) Two 220-V. d.c. generators, each having linear external characteristics, operate in parallel One machine while the other has a has a terminal voltage of 270 V on no-load and 220 V at a load current voltage of 280 V at no-load and 220 V at 50 A. Calculate the output of each machine and the bus bar voltage when the total load is 60 A. What is the kW output of each machine under this condition

) Two 220-V. d.c. generators, each having linear external characteristics, operate in parallel One machine while the other has a has a terminal voltage of 270 V on no-load and 220 V at a load current voltage of 280 V at no-load and 220 V at 50 A. Calculate the output of each machine and the bus bar voltage when the total load is 60 A. What is the kW output of each machine under this condition

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An induction machine, inverter, and control were implemented experimentally to validate the model shown in Fig. 3. To protect the experimental setup without significantly affecting the model, two factors were considered. The first factor is to avoid injecting faults that could cause severe failures or trigger the protection circuitry as predicted from simulations. The second factor is to use a tight external closed-loop torque control in experiments to avoid sudden overload conditions on the dynamometer and the motor shaft. Design a fault tree analysis (FTA) for induction motor failure in Fig. 3 if the rotational speed of the rotor failed to be controlled. fan cover cooling end fan bell wiring box lifting eye cast-iron frame nameplate stator coils squirrel- cage rotor Fig. 3 bearing seal ball bearing 0
q13 Complete the answer
pls provide solution
What is internal impulses?
Derive the equation of power transmitted by Flat - belt between two pulleys then find the equation of length of the belt. Also discuss the advantage and disadvantage of power transmission with belts.
No Handwriting please
The input power to a 3-phase load is measured as 6700 watts. If the line voltage and line current to the load are 430 V and 18 A respectively. The power factor of the System is,
Question (3): [1 A three-stage double acung telescopic cylinder is controlled with the circuit represented below. The supply pump has a displacement of 9 cm3/rev and it rotates at a speed of 2000 rpm. The cylinder rods have diameters of 100 mm, 80 mm and 60 mm. The barrel diameters are instead 110 mm, 90 mm and 70 mm. When extending, the cylinder sees a resistive force of 28 kN, while when retracting the external load is null. Calculate the extension and retraction velocities and the pressures in the following case: A. - No restrictions present in the lines Assume an oil density equal to 850 kg/m3. The relief valve is set to 150 bar. Find: a) Extension speeds Vel (for cylinder 1), Ve2 (Cyl 2), Ve3 (Cyl 3) b) Retraction speeds Vr1, Vr2, Vr3 c) Pump pressure during extension and retraction (PPE, PPR) πT www P PP RY DCV HXw Fig 3 CYL -F -
4. A network made up of seven independent units representing a system is shown in Figure 4.8. Each unit's reliability, R, for i = 1, 2, 3, 4, and 5, is given. Calculate the network reliability by using the network reduction method. R4 = 0.8 R5 = 0.9 %3D R6 = 0.8 R2 =0.6 R3 = 0.9 R7 =0.9 %3D R = 0.7 FIGURE 4.8 A seven independent-unit reliability network.
I need the answer as soon as possible