Specimen No. 3 w/c Ratio 0.4 0.6 0.8 Deformation (mm) Load (kN) 0.3 514 348 244 0.6 853 (failure) 472 304 0.9 433 (failure) 263 1.2 235 (failure)
Three 150 mm * 300 mm concrete cylinders with water to cement ratios of 0.4, 0.6, and 0.8, respectively. After curing for 28 days, the specimens were subjected to increments of compressive loads until failure. The load versus deformation results were as shown in Table .Assuming that the gauge length is the whole specimen height, it is required to do the following:
a. The compressive stresses and strains for each specimen at each load increment.
b. Plot stresses versus strains for all specimens on one graph.
c. The ultimate strength for each specimen.
d. The modulus of elasticity as the secant modulus at 40% of the ultimate stress for each specimen. e. The strain at failure for each specimen.
f. The toughness for each specimen.
g. Comment on the effect of increasing the water–cement ratio on the following:
i. Ultimate strength
ii. Modulus of elasticity
iii. Ductility
iv. Toughness. Curves may be approximated with a series of straight lines.
Trending now
This is a popular solution!
Step by step
Solved in 5 steps with 4 images
