Three resistance: 30, 20, 52 are connected in series and 20 volts. a) equivalent resistance of the circuit b) total current of the circuit c) Voltage drop across each resistor

Q: Q1: Draw the following signal and find the phase shift, f. 300 Hz: x(t)= Acos[@, (t-0.002)]

A: In this question,  We need to draw the signal and find the phase angle.  Frequency w= 2πf  Where f…

Q: 3. What is the equivalent resistance of the combination of identical resistors between points a and…

A: We need to find equivalent resistance for given circuit

Q: Q2:A: Consider the below block diagram, find G1(s). Such that: C(S)/R(S) = 10S²+105+1 S² +S+2

A:

Q: following set of linear differential equations: 0.02 w+ 0.15w = 0.03i, 0.7 di/dt + 3i = v - 0.03w.…

A:

Q: A particular pn junction at T = 300 K is doped with impurity concentrations of Na = 1.2 x 10¹4 cm³…

A: Given,T=300 KNd=1.2×1014 cm-3Na=2×1014 cm-3po=1.1×1014 cm-3Vt=25 mV∈s=13.1 ∈0

Q: How exactly was the combined impedance found my calculation was 27.43 ohms

A: The given impedance is in rectangular form and the same can be used to find only the magnitude value…

Q: Determine Vout for Vin-110 V, R₁-213 Ohm, R₂-8 Ohm

A: The required voltage can be calculated by using voltage divider rule.

Q: Choose the correct answer. 1. A fluxgate magnetometer allows a robot to locate itself on the basis…

A: Solution of question (1): It is asked to tell how does a fluxgate magnetometer allows a robot to…

Q: Paralleling of two generator step by step

A: Generator: Generator is an electrical machine which converts the mechanical energy into electrical…

Q: In a series circuit, you measure 9 volts across a 300 ohm resistor. How much current is flowing…

A: Given: A series circuit with, Measured voltage, V=9 volts. Resistance, R=300 Ω.

Q: How do you convert a voltage source in series with a short-circuit to a current source? A B Multiply…

A:

Q: (a) Determine the power and the rms value for the signal x(t) shown in the Figure below. (b) Sketch…

A:

Q: 1) Answer two only A- Sketch the single-sided and double-sided spectra for phase and amplitude of…

A: Given The given function is, xt=5cos30π+10t+4sin50πt+45-2.5cos80πt

Q: Question # 5: Find the ramp response for a system whose transfer function is G(s) = s/ [(s+4) (s+8)]

A:

Q: What length of a 50 ohm open circuit transmission line is equivalent to a 1 uH inductor at 50 MHz

A: We need to find out length of transmission line for given impedance .

Q: Q5: a) Find the bandwidth efficiency of 16-PSK modulation system, If 180 kHz of bandwidth is…

A:

Q: For the following voltage function: What is the correct value for the frequency in Hz, for the…

A: In this question,  We need to determine the frequency of the voltage signals.  We know Standard…

Q: Given the circuits below, what is the value of V due to the contributions of 6V source and 3A…

A: The given circuit is: Here, in the circuit there are two ideal sources: 1) 6V voltage source and,…

Q: Write the logic equation for the variable F in the circuit below, as implemented. AB CD B' C' F

A:

Q: A 35 A current flows through a 47 Q resistor. What is the voltage across the resistor? Ex: 540 V

A: Given, Current, I=35 A. Resistance, R=47 Ω.

Q: Consider Vdd = 1.8v, Vthn = 0.39v, and Vthp = -0.4 v for the problem. Assume i=g=0. Sketch Vout as a…

A:

Q: op-Amp circuit that produce output given by V₂ = -(4√₁ + √₂ +0:1√₂) if v₁ = 2 sin wt ; V₂ = 5V, and…

A: Design of a op-amp circuit that produce the given output waveform:

Q: 3. Calculate Vas in the circuit. 75 V + 2012 120 .300 280 150 एक ww ab www 2012 a 180

A:

Q: Determine the main core and yoke dimensions for a 200 kVA, 50 Hz, 1-phase core type transformer.…

A:

Q: A discrete-time signal x(n) is shown in Fig. Sketch and label carefully each of the following…

A: As per the policy of bartleby the provisions is to solve only 3 subparts of questions now I am…

Q: 1: In the circuit shown below, R₂/R₁=3 P₂/P Compute the Vs ww R₁ ww R₂ (P₁ and P2 are power…

A: Given, The circuit is, The ratio of resistors, R2R1=3.

