The following figure shows the brine circulation in Multi-Stage Flash (MSF) desalination process. Describe in detail the different thermal processes that take place on the seawater starting from the intake until it is ejected as a brine blow-down. Explain why does feed seawater is mixed first at the brine pool of the last stage?

Q: 3. Seawater is being desalinated by evaporation. From seawater with salt content of 600 ppm, it is…

A:

Q: (D) For two PFRs in series where each PFR is 1.6 m^3, determine the conversion after each reactor.

A:

Q: Material Nylon Admer tie layer EVOH LDPE Oxygen Permeability+ (cm³ (STP) cm / cm²-s-atm) 2.89 x…

A:

Q: The mass density of a 20% by mass ethanol/water solution is 968.7 kg/m3 at 200C. Calculate the…

A:

Q: Q) A Calculate the volume of the CSTR w/ the following conditions. Q) B Calculate the time to reduce…

A:

Q: total molar flux of methanol, NA, and the mass average velocity

A:

Q: The decay of U-238 to Pb-206 can be used to estimate the age of inorganic matter. The half-life of…

A: To calculate the age of the rock using the decay of U-238 to Pb-206, you can use the concept of…

Q: Problem 1 (Kinetic Data Analysis). You are a summer intern at an industrial plant and are given…

A: Overall reaction is Time (hours)CA (mole/liter03.2011.8021..1030.8140.7150.5560.4470.4280.36

Q: U-238 atoms is 0.66. Assume all of the Pb-206 present is due to the decay of U-238. What is -kt the…

A:

Q: What factors influence the drag force experienced by a solid object immersed in a fluid,

A: Drag force significantly influences the behavior of solid objects immersed in fluids.It is the force…

Q: Three hundred kg/min of steam enters a steam turbine at 300°C and 80 bar through a 8.0-cm diameter…

A: In the turbine, in the inlet, the state of steam is the superheated state. The state of steam will…

Q: An equimolar liquid mixture of benzene (B) and toluene (T) is in equilibrium with its vapor at 30…

A:

Q: How about the relative error and percentage error of the volume?

A:

Q: What is the equation that defines fugacity? O None of the above GR P ln (RT) In GR RT Ope() GR RT)

A: fugacity in terms of Gibbs free energy we find equation or relation between them

Q: 7.52. Show that the friction heating in a hydraulic jump is given by = 8(Zz - Z₁)³ 42122 (7.67)

A: Friction heating is taken as the energy loss.

Q: 5) A test tube contains 10 cm of salt water having density 1.01 g/cm^3 and 10 cm of fresh water is…

A: To estimate the time it will take for the fluid in the test tube to reach nearly uniform salinity…

Q: Example 5:- During the batch drying test of a wet slab of material 0.35 m² and 7 mm thick, the…

A:

Q: An opaque horizontal plate is well insulated on the edges and the lower surface. The irradiation on…

A:

Q: Water is flowing at a depth of 2 ft and a velocity of 50 ft / s. It undergoes a hydraulic jump. What…

A: In hydraulic jump there is a rise of water level. Depth of water before jump, y1 = 2 ftvelocity of…

Q: The initial reaction rate for the elementary reaction 2A + B-4C

A:

Q: A stirred-tank blending system initially is full of water and is being fed pure water at a constant…

A: 1% Define the parameters 2V = 2; % Volume (m³) 3q = 0.4; % Flow rate (m³/min) 4Ci =…

Q: can youdo part d and e now

A: The reaction of stilbene (A) to produce trospophene (B) and methane (C) is an exothermic reaction…

Q: Ba What will be the power required to crush 150 tonnes per hour of Emestone if 80 percent of the…

A:

Q: Could you resolve the problem using the experimental data provided. How are the results different?…

A: Given, feed molar flow rate Water is more volatile component.Given, mole fraction of more volatile…

Q: A mixture of 70 mole % n-pentane and 30 mole % n-heptane is vaporized at 101.325 kPa (absolute)…

A: A mixture of two hydrocarbons is flashed vaporized.Schematic of the process is shown below:Here,1 =…

Q: Mark the correct shortcut vapor pressure equation from the following choices: - log₁0pșat = 3 (w +…

