The Bernoulli equation for steady frictionless incompressible flow along a streamline between two locations 1 and 1 1 P₁+ PV² + 821 = P2 + +22 Water flows without friction from the top of a tank of water open to the atmosphere along a streamline from location 1 to 2 at the bottom of the tank, where it discharges into the atmosphere. Atmosphere I Z 0 1 2 With the datum for elevation as shown, the Bernoulli equation reduces to 01 Oy z₁ = = 1 Y Z₂- ev 1 YZ₁ =P2 + O Y 2₁ = 1 PV2 + 22.

The Bernoulli equation for steady frictionless incompressible flow along a streamline between two locations 1 and 1 1 P₁+ PV² + 821 = P2 + +22 Water flows without friction from the top of a tank of water open to the atmosphere along a streamline from location 1 to 2 at the bottom of the tank, where it discharges into the atmosphere. Atmosphere I Z 0 1 2 With the datum for elevation as shown, the Bernoulli equation reduces to 01 Oy z₁ = = 1 Y Z₂- ev 1 YZ₁ =P2 + O Y 2₁ = 1 PV2 + 22.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The well-known Bernoulli equation is used to calculate the Bernoulli constant C in a flow, V² P P + +gz 2 where P is the pressure, p is the fluid density, Vis the magnitude of the velocity, g is the gravitational constant, and z is the elevation. In a water flow experiment (p = 1000. kg/m³), the following measurements are made: V = 15.0 +/- 0.15 m/s, and == 3.42 +/- 0.01 m P= 20.5 +/- 0.5 kPa, The gravitational constant is 9.81 m/s². Calculate the RSS uncertainty for the Bernoulli constant C, and write C in standard engineering notation (C = m²/s²). +/-
The pressure in a water tower is 27,030 Pascals (N / (m ^ 2)) higher than at an open faucet. The density of water is 1000Kg / (m ^ 3). Use Bernoulli's equation to determine the velocity of outflow from the open faucet. the height difference between the top water level in the tower and the faucet is 9 meters, then the velocity of outflow is
Water flow from a large tank (T1) through a pipe Pipe X which splits into two smaller pipes, which discharges and flow out freely on Pipe Y and Pipe Z on as shown on the figure below. • Diameter of Pipe W and Pipe X =50 mm • Diameter of Pipe Y = 30 mm • Diameter of Pipe Z = 20 mm The velocity in meter per second through Pipe X is Blank 1 m/s. ***EXPRESS YOUR ANSWER in TWO (2) DECIMAL PLACE and DO NOT PUT UNITS*** ... T-1 Pipe Y 7m 4m Pipe X Pipe W Pipe Z
In our country, using natural resources, it is desired to generate electricity by placing a turbine between two water sources. The tangential velocity to the impeller of this turbine is calculated by the formula u = kuLaTeX: \ sqrt {2gHo} 2gHo. Here; The tangential velocity coefficient can be taken as ku = 0.46 ± 0.02, the head which represents the net energy in the turbine as H0 = 650 ± 5% m and the gravitational acceleration as 9.81 m / s2. Find the tangential velocity and the percentage error at that velocity.
Complete Solution please, thanks. 3. A vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and 4.5 m at the top. Gas with a unit weight of 0.12 N per cubic meter enters the bottom of the tank with a uniform velocity of-assume values with decimals between 3 to 4 m per second- enters the stack. The unit weight increases by 7.5 percent every 2 meters. Find the velocity of flow at every 5 meters along the stack.
find Step 1: Known, UnknownStep 2: SchematicStep 3: FormulaStep 4: CalculationsStep 5: Discussion A 30 cm diameter pipe, conveying water, branches into two pipes of diameters20 cm and 15 cmrespectively. If the average velocity in the 30 cm diameter pipe is 2.5 m/s, find the discharge inthis pipe (m3/s). Also determine the velocity (m/s) in 15 cm pipe if the average velocity in 20cm diameter pipe is 2 m/s.
Sparky needs to design a device that accelerates air in order to keep some the inflatable eagle fully inflated for some university events. The velocity through the device (V) is linear (ax + b, where a and b are constants). Since the inflatable is used on top of the ski/tubing run at Snowflex the wind velocity entering the device at x1 of 0 (V1) is 10 m/sec. Sparky needs the velocity at the exit of the 1 m-long (x2) device to be 25 m/sec (V2). For force calculations Sparky needs to know the local acceleration, convective acceleration, and total acceleration at the device inlet (x1 = 0 m) and exit (x2 = 1 m). What are these values?
3. A circular cylinder of radius a is fitted with two pressure sensors to measure pressure at 0 = 180° and at 150°. The intent is to use this cylinder as a stream velocimeter, i.e. a device to determine the velocity of a stream by measuring the pressures at the two taps. The fluid is incompressible with a density of p. Figure for Part (a) U Figure for Part (b) 30 a) Using potential flow approximation, derive a formula for calculating U from the measured pressure difference at the two pressure taps. Note that for accurate measurement, the velocimeter must be aligned to have one of the taps exactly facing the stream as shown in the figure. (Ans: 2|Aptaps|/p ) b) Suppose the velocimeter has been misaligned by ổ degrees so that the two pressure taps are now at 180° + 8 and 150° + 8. Derive an expression for the percent error in stream velocity measurement. Then, calculate the error for 8 = 5°,10° and –10°. (Ans: [2/(sin2(150 + 8) – sin²(180 + 8) )– 1] × 100 )
For the tank system shown, there is a constant flow (1) (2) rate of Q into tank 1. Initially tank 1 is at the height of h0 while all other tanks are completely empty. (a) Draw a block diagram representation of the following system. (3) of
1) Consider the wave of small wave elevation in water of infinite depth. By linearization the water fluid flow can be described by velocity potential o which satisfy linear equations. i. For the wave described by: o ekz sin(kx – wt) and 3 = acos(kx – wt) show that: a. The potential energy in a wave length is Apga?/4. b. The kinetic energy in the wave length is Apga?/4 as well.
The velocity distribution in a 0.02 m diameter horizontal pipe conveying carbon tetrachloride (specific gravity = 1.59, absolute viscosity = 9.6 x 10-6 Pa sec) is given by the parabolic equation: v(r)=0.01(0.12- r?), where v(r) is the velocity in (m/s) at a distance r in (m) from the pipe center. What is discharge? O a. 3.13 x-8 m3/s O b. None of the mentioned O c. 1.047 x 108 m3/sec O d. 4.97 x 109 m3/sec
A venturi meter, shown in Fig. designed constriction whose pressure difference is a mea- sure of the flow rate in a pipe. Using Bernoulli's equation for steady incompressible flow with no losses, show that the flow rate Q is related to the manometer reading h by is a carefully 2gh(PM – p). A2 VT- (D/D;)4 where py is the density of the manometer fluid. 2