If the maximum energy stored in the coil is 3mJ, what is the value of the resitance in the figure? 480 270 210 850 O 8 = 36.0 V www 100.0 Ω L = 75.0 mH R www elle

Q: A selected structural douglas fir-Larch 4*16 beam on a 20ft span support a hoist located at the…

A:

Q: 2.) 34 ៩ IN 852 31052 DIA 2A 16 852 742 √₂ 1252 Det hade equations Find hode voltages by Gauss-…

A:

Q: ele S ww www www ell Ly Pa

A:

Q: R(s) G₁ te: either move G2 or G3. H₁ G₂ H3 G3 H₂ GA C(s) ...

A:

Q: Solve for the transfer function, G₂ (s) c (t) = 3 (1+2e-²t); r(t) = 2 = C(s) R(s) if:

A:

Q: For the given circuit, find vo(t) when (0) = 5 A and v(t) = 0 V. 252 v(t) i(t) 0.4 H m 3Ω + y (t)…

A:

Q: A 1 km long microwave link uses two antennas each having 30 dB gain. If the power transmitted by one…

A:

Q: Obtain the carrier power and the total power of the sidebands for each of the following cases: i)…

A: In modulation the characteristics of carrier signal varies according to message signal. The low…

Q: Communication systms A carrier is frequency modulated by a sinusoidal signal f(t). The modulation…

A: Given, A carrier is frequency modulated by a sinusoidal signal f(t).Modulation constant,…

Q: A very lossy, long, 50 transmission line is open circuited at the load end. Find the input impedance…

A:

Q: Calculate maximums and minimums for Vs and Vo given the following circuit if Vin-110VRMS@60HZ,…

A: Given: A circuit of full wave rectifier along with a capacitor in parallel of load resistance.…

Q: Networking A digital signal is to be designed to permit 100 Mbps for a bandwidth of 10 MHz.…

A: Given Bit rate 100 Mbps, Bandwidth 10 MHz To calculate No.of levels and SNR

Q: E9.19 Find the power factor of the source and vs(t) in Fig. E9.19 if f = 60 Hz. j0.4 Ω Figure E9.19…

A: Given: f=60 Hz. Required: Power factor of the source and vst.

Q: λ A very lossy, long, 50 transmission line is open circuited at the load end. Find the input…

A: Length of line l = λ4 Characteristic impedance Z0 = 50Ω Load impedance ZL = ∞

Q: Consider the system below with inputs 2₁ (t) and r₂(t): 10.4 X₁ (t) 20000 x₂ lts H₁ (jw) - 20000 t…

A: The given system is shown below,

Q: A stress element in the x-y plane is assumed to be acting under plane stress conditions. The…

A:

Q: A circuit is shown to the right. a. Is this an example of positive feedback or negative feedback? b.…

A:

Q: Class C commutation is shown in figure. Considering a safety factor of 2, what should be the value…

A: Given- Class C communication- Safety factor=2, Time- t=10 μs=10×10-6 s, To Find- The value of the…

Q: The skin depth at 10 MHz for a conductor is 1cm. Find the phase velocity of an electromagnetic wave…

A:

Q: 3. The voltage v across a 50mH inductor is depicted below. a. Obtain an equation for and sketch the…

A:

Q: Find Va 12V Μ ΖΩ ΖΩ 2· Va ΖΩ

A:

Q: 2. Supposed a star-connected, balanced 4 wire, 3-phase supply is carrying line voltage of 400V. By…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Plane x = 10 carries a current of 100mA/malong ā while line x = 1, y = -2 carries a filamentary…

A: It is given that: plane x=10 carries a current of 100 mAm along ayline x=1,y=-2 carries a…

Q: Power supply and heat dissipation are increasingly key design factors for microprocessors and the…

A: Microprocessor is a programmable device which has computing, storing, making decisions capabilities.…

Q: What is the functional transform of 120 sin (377 t - 45 degrees) volts into its effective value?

