Q2: Ju A:A three-phase transmission line with 1.955 cm diameter conductor, the corona takes place if the line voltage exceeds 210 Kv (disruptive voltage F Hint: 6-1, mo-1 find the spacing between, The Bands conductors

Q: A semiconductor device needs to operate at 400K and requires p and n doping levels of 1015/cm3 to…

A: A semiconductor device needs to operate at 400K and requires p and n doping levels of 1015/cm3 to…

Q: Q1] Test for linearity, time invariance, causality, BIBO stability, and static of the systems i)…

A: iyn=yn-1-14yn-3-12xn+1+2xn-2Linearity--12x1n+1+2x1n-2=y1n-y1n-1+14y1n-3…

Q: What are IC Voltage regulators? State the different IC voltage regulators and its operation.

A: We need to tell about IC Voltage regulators and  its type  and its operation.

Q: explain the process to get Vout. i am no the best at Kvl or voltage potential

A: Need to explain the process for applying kvl to the loop to get the required value across the…

Q: 1) The following network is to be analyzed using Supermesh Analysis. 6Ω 24 V 40 www 6 A 1002 www 12…

A:

Q: A hydroelectric plant has a head of 70 m and a water volumetric flow rate of 9.000 m³/s. What is the…

A: Given  h = 70m  V = 9000 m3/s  ρ = 1000 kg/m3  We need to find maximum power that the plant can…

Q: How do you write a logical expression for 4 outputs in a 2-4 active low decoder?

A: This is the type of combinational circuit that can be used to convert binary to other codes. It has…

Q: b) Design an AC circuit with a power supply system supplying power to a lagging power factor load.…

A:

Q: 3. For the given circuit of Fig. 3, analyze the following: Zi, Zo, Av. with and without considering…

A: For the given amplifier circuit, we have to find the equivalent small signal model, input impedance,…

Q: b) Make one of these transformers as an autotransformer and calculate the improvements in the…

A:

Q: 6. The MOSFET in the circuit shown has V₁ = 1.5 and k = 100 mA/V². a. Determine the drain current.…

A: we need to calculate- a) the drain current ID  b) Node voltage Vx at a node x. Circuit:-

Q: Ex: Find current i, and voltage v. in the circuit shown in Figure.

A: Need to calculate the required voltage and current in the circuit and the same can be calculated by…

Q: 2- Find the norton eq. at 1. (a, b) and 2. (C, d) b 120 v Ans 612 m a fr 4√2 M. 3√2 PEA 1. (a,b) →…

A: In this question we need to find the Norton equivalent circuit at terminal a,b and c,d

Q: Q10. The circuit below is subjected to both DC and AC excitation. Assume ideal op amp. Find Vo(t). 2…

A:

Q: Question- Find RMS noise voltage. An amplifier has a bandwidth of 4 MHz with 10 k2 as the input…

A:

Q: 5. The transfer function of the system is given as 4 s(s+1)(s+2)+4 = 0 Using Routh's criterion…

A:

Q: In the circuit in the figure Vcc= 25 V, Vi= 40 mV, RB = 470 kg. RC = 3.3 kg, RE1 = 470 G, RE2 = 1.2…

A: The output voltage Vo can be calculated by using the DC and AC analysis of the given amplifier…

Q: 1. Moore's Law: 1) What is Moore's Law about? 2) Why we have been used Moore's law to predict…

A:

Q: What methods should be used when first cleaning an EPROM

A:

Q: For the electrical circuit given below. (L1-5H. C1-C2-0.1F, R1-10 ohm) LI Vi :C1 R1 www C2 Vo a.…

A:

Q: *if a^2 - 4b =0 then the roots are complex O real O repeated O other O

A: The equation is, a2-4b=0.

Q: An overhead transmission line configuration is shown below, operating at 60 Hz, and a conductor

A: Given data:   Operating Frequency is 60Hz Conductor temperature is 70°C   Refer to Table A.4 in the…

Q: VS VS A E Do not include the unit. The answer must be in 2 decimal places. B RL Transform the 1st…

A: A = 3 kohms B = 3 kohms  And C = 3 kohms   we need to find out the value of E in ohms

Q: In a series RL circuit shown below, the switch is in position '1' long enough to establish the…

A: Given circuit-   To find- Current it, for t>0.

Q: 1. Find the Nortor eq. at (a,b) for the cct.

