Since Vcc = 12 V, Vin = 690 mV, RB = 780 kΩ, RC1 = 27.9 Ω, RC2 = 25.4 Ω, RE = 470 Ω, RL = 47 Ω and β1 = β2 = 100 in the circuit in the figure Find the current (IL) flowing through RL? NOTE-1: VBE1 = VBE2 = 0.7 V will be taken. NOTE-2: Output impedances of transistors (r0) will be neglected.

Q: QUESTION 1 Assume Vcc = 15 V, ß =150, V3e = 0.7 V, RE = 1 k2, Rc = 4.7 kQ, R1 = 47 k2, R2 = 10 k2,…

A:

Q: VGSQ = 7 V, C1 = 64 nF and C2 = 33 nF in the circuit in the figure, what is the low cut-off…

A:

Q: Vcc = 10 V B = 200 Rc =2 k2 + RB = 220 k2 VBB = 4 Vo- VCE + IB VBE

A: Given: Consider the following circuit: To find: Load line intersection.

Q: A piezoelectric system having 500mV output for pressure measurement, design an inverting amplifier…

A: Solution: According to the given condition, the circuit diagram is, Gain=VoutVin=2500×10-3=4…

Q: H.W.t,;- For the civcuit shown, calcubeke Ave, Rips mel Rof &what is the feedback topology- Vec Vo…

A: Voltage gain, input impedance and output impedance of the above circuit can be calculated from small…

Q: Q3 Refer to Figure Q3. Given the amplifier parameters: IcQ=3 mA, B = 150, V₁ = 26 mV, and VA = 00.…

A:

Q: For the circuit in the figure, find the ones requested in the questions by using the following…

A:

Q: For the amplifier in the figure below, the circuit parameters are: Vcc = 15 V, VEE = 15 V, VA3 = 75…

A:

Q: QUESTIONS (a) Figure Q.1 (a) represents a common emitter amplifier. Given ß-100, VON-0.7V, Vaq-1.7…

A:

Q: For the circuit shown below, calculate: - 1. The input impedances (Z;), (Zif). 2. the loaded output…

A: First we will do dc analysis to calculate transconductance then we will find out gain and input and…

Q: Q-4: A- Calculate the common-mode output voltage and A, voltage gain for the circuit below, where V…

A:

Q: Q3 Refer to Figure Q3. Given the amplifier parameters: IcQ=3 mA, B = 150, V₁ = 26 mV, and VA = 00.…

A: For the above given question we need draw hybrid π model of the given common collector amplifier.

Q: Refer to the Figure below. VDD RD C₁ V₁oH Z₁ Compute for kohms ZO- if VDD-20V, RG-181Mohms, RD-2.3…

A: Brief description: For the given common source amplifier we need to calculate its output impedance.

Q: QI:- For the multistage amplifier of figure (1), assume rel 6.1 2 and rel 12.84 2, hrel hre2 = 0,…

A:

Q: 10 V Va -10 V Vb The difference amplifier is shown in (Figure 1). Suppose Ra = 1 k2, R = 50 k2, Re =…

A: Using Superposition theorem, the value of the output of the differential amplifier circuit can be…

Q: Q1) For the circuit, exactly find:- VCEQ and ICa respectively are equal? At ICQ [IC(sat)]/2, so VEE…

A:

Q: Voc= +20V R, B=100 Please analyze the circuit and determine the voltage gain of both (Av,dc = Vc/Vb…

A: We will perform  dc and ac analysis , we wil find out ac parameters.

Q: Q \ In the circuit shown in determine VC, IC, IB, if B=50.

