PLEASE SHOW YOUR SOLUTION THANK U Steam is generated at 4.0 MPa and 440°C and condensationoccurs at 0.15 MPa.(a) Considering that Ideal Rankine cycle occurs between theselimits, determine Q,, Qp, W and n.:(b) What mass flow rate is required for a net output of 30, 000kW?

Answered: Image /qna-images/answer/f20c1b78-c481-4e4e-810e-580e77901e1a.jpg

Answered: Steam is generated at 4.0 MPa and 440°C…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Steam is generated at 4.10 Mpa and 440°C and condensation occurs at 0.105 MPa a. For a Rankine engine operating between these limits, computethe thermal efficiency and the heat rate b. Considering that a Rankine cycle occurs between same limits, determine QA, QR, Wnet and eth c. What mass flow rate is required for a net output of 30 000 kW Don't answer the given problem, just give me the schematic diagram and t-s diagram of the given problem
Steam is generated at 10 MPa and 450OC and condensation occurs at 170 kPa. (a)For a Rankine engine operating between these limits, compute the thermal efficiency and the heat rate. (b) Considering that a Rankine cycle occurs between the limits, determine QA, QR, WNet, and eC. (c)What mass flow rate is required for a net output of 35 MW?
A (1.5 kg/s) of water vapor inters a condenser at (20 kPa and 60°C), and exit with (h= 251.5 kJ/kg). Find: a) The mass flow rate of water flow at the exit sections b) The rate of heat removed from the water in the condenser From table T=90C & P=70 kPah=2660 kJ/kg
A turbine receives steam at 8.5 MPa, 400°Cwith condensing pressure of 0.06 MPa. Determine the Cycle Efficiency. Attach your T-S diagram on your solution (A) 31.29 (в) 32.29 33.29 D) 34.29
Superheated steam at 18 MPa, 560 °C enters the steam turbine. The pressure at the exit of the turbine is 0.06 MPa and saturated liquid water leaves the condenser at 0.06 MPa. Pressure is increased to 18 MPa again after the pump. Find: (a) Sketch the process on a T-s diagram. (b) The net work per unit of steam flow in kJ/kg. (c) Heat transfer to steam passing through the boiler, in kJ/kg.
Problem (8.2) A steam turbine develops 3000kW when the steam is supplied at 10 bar and 250°C. The vacuum in the condenser is maintained at 65 cm of Hg. The barometric reads 75.2 cm of Hg. The rise in temperature of cooling water is limited to 15°C. The temperature of the condensate coming out of condenser is 35°C. Find, (a) specific steam consumption of the plant, and (b) quantity of cooling water circulated through the condenser per hour. Assume there is no leakage in the condenser. Ans.[(a) 4.8 kg/kW.h, (b) 447 tons/h]
3.) An ammonia compressor operates at evaporator pressure of 316.02 kPa and a condenser pressure of 1557 kPa. A twin-cylinder compressor with bore to stroke ratio of 0.85 is to used at 1200 rpm. The actual volumetric efficiency is 92% and compression and mechanical efficiency is 78% and 80% respectively. For a cooling capacity of 25 TR, (a) the sketch the p-h diagram labeling the evaporating and condensing temperature and pressures (b) define the all properties of ammonia taken from saturation table. Determine (c) the quantity of cooling water in the condenser in kg/min if the increase in temperature is 8°C, (d) the bore and stroke expressed in cm and (e) the size of the driving motor in hp. Given: h2 = h at 1557 kPa and s2 = s1 1695 kJ/kg
Air is cooled and dehumidified at constant pressure as shown in the figure below. Heat removed by the cooling coil is 130kW. Find air mass flow rate, air volumetric flow rate, condensation flow rate and sketch al states in a psychrometric diagram . Use AirH20 as the working fluid PLEASE NOTE: T2 has a typo, it should be 16.7 degrees Centigrade, not 16.7 degrees Fahrenheit, and all temperatures should be in Centigrade
In a marine gas turbine unit, a high-pressure stage turbine drives the compressor and a low-pressure stage turbine drives the propeller through suitable gearing. The overall pressure ratio is 4/1 and the maximum temperature is 650 o the isentropic efficiencies of the compressor, H. P. turbine, L. P. turbine are 0.8, 0.83 and 0.85 respectively and the mechanical efficiency of both shafts is 98 %. Sketch the process on the T-s diagram i. Calculate the pressure between turbine stages when the air intake conditions are 1.01 bar and 25 oC. ii. Calculate also the thermal efficiency and the shaft power when the mass flow is 60 kg/s. NB: Neglect kinetic energy changes and the pressure loss in combustion.
A reheater cycle is executed of 1 kg steam expanding initially from 12.547 Mpa and540.547 oC. The reheater pressures are 2.5547 Mpa and the steam leaves the reheaterat 420.547 oC. Condensation occurs at 0.02547 Mpa. Calculate W, ec and ee.
4. The condensing pressure for a Rankıne engine Is I Calculate the net work for 1 kg of steam and the thermal efficiency when the steam at the beginning of expansion is at 50 bar and (a) saturated, (b) 350°C, and (c) 640°C. Ans. (a) 627.2 kJ/kg, 26.4%; (b) 727.3 kJ/kg, 27.5%; (c) 1079.49 kJ/kg, 32.35% ot 2 15 MPà
Saturated steam at 40∘C is to be cooled to saturated liquid in a condenser. The mass flow rate of the steam is 17.3 kg/s . Assume no pressure loss. a)Determine the rate of heat transfer. Q = ? MW

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

Steam is generated at 4.0 MPa and 440°C and condensation occurs at 0.15 MPa. (a) Considering that Ideal Rankine cycle occurs between these limits, determine Q, Q, W and n.. (b) What mass flow rate is required for a net output of 30, 000 kW?