The rectangular wing of a smal airplane has a chord length of 1.8 m and a wingspan of 10 m. When its flying at 350 km/h, the wing experiences a total aerodynamic force of 29.5 kN, if the ratio of lift to drag is 3.75:1 a) What is the drag coefficient of the wing? 1.- 0.010 2.- 0.074 3.- 0.044 4.- 0.098

The rectangular wing of a smal airplane has a chord length of 1.8 m and a wingspan of 10 m. When its flying at 350 km/h, the wing experiences a total aerodynamic force of 29.5 kN, if the ratio of lift to drag is 3.75:1 a) What is the drag coefficient of the wing? 1.- 0.010 2.- 0.074 3.- 0.044 4.- 0.098

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3) An advertising sign mounted on the roof of a car is 33 inches tall, 15 inches wide and 54 inches long (airflow direction). The underside of the sign is flush with the top surface of the roof. Take air properties to be: p = 0.075 lbm/ft' and u= 1.22x10 lbm/ft.sec. Used a pressure drag coefficient of 1.2 for the advertisement sign. Calculate the total drag on the sign and the power required to overcome its effect if the car is travelling at a constant speed of a) 12 mph and b) 45 mph. Note: Provide a schematic diagram (sketch) of the problem configuration (if applicable). Every numerical calculation must be preceded by the appropriate equation. Do not forget units & dimensions during your calculations.
The drag polar equation of a light airplane in clean configuration can be written as Cp = 0.358 + 0.0405 C₁². It has a weight of 18,681 N. The wing area is 14.41 m². Calculate the minimum power required in watts. (Round off answer with no decimal places, No units, No commas) Answer given: 1461792 A 5,000 lbs. aircraft has an excess power of 75 hp at sea level. If the service ceiling is 3,657.6 m, determine the time to climb from sea level to absolute ceiling in minutes. (Round off answer with no decimal places. No units, No commas) Answer given: 17
The rectangular wings of a microlight aircraft have a combined spanwise length of 9.144 m and streamwise (direction of air flow) width of 0.9144 m The wings have a coefficient of form drag of 0.01 and a lift coefficient of 0.3 in cruise. When cruising at a speed of 150km/h and altitude of 3,000 feet, the temperature and absolute pressure of the atmospheric air are 5ºC and 90 kPa, respectively. a) Calculate the density of the air at cruising altitude. b) Calculate the form drag on the wings. c) Calculate the Reynolds number of the wings. d) Calculate the skin friction drag on the wings. e) If the fuselage of the microlight is spherical with a diameter of 1m and the total drag of the aircraft is represented by the contributio combined, and assuming the skin friction drag is negligible for the fuselage only, calculate the combined total drag force. fuselage and wings f) Calculate the power required to overcome total drag in cruise, using the value calculated in part e). g) Calculate the…
A 3 inch diameter steel sphere achieve a terminal velocity of 122 inch per seconds when dropping through it all column of liquid is 87 lbm/ feet cube. The density of steel is 488 lbs per feet cube. The final drag coefficient of the square is most nearly? a. 0.22 b. 0.34 c. 0.40 d. 0.48
Qustion. An aircraft is flying in level flight at a speed of 200 km/h through air (density, p = 1.2 kg/m³, and viscosity, μ = 1.6 x 10-5 N-s/m²). The lift coefficient at this speed is 0.4 and the drag coefficient is 0.0065. The mass of the aircraft is 800 kg. The effective lift area of the aircraft NOTE= Do not give wrong answer I will dislike , If not sure skip it
8. A flat plate ( 1.5 m ) long and ( 1.5 m ) wide is towed in water ( p = 1000 kg/m and v=1.31 * 10 “ m² / s ) in the direction of its length at a speed of ( 20 cm / s ). %3D Determine; a) The skin frictional drag force on both sides of the plate. b) The boundary layer thickness at the end of the plate.
The rectangular wings of a microlight aircraft have a combined spanwise length of 9.144 m and streamwise (direction of air flow) width of 0.9144 m The wings have a coefficient of form drag of 0.01 and a lift coefficient of 0.3 in cruise. When cruising at a speed of 150km/h and altitude of 3,000 feet, the temperature and absolute pressure of the atmospheric air are 5°C and 90 kPa, respectively. a) Calculate the density of the air at cruising altitude. b) Calculate the form drag on the wings. c) Calculate the Reynolds number of the wings. d) Calculate the skin friction drag on the wings. e) If the fuselage of the microlight is spherical with a diameter of 1m and the total drag of the aircraft is represented by the contribution of fuselage and wings combined, and assuming the skin friction drag is negligible for the fuselage only, calculate the combined total drag force. f) Calculate the power required to overcome total drag in cruise, using the value calculated in part e). g) Calculate…
8.) A circular cylinder 4m long and 3m in diameter is in an air stream. The flow velocity is 5 m/s L parallel to the axis of the cylinder. Given that the coefficient of drag, CD on the cylinder is 1.3, and the density of air is 1.225 kg/m3. What is the force on the cylinder? A. 0.090 KN B. 0.14 KN C. 0.24 KN D. 0.91 kN
#1. Consider a Boeing 747-700 in straight-and-level cruise flight on a standard day. The aircraft has a wing area of 525 m and is flying geometric altitude of he = 10,000 m. At a certain time during the flight, its mass is 3.5 x 105 kg and each of the four engines produces 50 kN of thrust. C was calculated as 0.4. a) Determine the cruise airspeed. b) Determine the total drag coefficient.
Kindly give me both right solutions with clear calculations The drag polar of a glider is given by CD=0.01+0.022CL2 . If it is launched from a height of 400m in still air. Please determine:(a) the maximum lift to drag ratio ??;(b) the greatest possible ground distance it can cover.
(a) A luxury sports car has a frontal area of 23.1 ft and a 0.24 coefficient of drag at 80 mph. How much power must the engine produce just to overcome the air drag? (Express your answer using three significant figures.) P = hp (b) A sport-utility vehicle has Cp = 0.45 at 80 mph and a slightly larger frontal area of 28.3 ft. How much power must the engine produce just to overcome the air drag? (Express your answer using three significant figures.) P =[ hp
A new sports car has a drag corfficient of 0.30 and a frontal area of 18.5 ft<, and is traveling at 90 mi/h. How much power (in ft-lb/s) is required to overcome aerodynamic drag if air density is 0.002378 slugs/ft?