Answered: Question 10 If a half wave rectifier is…

Question 10 If a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage drop model, the average output voltage is equal to 107.8 V 108.04 V 76.17 V 152.79 V

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 4RQ: What is the difference between a diode and rectifier?

See similar textbooks

Related questions

Q: Calculate % ripple factor for the given details of a full wave bridge rectifier. frequency= 50 Hz…

A: Given frequency= 50 Hz Rms voltage = 220 V Capacitance= 100 microfarad Resistance= 1 kiloohm

Q: If a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage…

A: average value of half wave rectifier is peak value of output voltageπ In half rectifier only one…

Q: What will be the out put of the D'Arsonval meters, if an average responding a.c meter of half-wave…

Q: 1. How great is the number of pulses in the three - phase half-wave rectifier?

A: The diagram in this experiment shows a 3-phase half-bridge half wave diode rectifier. The circuit is…

Q: QUESTION 3 A three phase star connected sinusoidal balanced source is used to feed a half wave…

Q: 5) For a single phase full wave bridge rectifier with a resistive load if the input voltage is 125…

Q: Example: What will be the out put of the following meters, if an average responding a.c meter of…

A: Given, Half wave rectifier reading = 4.71V True form factor of input waveform = 1.414

Q: A single phase full wave bridge rectifier is used to supply power. If resistive load of 8.5 ohm from…

Q: The average output voltage of full wave rectifier is more than half wave rectifier. True False 00

Q: The total secondary voltage in a center-tapped full wave rectifier is 64.55 V rms. Neglecting the…

Q: OA single phase half wave controlled rectifier is operated from a 145 V, 50 Hz supply and the load…

A: According to Bartleby guidelines I am supposed to do only first three questions. Kindly post next…

Q: The half wave rectifier is supplied with 230V, 70HZ signal. Assume the number of turns in the…

A: To calculate the average dc current through the load resistor 3 kilo ohm

Q: A single-phase full bridge uncontrolled rectifier is supplied by 220 V (rms) line voltage. The load…

A: In this question we need to find a output ripple effect of a single phase full wave rectifier.

Q: 1. Analyze the rectifier circuit. Find the indicated values. 10:1

A: The solution can be achieved as follows.

Q: Question 10 For the controlled half wave rectifier shown below; assume ideal thyristor: (No drop…

A: Use Ohm’s law and calculate the gate turn-ON voltage,

Q: What will be the out put of the H.W.R+PMMC meters, if an average responding a.c meter of half-wave…

A: Measuring Instruments: Generally we use two types of measuring instrument in electrical system.…

Q: In a single phase half-wave controlled rectifier has 400 sinwt as the input voltage and R as the…

Q: 2. A full-wave bridge rectifier is operated from a 50 Hz, 220 V rms line. It has a 100 uF filter 1…

A: Given Vrms=220VR=2kΩC=100μFf=50HzIdc=V/R=0.11 Form factor-IrmsIavg=Imax/22Imaxπ=1.11Ripple…

Q: Q20. Single phase half wave controlled rectifier is supplied from 220 V with 20 2 pure resistive…

A: The given device is a single phase half wave controlled rectifier with pure resistive load. The RMS…

Q: If one of the diodes in a 60 Hz bridge full-wave rectifier opens, the output is Select one: a.…

Q: A single-phase bridge rectifier has a purely resistive load R = 10. The sinusoidal input voltage has…

A: First draw the output voltage waveform and than derive the average output voltage and than…

Q: Use Germanium diode. The peak value of the input to a half wave rectifier is 45.72 V. The…

A: Given data, Peak value of input voltage is given, Vm=45.72 V Rms output voltage of half wave…

Q: if a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage…

A: Primary winding voltage V =240 V RMS F = 50 Hz . Vavg = ?. Average output voltage in case of…

Q: A 50 ohms load resistance is connected across a half wave rectifier. The input supply voltage is…

A: First draw tha output voltage waveform and than using average value integral evaluate average value…

Q: What is the peak output voltage for this half-wave rectifier? + Pri 169.706 V 60 Hz 0 Deg express…

Q: For a full-wave controlled rectifier, find out the RMS output voltage

A: Given data Vm = 220

Q: In a half wave rectifier, the input sine wave is 200sin200 nt Volts. If load resistance is of…

A: The equation of sine wave is in the form Em sin ωt. Comparing it, we get Em=200 Power = Em22πRL…

Q: 15 - Which of the following is the element to be used in the rectifier circuit to adjust the output…

A: Which of the following is the element to be used in the rectifier circuit to adjust the output…

Q: 3: A single phase half wave controlled rectifier is used to supply power to a 20 Q load from a 230…

A: Rectifiers convert AC power to DC power whose average output voltages and currents are infinite.…

Q: A 1-phase half wave diode rectifier with R load, has input voltage of 240 V. The input power factor…

A: Given data, Input voltage Vs=240 V

Q: In a full-wave rectifier, the dc voltage level is larger than the ripple voltage level. Select one:…

A: In full wave rectifier the DC output voltage is larger than the the ripple voltage level. The…

Q: A certain unfiltered center-tapped full wave rectifier is powered by a 120 Vrms, 60 Hz power system.…

A: The solution is given below

Q: 22. A single phase halfwave controlled rectifier has 400 sin 314 t as the input voltage and R as the…

Q: 30. A voltage source 200 sin314t is applied to a thyristor controlled halfwave rectifier with a…

A: In this question we need to choose a correct option.

