Ross and Rachel are fighting if they were on a break. Ross is trying to get his stuff weighing 150. N placed on an inclined plane by pulling it upwards parallel to the inclined plane with 150. N force. However, Rachel is trying to stop Ross by exerting 50.0 N perpendicular to the inclined plane. The coefficients of friction between the box and the incline are us = 0.450 and uk = 0.350.

Ross and Rachel are fighting if they were on a break. Ross is trying to get his stuff weighing 150. N placed on an inclined plane by pulling it upwards parallel to the inclined plane with 150. N force. However, Rachel is trying to stop Ross by exerting 50.0 N perpendicular to the inclined plane. The coefficients of friction between the box and the incline are us = 0.450 and uk = 0.350.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Ross and Rachel are fighting if they were on a break. Ross is trying to get his stuff weighing 150. N placed on an inclined plane by pulling it upwards parallel to the inclined plane with 150. N force. However, Rachel is trying to stop Ross by exerting 50.0 N perpendicular to the inclined plane. The coefficients of friction between the box and the incline are us= 0.450 and = 0.350. Which of the following shows the most ideal force diagram for the object? A. C. 30⁰ 30* 50 N W 50 N 150 N 180 N B. D. 30⁰ 30⁰ 50 N FRIENDS 50 N 50 N 150 N 150 N 150 N
In order to burgle a local McDonald's, the Hamburglar must climb onto the roof. To do this, a ladder of length 3.31 m and mass 21.2 kg is placed leaning against a vertical wall, as shown in the image below. There is negligible friction between the ladder and the wall, but the same is not true for the ladder and the ground: us ≠ 0 between those two surfaces. Even with that friction, the ladder will start slipping if the angle ø ladder makes relative to the ground is less than 71.0°. Assuming the ladder is uniform (so that its center of gravity is located at its geometric center), what must be the maximum static frictional force (in N) that exists between the bottom of the ladder and the ground? Explain how you solved the problem involving a ladder leaning against a wall. Be sure to state what your known and unknown quantities are, what concepts were applied, and what equations were used!
2. The 100 – Ib force acts as shown on a 300 - Ib block placed on an inclined plane. The coefficients of friction between the block and the plane are us = 0.25 and Hk = 0.20. Determine whether the block is in equilibrium, and find the value of the friction for the friction force. 300 Ib 100 lb
A 150 lb man can climb up15 ft on a 20 ft ladder before it slips. What must the coefficient of friction be if the ladder is arranged so that its base makes an angle of 50 ̊ with the ground? Assume the ladder to be uniform and weighing 100 lb.
A 150-lb man stands on a 60-lb bar to which a cable is fixed at point B. The cable passes over two fixed pegs with coefficients of friction as indicated. You may treat the cable the same as you would treat a flexible flat belt. Assume the normal force exerted by the man on the bar to be downward through point A. Find the smallest force the man can exert on the cable if the bar is to remain horizontal. -02 10 ft 2 ft Technals Draen by lenentie
A 250 lb refrigerator is being pushed. You do not know what force P should be applied. The coefficient of static friction between the refrigerator and floor is point G. 0.4. The center of gravity of the refrigerator is at = d2 ++ d2 → F1 d3 d1 d4 Values for the figure are given in the following table. Note the figure may not be to scale. Variable Value di 4.5 ft d2 1.5 ft d3 2.5 da 3.5 a. Determine the force P that is needed to overcome friction. b. Determine the location of the normal force x measured from the center of the refrigerator if the force P from part a is applied. c. Determine the minimum force P that is required to tip the refrigerator. d. Will the refrigerator slip or tip first? Round your final answers to 3 significant digits/figures.
A 250 lb refrigerator is being pushed. You do not know what force P should be applied. The coefficient of static friction between the refrigerator and floor is lg = 0.4. The center of gravity of the refrigerator is at point G. - d2 -- d2 F1 d3 d1 d4 Values for the figure are given in the following table. Note the figure may not be to scale. Variable Value di 4.5 ft d2 1.5 ft d3 2.5 d4 3.5 a. Determine the force P that is needed to overcome friction. b. Determine the location of the normal force r measured from the center of the refrigerator if the force P from part a is applied. c. Determine the minimum force P that is required to tip the refrigerator. d. Will the refrigerator slip or tip first? Round your final answers to 3 significant digits/figures. P= lb ft Pip = lb Will the refrigerator slip or tip first? tip O slip
Your physics book is resting in front of you on a horizontal table in the campus library. You push the book over to your friend, who is seated at the other side of the table, 0.400 m north and 0.300 m east of you. If you push the book in a straight line to your friend, friction does -4.8 J of work on the book. If instead you push the book 0.400 m due north and then 0.300 m due east, how much work is done by friction?
A 100-lb force acts as shown on a 300-lb crate placed on an inclined plane. The coefficients of friction between the crate and the plane are u. = 0.25 and Hk = 0.20. 300 lb Determine whether the crate is in equilibrium, and find the value of the friction force. 100 Ib 4
A 70 pound object needs to be lifted vertically one foot. You Have a 2-inch diameter piston actuator with a 12-inch stroke connected to a 50 psi source of pressurized air. The mass is restricted by a set of guide rails, which limit it's vertical motion, and which uses roller bearings with a friction coefficient of 0.002. Can the object be lifted? How long will it take? O yes, 0.24 seconds O yes, 0.73 seconds O yes, 0.12 seconds no
A weight of 10 N resting on an inclined plane at 30° to the horizontal is connected by a string passing over a frictionless pulley at the upper end of the inclined plane. The free end of the string is connected to a weight of 20 N which hangs in air. If the coefficient of friction of the inclined surface is 0.2, calculate the time taken by the hanging weight to decend by 1 m. (1) VON u=0.2 (2) 30° 20N Given diagram Fig s=1m
A 1130-kg car is held in place by a light cable on a very smooth (frictionless) ramp as shown below. The cable makes an angle of 31.0° above the surface of the ramp, and the ramp is itself raised by 25.0° above the horizonal. a. Find the tension in the cable. b. How hard does the surface of the ramp push on the car? 31.0° 25.0° 02016 Pearson Education, Inc. Cable