight. Let distance hc = Find: The tension in...

A:

Q: Steam enters an adiabatic turbine at 4MPa and 600C and exits at 40 kPa. If the efficiency of the tur...

A:

Q: 9. An initially rectangular element of material is deformed as sh in the figure (deformation shown b...

A:

Q: rectangular form.

A: Given : ln( 1+2i)   

Q: 16. A dual cycle using air operates at 14.7 psia, 70°F and r = 7. The cylinder diameter of the engin...

A:

Q: 2.Two Carnot heat engines run in series with the efficiency of first engine is k times the second. I...

A:

Q: Solve the following problem :a.What is the weight of a 1-kg mass at an altitude where the local acce...

A: Given data,  m= 1 kg  g= 9.75 m/s²  Note: for part b, complete data is not given.

Q: A pair of helical gears in which teeth on pinion are 20 and on gear are 30, the normal module is 5 m...

A: