A 4 pole generator with wave wound armature has 54 slots each having 28 conductors. The flux per pole is 0.01 Wb. (i) At what speed must the armature rotate to give an induced EMF of 220V is, (ii) What will be the voltage developed, if the winding is lap connected and the armature rotates at the same speed is,

A 4 pole generator with wave wound armature has 54 slots each having 28 conductors. The flux per pole is 0.01 Wb. (i) At what speed must the armature rotate to give an induced EMF of 220V is, (ii) What will be the voltage developed, if the winding is lap connected and the armature rotates at the same speed is,

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In winter season, he chemical observed a snow from a pavement that is being scooped up to a height of 40 ft by an endless bucket-scoop. and is then dropped into a container. He noticed that, at the highest point, the snow moves at 3 k’s. A total of 66 hp is needed to scoop snow at the rate of 100 lb’’s. Assuming a loss of 10% due to friction, calculate the percentage of tool work need to melt and break up the snow.
3
Scissors are like a double-lever system. Which of the simple machines is most analogous to scissors?
Q1. The part shown below will be turned in two machining steps. In the first step a length of (50 + 50) = 100 mm will be reduced from Ø100 mm to Ø80 mm and in the second step a length of 50 mm will be reduced from Ø80 mm to Ø60 mm. Calculate the required total machining time T with the following cutting conditions: Cutting speed V=80 m/min, Feed is f=0.8 mm/rev, Depth of cut 3 mm per pass. Ø100 Ø80 Ø60 50 50
23. Mastery Objective 23: Perform shearing on triangles and parallelograms, and explain what measurements are preserved or change. (a) Shear the following triangle. Explain what measurements change and what stays the same, justifying your claims. D. (b) Shear the following parallelogram. Explain what measurements change and what stays the same, justifying your claims.
Q2. Draw a neat diagram and explain the uses of following tools in sheet metal shop a) Centre punch b) Mallet c) Snips d) Sakes and Anvil
DESCRIPTIVE GEOMETRY