A: The vapor pressure of a substance at temperature (T) is equal to the pressure exerted by its vapors…

Q: The Joule coefficient, J, is defined as μ = ƏT ᎥᏙ U HjCv=p-aT/KT. Show that

A: To prove the relationship between the Joule coefficient (μJ​) and specific heat at constant volume…

Q: (b) Compute the pressure drop in this 4 cm long section of artery when it is constricted as seen in…

A:

Q: Describe how an efficient separation of anions can be achieved using capillary zone electrophoresis…

A: Capillary zone electrophoresis (CZE) and micellar electrokinetic chromatography (MEKC) are both…

Q: 1. The density of this fraction at 60 and 600 F.

A:

Q: Nitrogen from a gaseous phase is to be diffused into pure iron at 700°C. If the surface…

A:

Q: The tank in Fig. 3.7 has an inflow line with a cross-sectional area of 0.5 ft² and an outflow line…

A: To determine how many pounds-mass per second (lbm/s) of air are flowing through the vent and in…

Q: If you know that the moisture content Y=0.019, and the wet bulb temp. = 28 °C for dry air at 1 atm.…

A: Calculation:Dry bulb temperature:Using the psychrometric chart, we can find the dry bulb temperature…

Q: Two CSTRS (one 820 liters and the other 3200 liters) are combined in parallel with a 0.4 mol/sec…

A: Volume of CSTRs are 820 Litres and 3200 Litres.Feed flow rate = 0.4 mol/s Feed A spilts equally into…

Q: .* A nozzle is bolted onto a pipe by the flanged joint shë in Fig. 7.29. The flowing fluid is water.…

A:

Q: Calculate the pressure difference between points A and B 66.6 in Water 30.0 in 22.2 in 40.3 JJ in…

A: Assuming pressure at point A is PA and at point B is PB.We know specific gravity of water is 1 and…

Q: Hydrogen Sulfide has to be removed from a light refinery hydrocarbon stream before the gas is…

A: Given :The feed gas contains 4.0 mole% H2S.y

Q: If solar radiation intensity is 700 W/m² in NJ, how much solar energy arrives at a solar collector…

A:

Q: If 50% excess air it Supplied (miler air) ~ 1.5 (nuter air theoretical.

A:

Q: In April 2010, the worst oil spill ever recorded occurred when an explosion and fire on the…

A:

Q: A continuous stirred tank reactor is used to break down a chemical in an irreversible first-order…

A: a) To derive a dynamic model for the reactor, we need to start with the mass balance equation.The…

Q: Using the following parameters of the potential-current density equation (AFC = 0.08 V, BFC = 0.05…

A: The potential-current density equation for a PEMFC is given by:where:E0 is the thermodynamic cell…

Q: XA 0.0 mol -TA m³.sec 1 m³.sec -TA mol FAO (m³-sec) -TA mol 0.49 0.1 0.41 0.2 0.34 0.4 0.199…

A: Given, feed flow rate Tabulating data of XA and…

Q: Question 10 Pure butanol is to be fed into a semibatch reactor containing pure ethyl acetate to…

A:

Q: A heat engine receives 500 BTU of heat per cycle from a reservoir at 540oF and rejects heat to a…

A: A heat engine operates by receiving heat from a high-temperature reservoir (source) and partially…

Q: A heat exchanger uses 5000 kg/hr of water to cool hydrocarbon oil from 140oC to 65oC. The oil,…

A: In a heat exchanger, two fluids, namely hydrocarbon oil and water, are used to transfer heat between…

Q: Cp - Cv for (1) an ideal gas, and (2) for a van der Waals

A:

Q: An experiment designed to measure the size of air bubbles released in water is diagrammed below. Air…

A: Diameter of syringe = d Critical diameter = D D = 10dTerminal velocity = UUpward force on bubble = F…

Q: At 1100 ºC n-nonane (n-C9H20) thermally cracks (i.e. breaks  into smaller molecule fragments) 20…

A:

Q: Describe how can we estimate the coefficients in a Virial equation.

A: An equation of state of gases that has additional terms beyond that for an ideal gas, which…