Steam is the working fluid in the ideal Rankine cycle 1–2–3–4–1 and in the Carnot cycle 1–2–3’–4’–1 that both operate between pressures of 1.5 bar and 60 bar as shown in the T–s diagram in Fig. below. Both cycles incorporate the steady flow devices shown in Fig. For each cycle determine (a) the net power developed per unit mass of steam flowing, in kJ/kg, and (b) the thermal efficiency. Compare results and comment. p (bar) h (kJ/kg)v (m/kg)State1602784.3p= 60 bar1.52180.60.76963'1.51079.80.27521.5467.110.0010528p= 1.5 bar460473.274601213.4 HW3: Steam is the working fluid in the ideal Rankine cycle 1–2–3–4–1 and in the Carnot cycle1-2–3'-4'-1 that both operate between pressures of 1.5 bar and 60 bar as shown in the T-sdiagram in Fig. below. Both cycles incorporate the steady flow devices shown in Fig. For eachcycle determine (a) the net power developed per unit mass of steam flowing, in kJ/kg, and (b) thethermal efficiency. Compare results and comment.

Given data To finda) Wnetb) nthermal

Steam is the working fluid in the ideal Rankine cycle 1–2–3–4–1 and in the Carnot cycle 1–2–3’–4’–1 that both operate between pressures of 1.5 bar and 60 bar as shown in the T–s diagram in Fig. below. Both cycles incorporate the steady flow devices shown in Fig. For each cycle determine (a) the net power developed per unit mass of steam flowing, in kJ/kg, and (b) the thermal efficiency. Compare results and comment.

Steam is the working fluid in the ideal Rankine cycle 1–2–3–4–1 and in the Carnot cycle 1–2–3’–4’–1 that both operate between pressures of 1.5 bar and 60 bar as shown in the T–s diagram in Fig. below. Both cycles incorporate the steady flow devices shown in Fig. For each cycle determine (a) the net power developed per unit mass of steam flowing, in kJ/kg, and (b) the thermal efficiency. Compare results and comment.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.22P: 1.22 In order to prevent frostbite to skiers on chair lifts, the weather report at most ski areas...

See similar textbooks

Similar questions

2. A tank initially holds 100 gal of a brine solution containing 20 lb of salt. At t = 0, fresh water is poured into the tank at the rate of 5 gal/min, while the well-stirred mixture leaves the tank at the same rate. Find the amount of salt x in the tank (in lbs) at any time t (in minutes). A) x = 20e 20 В) х%3D 20е 10 С) х%3D 20е D) x= 20e
1. The following data (integral molar volume) are given for A-B solutions: 0 0.1 0.2 XA V (cm/mole) 10.0 11.1 12.0 12.7 13.2 13.5 13.6 a) What is volume change of the system when 2 moles of A and 3 moles of B are mixed to form a solution? b) What is volume change of the system when 1 mole of A is added to 4 moles of solution with XẠ = 0.5 initial composition? 0.3 0.4 0.5 0.6 0.7 0.8 0.9 13.5 13.2 12.7 12.0
A gas in piston cylinder assembly undergoes an expansion process for which the relation between the pressure and the volume is given by : PVn = Constant If the initial pressure is equal to 6 bar, the initial volume is equal to 0.1 m3 and the final volume is equal to 0.2 m3. Determine the work if n = 0. Answer 1 Determine the work if n = 1 Answer 2 Choose... 70) 15.8 J 60 kJ 580.9 J 41.6 kJ 250 kJ Choose... Choose... Invite to a call 8
A silver cube with an edge length of 2.24 cm and a gold Substance Specific heat (J/g.°C) Density (g/cm³) cube with an edge length of 2.63 cm are both heated to gold 0.1256 19.3 84.8 °C and placed in 115.0 mL of water at 20.5 °C . silver 0.2386 10.5 What is the final temperature of the water when thermal water 4.184 1.00 equilibrium is reached? Tinal
If 5.6 m³ of oil weighs 46800 N, what is the mass density in kg/m3. Select one: 851.9 8357.1 860.9 8457.1
1) A piston-cylinder system containing 1100 grams of an ideal gas ‘X’ is cooled from 900 K to 100 K at constant pressure. The specific heat capacity of the gas is Cp = 38.3 J.mol-1.K-1. Assume Cp stays constant in the given temperature range. The molar mass of the gas = 28 g.mol-1. a) Write the simplified first law of thermodynamics for this system with justification. b) Calculate the total heat transferred (in kJ) during the process of cooling c) If the entire heat from the cooling of ‘X’ (as calculated in (b)) could be used as work to change the volume of another gas ‘Y’ from 500 m3 to 1000 m3 in a constant pressure process, calculate the value of pressure. d) Instead of cooling at constant pressure, if ‘X’ was expanded reversibly and at a constant temperature (300K), calculate the work done by the system in kJ if the change in volume was 10-fold.
1. In general, the internal energy U depends on both temperature and volume, U=U(TV). The volume dependence comes from the potential energy due to the interactions among the particles. For free particles, there are no interactions, thus, the internal energy U should be independent of the volume, i.e., = 0. Verify this result for ideal gas pV = RT. au av
Q1. The following data is obtained during geothermal drilling operation. Rock density = 1550 kg/m ³, heat capacity of the rock = 0.00163 J/kg K, temperature difference = 80 K. How much will be the thermal heat content of the rock at the geothermal site? Discuss about geothermal gradients their importance in energy exploration. Do you think utilization of geothermal energy worldwide is increasing yearly? Justify your answer. Do you think the geothermal energy available in this site can be used for a metal melting industry?
۳۸% ۱۰:۲۱ ص docs.google.com/forms 10 نقاط Resolve the 300 N into two components at the u and v axis 300N 20 70° Fu = 109.1 N, Fv= 244.5 N O Fu = 300.2 N, Fv= 217.5 N O Fu = 154.1 N, Fv= 219.3 N O Fu = 203.2 N, Fv= 267.7 N O
For an ideal gas if the specific internal energy at a specific pressure and temperature of 20 C is u=201.2 kJ/kg, what is the specific internal energy if the pressure is doubled while the temperature stays the same. Select one: O a 100.60 O b. 201.20 C. 603.60 d. 301.80 e. 402.40
30. A cylinder contains an amount of gas. At pressure of 470 kPa and at temperature of 27 ̊C, thegas occupies a volume of 0.03 m3. It is then compressed according to Boyle’s law until its pressureis 1.3 MPa, and then expanded according to Charles’ Law until its volume is 0.02 m3. Calculate thefinal temperature of the gas. a. 292.35000C b. 248.85000C c. 216.22500C d. 280.31810C
t K P (KPa) Y (%) h (KJ/kg) U (KJ/kg) S (KJ/kgK) Vx103 State m/kg 380 2013.2 353 70 300 859.6 613 518.7