The airplane weighs 127050 lbs and flies at constant speed and trajectory given by = 12.8° on thefigure. The plane experiences a drag force of 56420 lbs. Determine the thrust and lift forces required tomaintain this speed and trajectory.FaragFthrustx'FliftFueightBY NC SA2013 Michael SwanbomThe lift force acts in the y' direction. The weight acts in the negative y direction. The thrust and dragforces act in the positive and negative z' directions respectively.lbsThe thrust force is equal tolbsThe lift force is equal to

The airplane weighs 127050 lbs and flies at constant speed and trajectory given by 0 = 12.8° on the figure. The plane experiences a drag force of 56420 lbs. Determine the thrust and lift forces required to maintain this speed and trajectory. Farag Fehrust x' Flift Fueight 2013 Michael Swanbom The lift force acts in the y' direction. The weight acts in the negative y direction. The thrust and drag forces act in the positive and negative z' directions respectively. lbs The thrust force is equal to lbs The lift force is equal to

The airplane weighs 127050 lbs and flies at constant speed and trajectory given by 0 = 12.8° on the figure. The plane experiences a drag force of 56420 lbs. Determine the thrust and lift forces required to maintain this speed and trajectory. Farag Fehrust x' Flift Fueight 2013 Michael Swanbom The lift force acts in the y' direction. The weight acts in the negative y direction. The thrust and drag forces act in the positive and negative z' directions respectively. lbs The thrust force is equal to lbs The lift force is equal to

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The large block shown is x = 72 cm wide, y = 54 cm long, V3 and z = 9.0 cm high. This block is passing through air (density of air p = 1.43 kg/m³) at a speed of v = 7.98 m/s. Find the drag force Fa1 acting on the block when it has the velocity v and a drag coefficient I = 0.902. レ X Fa1 = N V1 Find the drag force Fa2 acting on the block when it has the velocity v2 with a drag coefficient I = 0.992. Fa.2 = > TOOLS Find the X10 block when it has the velocity vz with a drag coefficient I = 1.17.
For a new sailboat, a designer wants to determine the drag force that may be expected at a given speed. To do so, she places a model of the proposed hull in a test channel and uses three cables to keep its bow on the center-line of the channel. Dynamometer readings indicate that for a given speed, the tension is 35 lb in cable AB and 40 lb in cable AE. The drag force is exerted in the direction of Flow at point A. –7 ft - B E1.5 ft 4 ft Flow A 4 ft E What is the magnitude of the drag force in Ib? What is the magnitude of the tension force in cable AC in Ib? What is the angle a in degrees measured CCW from the vertical? What is the angle B in degrees measured CW from the vertical?
Explain the mechanism of drag and lift force generation for the wing using Newton's law. Here are the hints : If the wing does not exist, the velocity distribution is uniform at v=U_inf. Therefore, the x-directional velocity of the air is deceralated by the wing. This implies that the wing applied a force in the -x-direction to the air (Newton's second law). In other words, the air flow applied a force in the x-direction to the wing (Newton's third law). This is the mechanism of drag generation.
The Air Force's new experimental jet, the X - 9001, is a perfectly flat, rectangular wing. It has a cruising speed of 100 m s¹. Determine the thrust force required to maintain that speed [36 N]. Neglect any frontal area or pressure drag. Drag occurs on both the top and bottom of the plate. The plane may be considered to be 1 m long and 1 m wide.
A lady on a bicycle is going down a hill. If the initial slope angle θ1 = 5 and she has a constant speed with no braking or pedaling, determine the drag force asserted on bicycle tires by the ground (Assume the total mass for her and the bicycle is 70 kg and neglect air resistance). Question 2 options: F=35.93 N F=0.0483g N F=59.85 N F=0.0523mg N Note:- • Do not provide handwritten solution. Maintain accuracy and quality in your answer. Take care of plagiarism. • Answer completely. • You will get up vote for sure.
For a new sailboat, a designer wants to determine the drag force that may be expected at a given speed. To do so, she places a model of the proposed hull in a test channel and uses three cables to keep its bow on the centerline of the channel. Dynamometer readings indicate that for a given speed, the tension is 40 lb in cable AB and 60 lb in cable AE. Determine the drag force exerted on the hull and the tension in cable AC.
A 1:8 scale tractor model is tested in a pressurized wind tunnel. The width, height and length of the model are 0.305 m; 0.476 m; and 2.48 m. In the test with a wind speed of 75 m/s, the drag force that occurs in the model is 128 N. Determine the aerodynamic drag and the power that the engine must give to the prototype tractor vehicle when running at a speed of 50 km/hour where the wind blows from the front of the tractor at a speed of 10 km/hour.
the weight of the trailer is 2130kg, the weight of the tow truck is 6000kg and the slope of the truck is 2% going on a ramp. The speed of 69km/h when first entering the ramp and 320m along the ramp, then 93km/h is the speed. (i) find the total average force on the wheels of the truck. (ii) calculate the average force between the truck and the trailer.
A wheel tractor has a 200HP engine.if it is operating at an altitute of 1000m above sea level, at an average temperature of 25 degree celcius, and at an average speed of 12km/hr. Calculate the available rimpull of this tractor. Take rimpull efficiency as 85%
pls send me answer of this question all the parts pls and i will rate you sure, pls solve a,b,c and d and also a and b A 200-kg dragster (racing car) exerts a constant force of 4000 N during a race. The coefficient of kinetic friction between the tires and the pavement is .15. If the drag strip is 1000 m long, determine:a. The net force on the dragster. b. The acceleration of the dragster. c. The time it takes for the dragster to finish the race.d. The dragster's velocity at the end of the race.The dragster now needs to slow down, so it opens a parachute. The force of air drag is 3500 N. The driver also locks the brakes of the dragster, and the coefficient of kinetic friction becomes .75. Determine:a. How long it will take to stop the dragster.b. The distance the dragster travels while stopping.
A stationary object in a flow of speed 27 m/s produces a drag force of 13 N. The flow speed is then changed to 25 m/s. What will be the drag force if the Drag Coefficient and density are assumed constant? Give your answer in Newtons to 2 decimal places.
Consider a conical pendulum with a mass m = 10 kg on a string of length L= 5 m. The angle it makes with the vertical is 4°. The pendulum is place on the surface of Mars. The velocity of the mass is given by v=Lgsin Otan ở What should be the length of the string if the pendulum has the same speed as the one on the Earth? Assume the angle is kept the same. ( 9mas=3.71 m/s 14 - O A) 1.9 m O B) 5 m O C) 13.2 m O D) 1.4 m O E) 3.6 m