Tension only members B 4m 5m 5m 20kN C 5m D

Q: An open rectangular Bốx is to bê made from a 9 x 12 inch piece of tin by cutting a square of side x…

A:

Q: Line rods or range poles are made up of?

A: Range poles or ranging rods as they are sometimes called, is a surveying instrument that is used for…

Q: Define Dynamic viscosity.

A: DYNAMIC VISCOSITY:   Dynamic viscosity is the properly of fluid to resist the flow. Or to be more…

Q: Can you write the solution in a sheet of paper? Thank you!

A: As asked, solution is provided on a paper.

Q: With a neat sketch explain the constructional features of a crane fixed to a pillar and can be…

A: - Crane is a type of material handling and shifting powerful and heavy machine used with cables and…

Q: For 1.DU z The figure is made of a 4"radius half-circle inscribed in a 4" x 8"rectangle beside a 4"x…

A:

Q: Describe surface grinding operation.

A: To achieve a smooth appearance, surface grinding is performed on flat surfaces. Grinding is indeed a…

Q: Please give the figure with correct label

A: Given that total surface area of cylinder in square feet is equal to it's total volume in cubic…

Q: Which of the following is the largest scale? O 1cm:1mile O 1 mm:10m O. 1:1000 1cm:1km

A: to check largest or smallest scale firstly convert all numerator and denominator in same unit of all…

Q: Draw the picture of diesel hammer ? Explain how it works ?

A: Below is given the Diagram and Working of A Diesel Hammer.

Q: Out of all the Hard Flooring Finishing, which would be the most economical for a Public School…

A: Hard Flooring Finishing Hard flooring finishing refers to the materials and processes used to create…

Q: Environmental Effects of engineering constructions projects. Include photos.

A: Environmental engineering : Environmental engineering comprises the development of methods and…

Q: Explain concrete water tanks

A: Reinforced concrete water tanks are constructed for storing water. The design of reinforced concrete…

Q: What is structural deficiency?

A: The term structural deficiency indicates that there are elements of the structure that require to be…

Q: Discuss in detail Kennedy and Lacey Theory? Write down all the design steps.

A:

Q: What is the general range of L/G ratios?

A: L/G ratio stand for the liquid to gas ratio. which is the ratio of the waste slurry to the flue gas…

Q: What is the volume of this room in cubic feet?

A: Knowing the volume of a room is important when determining its heating and air conditioning needs.…

Q: Consider a glass with ice cubes. Sketch its plan, two elevations and a 3D image.

A: Glass with ice cubes- When a glass is filled with ice cubes, it can have many drawing shapes. All…

Q: What is LAP SPLICING? Illustrate a figure and explain it thoroughly

A: A lap is when two pieces of reinforcing bar (rebar) are overlapped to create a continuous line of…

Q: metallurgy slag is used in road construction to make roads better

A: Millions of tons of metallurgical slags are produced every year from several types of furnace during…

Q: What is the purpose of Recarbonation?

A: The process of adding carbon dioxide to lime-softened, clarified water in order to lower the pH and…

Q: Stability (one word): Blank 1 Determinacy (two-words); Blank 2 to the Blank 3 degree Blank 1 Blank 2…

A:

Q: What is layerd cake

A: Layered cake:

Q: What is Prebid?

A: A prebid is a meeting which generally happens before a bid. It is held to clear up any confusion…

Q: A roofer is working to cover a 2,500-square-foot roof. He must first install beams, then covering,…

A:

Q: 2. A grad of 1.5% intersects a grade of -2.5% at station 1+080 of elevation 68.94m. If the summit is…

A: Solution-The given values are as follows  The grade g1=1.5%The grade g2=-2.5%Station…

Q: Where does the supply number of 15 come from

A: Query is about the value of supply of concrete

Q: The information shown in this attached document. This has been extracted from the Expert Panel…

A: The order of construction in civil projects can vary depending on the specific project and its…

Q: A 3m square tank contains water to a depth of 5m. A 1.50m cubical block of wood (0.78) is made to…

A: Size of square tank is 3 m Size of cubical wooden block is 1.5 m

Q: (b) Design the Beam B-B for the maximum sagging section only. Your design should consider the…

A: L=4.55 mh=22.2 mt=122 mmDL=3.55 kPaLL= 4.55 kPafck= 25.5 Mpafy=472 MpaTo design- 1) Loads2) Design…

Q: lo" A 992 steel 14" -2" what is Mp= ? 14"

A: From the given data calculate all areas find the y bar find the Ix

Q: 6.2 THE FOLLOWING PROVISIONS IN A CONSTRUCTION CONTRACT ARE UNENFORCEABLE: CHECK ALL CORRECT…

A: UNENFORCEABLE  means the clause in a contract that cannot be legally upheld by lawIt means if one…

Q: What is the total weight of steel reinforcing mesh, 6 x 6 10/10 that is used for a concrete slab…

A: Steel reinforcing mesh, 6x6-10/10 Area=12750 square feet

Q: discuss in deep ( Detailed explanation***)  the ways/ techniques to protect concrete, steel and…

A: The exterior protection of concrete building elements is required to safeguard the construction from…

Q: Define the size of a concrete cube?

A: Cube test of concrete is one of the most important tests done on concrete. It is also known as a…

Q: Using one 3-foot by 8-foot piece of sheet metal, an installer makes four 6-inchcircular ducts. Each…

A: Ducts act as a passage for inlet and outlet for air from AC, emission of smoke and heat from…

Q: How does carburizing work?

A: Introduction- Carburization- A low carbon steel is converted into a high carbon steel by the process…

Q: Discuss  in  details coagulation

A: Coagulation is defined as the process of converting smaller dissolved solids into larger particles…

Q: Explain briefly the material selection criteria and the materials which are used to manufacture 1.…

A: Material selection criteria : An efficient material selection criteria satisfies  efficient…

Dimensional homogeneity

The term dimensional homogeneity means that in an equation, the dimensions of each term on both sides are equal, which means the dimensions of the left-hand side (LHS) of an equation are similar to the dimensions of the right-hand side (RHS). For a dimensionally homogeneous equation, the powers of fundamental dimensions will be identical on both sides of the equation.