Answered: A three-phase line has its conductors…

A three-phase line has its conductors at the corners of an equilateral triangle of side 1 m. The radius of each conductor is (1/0.7788) cm. The inductance per phase per km is given by:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: a) It is applied direct current to RC circuit. Which figure does belong to power supply, which…

A: a)we need to identify and explain which figure belongs to power supply and which one is for…

Q: n shown in Figure (4); Find the rms value.

Q: 20 A sinusoidal ac source in the figure has an rms value of V. Considering all possible values of R,…

A: Given: VRMS = 202Vinput= Vin(t) = 20sintAnd Consider RL =∞VZ = 5 volt Find: minimum Value of Rs to…

Q: Which of the following statement is true? a. Angle between load voltage and load current in a pure…

A: Solution:- Let's consider a capacitor C connected to load with capacitance C.C is connected as load.…

Q: What does it mean for a steady-state to be unstable (a.k.a, a source)? Explain..........

A: Generally for a control system, the output will be bounded for a bounded input. This is called a…

Q: Why it is necessary to use the geometric means radius in the formula for the inductance caleulation…

A: Expression of per phase inductance of 3 phase transposed transmission line Lph=2×10-7×lnDr' H/m/ph…

Q: 4. Electrical failure of insulators occurs due to ... ....and .. 5- The other name of…

A: 4) there could be multiple reasons for the electrical failure of insulators but the two are:-…

Q: For the capacitor circuit in Figure 1 a. Determine the time constant of the circuit. b. Write the…

Q: You measure the capacitanceC1of a capacitor by doing thefollowing: First connect capacitorsC1andC2in…

A: Given capacitance c2 is 3 mf and slope of the graph between voltage across c2 and supply voltage Vs…

Q: Consider a step up converter with a resistive load of value R5 Ohms. It is supplied by a DC power…

A: First calculate ripple current and than find the new value of ripple current . using new value of…

Q: Can you please write a full description for transient behaviour of capacitors and inductors…

A: Series Connection: Current in R/L or charge in C same Voltage in R, L,C different Parallel…

Q: Voltage

Q: A step-down chopper is to be used to supply power from a 600-V overhead wire to the commutator motor…

A: Source voltage, Vs = 600 VMotor resistance, R = 0.2 ΩMotor inductance, L = 25 mH = 0.025 HChopper…

Q: What does it mean for a steady-state to be unstable

A: Steady state: A system is to be called in steady state when the current flowing in the circuit or…

Q: Q5. Describe the properties of ferromagnetic materials.

A: Properties of ferromagnetic material is to be discussed here.

Q: Wiat is the difference between a real independent voltage source and an ideal independent voltage…

A: Resistance opposes the flow of current. The dependent voltage or current source value depend on…

Q: For the three circuits given in the figure, the source voltage is sinusoidal with a peak value of 1V…

A: Given the three circuits as shown below: For the three figures, it is provided with a sinusoidal…

Q: 2.)What is the difference between Ampere's law and Biot-Savart's law?

A: A current carrying wire produce magnetic field. The direction is obtained by right hand rule.…

Q: A 220 V, 60 Hz voltage is applied across a series circuit figure comprising a coil of resistance R,…

A: NOTE: as per our company guidelines we are supposed to answer only first three sub-parts. kindly…

Q: C) Determine the Voltage Vo 20L0°V jios 2052 V. Vo (in ALD form)

Q: A 120 V, 60 Hz power source is connected across an 800 ohm resistance in series with an unknown…

Q: measures the dispersion around the expected value.

A: The correct answer of it is standard deviation because variance and standard deviations are related…

Q: The mutual inductance coupling coefficient standard unit is ... * Ohm Henery Unit-less Mho

A: The mutual inductance is M=k x sqrt L1 .L2 k is the coefficient of coupling k=M/ sqrt L1.L2

Q: A class-A d.c. chopper circuit is supplied with power from an ideal battery of 120 V. The load…

Q: A controlled rectifier circuit is generating thewaveform of Figure P4.30 starting from a…

A: Let P be the power dissipated in a resistive load when the voltage is not rectified, and P’ be the…

Q: To reduce the ripple voltage across the smoothing capacitor terminals, Select one: a. supply voltage…

A: ripple voltage is inversely proportional to the capacitance used. so for reducing ripple voltage we…

Q: Define the concept of "harmonic distortion" in power systems. What are the sources of harmonics, and…

A: Harmonic distortion refers to the presence of additional frequency components, known as harmonics,…

Q: Suppose we have a 10-Hz sinusoidal voltage source, vin(t). Draw the diagram of a circuit that clamps…

A: Drawing a circuit that clamps the positive peaks to - 4 V

Q: Derive the expressions of voltages across resistor and capacitor and the current through the circuit…

A: The solution is given below

Q: Q1. following: For the circuit shown in figure (a). Let V1= 10Vms, frequency 10KHZ. Draw the A.…

A: Series Connection of impedances: When n no. of impedances are connected in series, their equivalent…

Q: Discuss the importance of reactive power in power systems and its impact on voltage control.

A: Reactive power is crucial aspect of power systems, playing a vital role in maintaining the stability…

Q: In the nominal pi model which among these are divided into two halves? a. Series impedance O b. None…

A: In this question we will write about nominal pi method..

Question

Inductance calculation..

A three-phase line has its conductors at the corners of an equilateral triangle of side 1
m. The radius of each conductor is (1/0.7788) cm. The inductance per phase per km is
given by:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data-

VIEW

Step 2: Calculation-

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A resistor of 12ohms and an inductance of 0.025H are connected in series across a 50Hz supply. What values of resistance and inductance when connected in parallel will have the same resultant impedance and p.f. Find the current in each case when the supply voltage is 230V
Consider more realistic situation, silicons intrinsic Fermi level isn't at the midgap. Please find the energy differences between real Fermi level and midgap Please give some explanations.
quick please
What is the DC equation and the waveforms?
Discuss two methods that can be used to determine the particular solution of a circuit with constant dc sources.
Please write short introduction about AC Circuits - Series Circuits
A thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small a relatively small surge limiting inductance B. A fixed capacitance and a relatively large surge limiting inducatance C. A variable capacitance and a relatively small surge limiting inductance D. A Variable capacitance and a relatively large surge limiting inducatnce
Which of the following is not a practical type of inductor? O a. SMD Chip Inductor O b. AM Radio Antenna O c. Curie Temperature O d. Toroidal Core Inductor
A 6-uF and a 10-uF capacitor is connected in parallel are in series with a 12-uF capacitor. The combination is then connected across 250 Volts source. Determine (a) charge in each capacitor; (b) total energy; (c) energy in 6-uF capacitor; (d) energy in 10-uF capacitor; (e) energy in 12-uF capacitor. 6 uF 10 µF 250 *12 F
Investigate and explain the characteristics of ideal and real voltage and current sources.
Discuss Potential barriers of combined heat and power (CHP).
Specify the LM-series linear regulator required to regulate a fixed voltage of -7 V. Please write the numbers only in the answer field: i.e. for LM1234, you would write 1234 in the answer field.