A: Norton's equivalent circuit needs to be calculated for the given circuit between terminals a and b.…

Q: 3. Illustrate PIN configuration diagram for each of following ICs • 7400 • 7402 ● 7430 7432

A:

Q: A hybrid VR stepping motor has 8 main poles which have been castellated to have 5 teeth each. If the…

A: A hybrid stepper motor - is a type of electric motor that combines the features of both permanent…

Q: N X ms ---------- O a. theta=67,50 O b. theta-33,75 O c. theta=101,25 O d. theta=84,38 O e.…

A: In this question,  We need to determine the value of phase difference.  If X=9ms.

Q: Problem 3 The 74F138D is a 3:8 active-low decoder with three enable pins. Assume the enable pins are…

A: Need to convert the given truth table function into the decoder-based logic circuit. The output of…

Q: Which of the following Boolean Algebra Theorems are True (Select all that apply) X+0=X X+1=1 x.0mx…

A: The True Boolean Algebra Theorems out of the given options

Q: 1 V₁ 12.6 V D₁ 2 IDEAL DIODE R₁ 12 kn What is the current through the diode? E13

A:

Q: 1) The following x(t) signal: a) Instant power, b) Average power c) Find its Total Energy. X(t)= I…

A:

Q: Consider the following frequency selective circuit. At what frequency, in hertz, will the magnitude…

A: Given: A frequency selective network, with, R=22?, L = 250 mH, C=10 mF. To find: Frequency at…

Q: 3. The switch in the circuit shown in Fig. 3 has been in position 'a' for a long time before. moving…

A: The expression for current through the inductor and voltage across the voltage needs to be…

Q: c) Two alternating voltages have the following instantaneous values: I v2 = 12 sin(wt + π/6) v1 = 24…

A:

Q: R1 www 2.2kQ Figure 1 w R2 1kQ w R3 3.3kQ

A: According to guidelines we don't solve lab based question. So in this question we only calculated…

Q: Q1. Determine Req for the circuit shown in Figure Q1. (Note: w=22) (Ans: 5.692) Req 3 W W 2 W 6 W m…

A: it is asked to find Req for given circuit

Q: How did they get a) 0.48 m^3 b) 0.5?

A: According to the question, A square ventilation duct has a side length of 0.3m. The duct is turned…

Q: VS1 IA m R2 IB using Mesh analysis what is the equation at loop IB? (A) VS2 = R2*1A + (R2+R3)*IB B)…

A:

Q: what things should I have to buy to design accelemetors in prosthetic?

A: We need to tell about things should have to buy to design accelemetors in prosthetic.

Q: Circuit theory

A: In this question,  We need to determine the value of phase difference.  If X=9ms.

Q: Given the sinusoidal input source current i;(t) = 20cos (100t), find the steady- state expression…

A: i1(t) = 20 cos( 100t) A, R = 400 Ω, L = 3 H Circuit

Q: A continuous-time linear, time-invariant (LTI) system is represented by the following impulse…

A: In this question,  We need to check the all properties of the given system.

Q: Simplify the following expression using the K-Map for the 4 variables A,B, C and D.…

A: Given, Logic expression is  f(A,B,C,D) = ∑ (1,3,5,7,8,9,12,13)  We need to simplify it using K-map.

Q: what FR4 rogers in detail

A: FR4 and Rogers are two different materials used in printed circuit boards (PCBs). FR4 is a common…

Q: D₁ 12 IDEAL_DIODE V₁ 12.6 V R₁12 kn What is the current through the diode?

A:

Q: Solve for the zero-input response - y(n) = 0.9y(n − 1) – 0.81y(n − 2) + x(n), y(−1) = y(−2) = 1

A:

Q: The parameters of a three-phase transmission line are given as Z = (12.84 + j72, 76)Ω and y = j5,…

A:

Q: c) Two alternating voltages have the following instantaneous values: v2 = 12 sin(wt + π/6) v1 = 24…

A: Two alternative voltages are given , V1=24sinwt V2=12sin(wt+π/6) We need to add the two voltages, by…

Q: Shouldn't answer be in volts/degree?

A: The question was based on the calculation of the sensitivity of a potentiometer.

Short Transmission Line

A short transmission line is a transmission line that has a length less than 80 kilometers, an operating voltage level of less than 20 kV, and zero capacitance effect.

Power Flow Analysis

Power flow analysis is a topic in power engineering. It is the flow of electric power in a system. The power flow analysis is preliminary used for the various components of Alternating Current (AC) power, such as the voltage, current, real power, reactive power, and voltage angles under given load conditions and is often known as a load flow study or load flow analysis.

Complex Form

A power system is defined as the connection or network of the various components that convert the non-electrical energy into the electric form and supply the electric form of energy from the source to the load. The power system is an important parameter in power engineering and the electrical engineering profession. The powers in the power system are primarily categorized into two types- active power and reactive power.