A:

Q: A- Calculate the common-mode output voltage and Ac voltage gain for the circuit below, where V; =…

A:

Q: Vec +10V Ist stage 2nd stage 47 kn 4.7 kn I uF Vo- C. 100 F 10 kn LOKA T100 F 10 kn 10 k Boc =B- 150…

A: Plot of gain vs frequency

Q: Voc= +20V B=100 Please analyze the circuit and determine the voltage gain of both (Av,dc = Vc/vb for…

A: We will do DC analysis and AC analysis for given circuit , we will find out DC current then ac…

Q: Question 2: Common Collector/Emitter follower For the amplifier circuit below, the transistor…

A:

Q: Given the multistage cascaded amplifier system below. L2 A2 P. P L1 P; = 35 mW, L, = 7.1 ft., L2 =…

A: The solution is given below

Q: Figure 1 shows a well-known circuit configuration with the bypassed source resistor using an…

A:

Q: For the circuit given below, and find the formulas for: Vout a. Output voltage gain, which is…

A: for our policy, i can solve first three parts

Q: The target output impedance value for the degenerated current source circuit with MOSFET is Rout=…

A: We need to calculate Rs , we will calculate it by putting all other value in given Ro formula .

Q: Problem 5. For the cascaded system below with two identical stages, determine: (d) How Zo is…

A: We need to find out output impedance and phase shift between input and output.

Q: e circuit shown in figure beside, find the total ave ?delivered to

A:

Q: 0.1 For the circuit shown, calculate the Av and RE that required to get 5KHZ lower critical…

A:

Q: For the amplifier circuit given in figure below with Rr (Rc = 2.7 k2, REI = 0.4 k2, RE2 = 0.6 k2, Cy…

A:

Q: the input and output impedances : amplifier configuration in Figure below is Al = 175,000 Zin = 10…

A:

Q: Q1) For the circuit, exactly find:- VCEQ and ICQ respectively are equal? At ICQ = [IC(sat)]/2, so…

A:

Q: Q2. Given the circuit configuration below, Vcc=VEE=6V, R = 2kn Rc = 6kn, Re = 5kn, Rb = 0, Rw = 2002…

A: The circuit is given as Diffential voltage gainAd=α2R+RC2re+RW2

Q: Q1: For the circuit shown in figure. Derive the stability factors S(Ico), S(VBE) and S(B). RB www…

A: For the given circuit calculation of Stability factor expression. SICo=∂IC∂ICoSVBE=∂IC∂VBESβ=∂IC∂β

Q: J ror sy stein is given by K(s + 2) G(s) =+7) For K > 6, che scability characteristic of the…

A:

Q: b) An input voltage source Vs of 130mV RMS and an internal resistance Rs of 100 is connected to an…

A:

Q: For the amplifier network shown in the figure, neglect the le 012 sin(2m*1000t-180°) Ob8…

A: We need to find out the output voltage for given circuit

Q: is P Vo P 0.8 pf lagging 0.9 pf lagging ?For the circuit shown above, what is the input power factor…

A: Power factor- It is the ratio of the total power and the utilized power which means it indicate that…

Q: Lhat the T00, and the vCE n ngui collector current. Şekildeki devre için VBE =710 mV, B = 100 ve VA…

A:

Q: 1. Given a circuit in figure 1.1 where an amplifier model is proposed courant source with values…

A:

Q: Q1) For the circuit, exactly find:- VCEQ and ICQ respectively are equal? At ICQ = [IC(sat)]/2, so…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: 3) With reference to the switching conditions given below develop an appropriate circuitry that can…

A: Introduction: Diode converters AC (Alternating current) supply in DC (Direct current) supply. This…

Q: Consider the following step up converter with a resistive load of value RS ohms. it is supplied by a…

A:

Q: Q1. Find the input impedance Zn(S) of each of the circuit in Figure Q1.

A:

Q: Voc=-20V B=100 Please analyze the circuit and determine the voltage gain of both (Av,dc = Vc/Vb for…

A: We need to do DC analysis and AC analysis to find out gain and input impedance ànd output impedance.

Q: Perform the following steps for the given circuit in below. a) Find the Vo, if the Vs = 120mV_peak,…

A: ID = IDSS 1-VGSVp2 ID = 121-1.1ID42 ID = 12164-1.1ID2 I =0.75(16-8.8ID+1.21ID2) ID…

Q: Design a transistor amplifier to supply a LED. The LED is required to turn on and off following the…

A:

Q: Given a feedback uniy GCs) = k(s+4) Cs+x) (S-1) (s-8) find out following: ystem cwith %3D i) Sketah…

A: " Since you have posted a question with multiple subparts, we will solve the first three subparts…