Q: op-Amp circuit that produce output given by Vo= -(4√₁ + √₂ +0.11₂) if v₁ = 2 sin wt ; V₁₂ = 5V, and…

A: We need to design the given circuit and we need to draw output

Q: 4 Electric power is to be generated by installing a hydraulic turbine-generator at a site 70 m below…

A:

Q: gain H. W₁: For the circuit shown below, total (G₁) = 60 dB; A = 105, BW= 5KHZ; f₁ = 1MHZ ; Ri= 1 Mr…

A:

Q: la) Why are line codes used in communication? b) Draw the line code using all four digital formats…

A:

Q: The voltage across R₁ resistor in the circuit shown below is? V1 10 R1 60 www 29

A: Given =  R1= 60ΩR2= 40ΩV1= 10v

Q: A 200-watt, 120-volt light bulb uses O a. 0.6 amp Ob. 1.67 amps O c. 16.7 amps d. 24,000 amps

A: Given bulb rating, Power, P=200 watt. Voltage, V=120 V.

Q: Exo for the circuit shown below; if the input find the output voltage is a sinusoidal wave, wave…

A:

Q: Question 9 50 V 30 www SA Selected Answer: 60 Correct Answer: 60 150 ●0 If R 54 2, then the Thevnin…

A: Given data, R=54 Ω. Circuit diagram is given by,

Q: H.W3]: For the circuit shown below; find to? R₁ = 1K₁₂², R₁₂ = 2K₁2 R₂ = 3kr, Re=9kr Ans: Vo= 6v₁…

A: We need to find out the output voltage for given circuit

Q: A 100 ohm transmission line is terminated by a load impedance of 50 – j50 ohm. Calculate the…

A:

Q: Problem 3 Using a centre-tapped transformer, design a full-wave unregulated power supply delivering…

A:

Q: Q2. (i) A switch tail ring counter (Johnson counter) uses the complement of the serial output of a…

A:

Q: Q2. In a common base connection, IE = 1mA, IC = 0.95mA. Calculate the value of IB.

A: Given: In a BJT, Emitter current, IE=1 mA. Collector current, Ic=0.95 mA.

Q: Consider a causal second-order system with the transfer function G(s) = lim c(t), rounded off your…

A:

Q: Question No.3 A 10-μF capacitor in series with a 1-MQ resistor is connected across a 100-V DC…

A: Given a series RC circuit with, Supply voltage, V=100 V. Capacitance, C=10 μF. Resistance, R=1 MΩ.

Q: Obtain Vo in Fig. 3 using nodal analysis. 12/0° V Α 2Ω{V} j2 Ω 4Ω www -j4 Ω 0.2V,

A:

Q: The open-loop DC gain of a unity negative feedback system with closed loop transfer function (S+ 4)…

A: Given, Closed loop transfer function, CsRs=s+4s2+7s+13.

Q: Referring to figure shown below, determine the following: a. Total Resistance (R₁) b. Current Ix c.…

A:

Q: B- Find the F.T of f(t) = cos(w.t) f(x)

A:

Q: H.W3]: For the circuit shown below; find to? R₁=1KR, R₂ = 2K₁R R₂ = 3kr, R₁=9kr кл, AnsNo= 6v₁…

A:

Q: A coil has a resistance of 100 Ω and an inductance of 0.2 H. This coil is connected in series with a…

A:

Q: Draw the logic circuit represented by each expression: (c) AB+C

A: Given: Boolean expression, ⇒AB+C

Q: (a) Write the Boolean algebra expression for:

A: Given logic circuit,

Q: 4.) A single-phase transformer is rated 20 KVA, 480/240 volts, 60 Hz. The equivalent leakage…

A: Given: Single phase transformer is rated 20 KVA, 480/240 volts, 60 Hz. Required: per unit leakage…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.