A:

Q: . In the circuit shown, switch A and switch B has been open for a long time. At t = 0 switch A…

A:

Q: 1 (s+2)(+5) Given the closed-loop system in the figure with C(s) = K and G(s) = interval of the…

A:

Q: Snow the power stages of ac generator and list do formulas that can produce as many as you can. TE:…

A:

Q: ALTI system has input x(t) and impulse response h(t). Calculate the energy of the signal at the…

A: Given: LTI system impulse response, h(t)=3πsinc3tπ, and input to the system, x(t)=5πsinc5tπ, To…

Q: Find the magnitude and phase angle of the following transfer function.

A:

Q: 1. DA = Бу+ха DB=B+ XX z-YB C) ь y Сpl D D B

A: Given: A sequential circuit with equations relating input output. DA=X¯Y+XADB=X¯B+XAZ=XB To explain:…

Q: A single-phase transformer is required to step down the voltage from 1100 V to 230 V at 50 Hz. The…

A:

Q: The signal xlt) is the input to a CT LTI system with frequency response H(ju). -...^^ -27 6)**: c)…

A: Given: For an LTI system, x(t)=∑n=-∞∞δ(t-nT),H(jw)=1 ;-3πT≤w≤3πT0 ;Otherwise, To find: Output y(t)…

Q: Find the equivalent impedance for the circuit below: Given: L1-L2-1H, R₁-20, R₂-40, C-0.01F, RC-50,…

A: Given, The given circuit diagram,

Q: : Calculate the amount of information if binary digits occur with equal likelihood in binary PCM.

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 8√ 1+ 252 M +√3 - + V₁ + عما 452 M V₂ Find V₁, V₂ x V₂. - pol

A: We need to find out the voltage for given circuit by using of KVL and KCL .

Q: -2 -1 f(t) 1 1 2

A:

Q: 2- Sketch a phasor representation of the three-phase system in equilibrium that contains both phase…

A:

Q: A 220-V d.c. machine has an armature resistance of 0.5 Q. If the full-load armature current is 20 A,…

A:

Q: A circuit is shown to the right. a. Is this an example of positive feedback or negative feedback? b.…

A: Given: An Op-amp circuit. To find: a) Is this an example of positive feedback or negative feedback?…

Q: A rectangular air-filled waveguide has cross-section of 4 cm x 10 cm. Find the minimum frequency…

A: Given, Air filled rectangular waveguide having dimensions a = 10 cm  b = 4 cm We need to find the…

Q: Three halogen lamps are connected on the same terminal node across 115-volt, 60-Hz source. If each…

A: The three LED lamps are connected in parallel to the AC source battery which is given as: Vrms=115V…

Q: A DC motor has the following specifications: 10 hp, 37.5 A, 230 V; flux / pole = 0.01 Wb, number of…

A: Given- DC motor, 10 hp, 37.5 A, 230 V, flux/pole=0.01 Wb, V=230 V, Number of poles P=4, Number of…

Q: H.W 4: Calculate the error constants and determine ess for a unit step, ramp and parabolic functions…

A:

Q: can you pls show a clearer picture of the efficiency part? I cant understand it

A: It is given that: η=1-LossesInputη=1-LossesLosses+VtILη=1-Ia2Ra+VfIf+WoIa2Ra+VfIf+Wo+VtIL

Q: With frequency f= 500 cycles/sec, what is the pure element in series with the R-25 ohms which causes…

A: Given data:-f=500 cycles/secf=500 HzR=25 Ω curren lag voltage by 20°.ϕ=20°

Q: Q2. For the circuit as shown below, find a single equivalent capacitor at terminals (a, b), where…

A: We need to find out the equivalent capacitance for given circuit .

Q: What reactive element comprising the circuit if the instantaneous voltage and current is 450 cos…

A:

Q: The average value of the sawtooth waveform with v()t) = Vm T (limits from 0 to T) is OVm T 0.5 Vm T…

A:

Q: Given the series RLC circuit in the following figure: (a) Derive the expression for the half-power…

A: Series Resonance A circuit containing reactance is said to be in resonance if the voltage across the…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.