Q: What is the average output voltage of a three phase six pulse rectifier operating on a line to…

A: 3 phase 6 pulse rectifier circuit is shown as

Q: What is the value of the ripple factor in a full-wave rectifier without filter? O 0.482 O 1.21 O…

A: Ripple factor is defined as the ratio of RMS value of the AC component of output to the average…

Q: A single phase full wave rectifier supplies a 20 Ohm load at an average voltage of 15 V. Determine…

A: Given: Single phase full wave rectifier Load, RL=20 Ω Average supplied voltage, Vavg=15 V

Q: The voltmeter has an amplitude value rectifier, the scale is graduated to root mean square…

A: we need to find out the absolute and relative error.

Q: The half wave rectifier is supplied with 240V, 50Hz signal. Assume the number of turns in the…

A: We need to calculate the average dc current through load for a given half wave rectifier

Q: QI: Q1: Single phase half sinusoidal wave controlled rectifier with (a = 30°), pure resistive load…

Q: The half wave rectifier is supplied with 230V, 70HZ signal. Assume the number of turns in the…

A: The circuit given is a half-wave rectifier. Data given: Input voltage (Vin) = 230 V (RMS) frequency…

Q: If a resistive load is supplied from a single phase half wave rectifier , if a supply voltage is…

A: The solution can be achieved as follows.

Q: The RMS output voltage of a Full-Wave Bridge Rectifier is 20 volts, Calculate the average current…

A: given that RMS output voltage = 20v RL= 3.2*103 ohm

Q: Solve it quickly please now

Q: What is the Peak Inverse Voltage (PIV) of a Bridge-type rectifier if Vp = 12V? Group of answer…

A: We need to select correct option for PIV inversion voltage .

Q: The RMS output voltage of a Full-Wave Bridge Rectifier is 20 volts, Calculate the average current…

Q: If the load resistance of a capacitor-filtered full-wave rectifier is increased, the ripple voltage…

A: Ripple voltage for a full wave capacitor-filtered rectifier is :- Vripple = Vout/ 2frCRL i.e.…

Q: A three phase full wave rectifier is shown below along with the peak input phase voltage Vm=169.7V.…

Q: If the time period of output voltage of a 1-o bridge rectifier is 25/3 ms, then the supply frequency…

A: Given: Time period of output voltage waveform, T'=253 ms

Q: single-phase half- wave controlled rectifier circuit with inductive load (L-0.1 and R=102) and the…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the difference between a diode and rectifier?
What is CEMF?
Draw the waveform Vs , VL, ID ((each)) , is for single phase full wave rectifier with RL load for the following firing angle a) 0° b)45° c)90° d)135° f)180°
A 60 Hz sinusoidal voltage with an RMS value of 120 V is applied to a single-phase full-wave SCR rectifier. The DC output voltage of the rectifier is 101 V, the firing angle (in degrees) of SCR is would be: O A. 36 O B. 45 O C. None of the other choices are correct O D. 30 O E. 60
A single-phase half wave uncontrolled rectifier circuit is operating with a purely inductive load and a source voltage of 100 sin (277t) V. An ideal PMMC ammeter is connected in series with the inductive load reads 20 A. Calculate the distortion factor of the rectifier. Answer Choices: a. 0.866 b. 0.707 c. 0.577 d. 0.816
Single phase half sinusoidal wave controlled rectifier with (? = 30?) pure resistive load (Vs =220 v. f=60 Hz, R=10Ω) Determine the average output voltage Vo  Determine the r.m.s value of the output voltage
iii. For fully controlled single phase bridge rectifier with inductive load (load current is continuous) ,supply voltage 220 V(RMS) and a=30° .The mean value of output voltage is : (a) 150.32V (b) 171.52V (c) 120.98V
A 50 ohms load resistance is connected across a half wave rectifier. The input supply voltage is 230V (rms) at 50 Hz. Determine the DC output (average) voltage (4 significant figures)
C4 R1 Vout For the precision rectifier circuit shown in Figure C4 what is the correct operation for the circuit if a Sine wave is 10k D1 R2 LM324 VEE applied to the input signal VIN? Vin D2 10k OUT V3 U1A Figure C4 A. When VIn is negative the circuit operates as unity voltage follower providing an in phase sine wave at VouT. When VIN is positive the circuit conducts but only to one diode drop, B. When VIn is negative the circuit operates as an inverting amplifier providing an inverted sine wave at VouT. When VIN is positive the circuit is driven to very close to zero due to amplifier gain reducing the diode drop voltage, c. When VIn is negative the circuit operates as an inverting amplifier providing an in-phase sine wave at VOUT. When VIn is positive the circuit is driven to very close to zero due to amplifier gain reducing the diode drop voltage, D. When VIn is negative the circuit operates as unity voltage follower providing an inverted sine wave at Vour. When VIn is positive the…
In a half wave rectifier, the sine wave input is 55sin55t. If the load resistance is of 1K, then DC power output will be? a. 0.3W b. 3.99W c. 5.97W d. 6.77W
A 50 ohms load resistance is connected across a half wave rectifier. The input supply voltage is 230V (rms) at 50 Hz. Determine the DC output (average) voltage (4 significant figures) Please solve it correctly. Thankyou!
CIRCUIT DIAGRAM : D1 IÑ4001 AC Source RL 1K Q VOUT PROCEDURES : 1. Construct the half-wave rectifier circuit as shown. 2. Monitor the input voltage using the oscilloscope. Adjust the oscilloscope to show at least two complete cycles of the input signal. Draw the input waveform in Graph 1 and measure the peak-to-peak value. Record this in Table 1. Convert this value into RMS value using the formula: 3. 4. Vp-p Vp-p P-P VRMS 2.828