Problems arise if the contaminant concen- tration in the influent to the manufacturing step rises above a critical acceptable level (ca). Again, assuming that the contaminant con- centration in the municipal water is zero and that the UPW system does not remove any of this contaminant, solve for the recycle ra- tio (RR = R/Q) as a function of the other known quantities, Q, ca, and W. NOTE: for the purpose of answering this question, use "ca" to denote Ca.

Problems arise if the contaminant concen- tration in the influent to the manufacturing step rises above a critical acceptable level (ca). Again, assuming that the contaminant con- centration in the municipal water is zero and that the UPW system does not remove any of this contaminant, solve for the recycle ra- tio (RR = R/Q) as a function of the other known quantities, Q, ca, and W. NOTE: for the purpose of answering this question, use "ca" to denote Ca.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Chose the correct answer 1- The Unit measurement of suspended solids is ...A- kg 2- The Unit measurement of Turbidity is A- °C is B-m B-NTU C- mg/L C-K 3- The Unit measurement of pH www A-mg/L 4- The Unit measurement of alkalinity is .. 5-Non toxic metals includes 6-Dissolved materials size is lees than A- 10 mm D- none of above D- none of above D- none of above B- p.p.m C- g/m³ D- none of above A- m/sec B- m³/sec C- mg/L A-Chromium B- Mercury C- Calcium D- none of above B- 106, C-108 mm D- none of above mm 7- Public standards of Hardness in drinking water is A-500 mg/L B-50 mg/L C-100 mg/L D- none of above 8- Alkalinity species includes are A-HCO3 B-CO3 C- OH D-All of above ... 9- Dental cavities in children can prevented when Drinking water has Fluoride concentration of A- 0.1 mg/L B- 1 mg/L C- 10 mg/L D- none of above 10- Toxic metals are metals that harmful to humans even when exists in concentration of .. A- Small B-Large C-zero D- none of above
For each of the following constituents that might be found in water or wastewater, provide two examples of a unit operation that would be useful in removing that consitutent. a. Giardia lamblia (protozoan) b. Arsenic c. Bentonite (clay)
Determine the pH of a solution that contains 2*(10^-4) mg/L of OH- (at 25 degrees).
Glycerin flows at 35 m through a 150 mm diameter new wrought iron pipe at a velocity of 3 m/s. It has an absolute viscosity of 1.50 Pa-s and a specific gravity of glycerin = 1.26. 1. Determine the Reynold's number,
Q2: Determine the resultant about the point O of the four forces and one couple which act on the plate shown in the Figure below. Note : for the resutant of 3osihys Forc es, You should computy the magnitude Kdirechion 30N 5 m- 3 ocos4s 25N 2 m 70 N-m 20N 40N o 30
You have designed a treatment system for contaminant Z. The treatment system consists of two parts: (1) a pipe with a volume of 15 m3 and (2) a CSTR has a volume of 60 m3. The pipe feeds into the CSTR. The inflow to the pipe is 10 m3/d and the influent Z concentration at the start of the pipe is 2,500 mg/L. The effluent from the pipe has a Z concentration of 1500 mg/L. Assume the reaction is first order. What is the reaction rate constant in units of (1/day)?
Problem 2. A reverse osmosis membrane has a kw values of 2.5-10 L/(m²-s-bar) and an average ks value of 3.5.10+ L/(m²-s). Find the expected permeate salt concentration of chloride if the feed concentration is 4500 mg/L, the system operates at a gauge pressure of 35 bar on the feed side of the membrane, and 95%. Assume the permeate has a negligible osmotic pressure. Answer: 171 mg/L.
Aluminum pieces inadvertently collect on the filter. a. If left on the filter, will the percent yield of the alum be reported as too high or as too low? Explain. b. If the aluminum pieces are detected on the filter, what steps would be used to remedy the observation? Explain.
The pOH of a basic solution is 3.33. What is pH?
Lake Bonaventure is a lake fed by the Saint Croix River. The Acme smeting company discharges the heavy metal nickel into the lake. The easy way to model the concentration of nickel is to assume the lake is well mixed. It isn’t. The lake has a mean depth of 30m, and during the summer a surface epilimnion of 5m develops, which breaks down for the winter. (no calculations are required to answer the questions below) (A) Given what you know about the hydrology of lakes, what differences in concentration would there be if the smelter discharges at the surface or at a depth of 30m? (B) How would concentrations vary in the lake throughout the year? (C) What if you factor in the fact that the flow of the Saint Croix River is less during the winter?
A PFR is not meeting effluent requirements so baffles are going to be added to the tank toincrease contact time. The tank is 12 ft deep, 40 ft wide, and 120 ft long. The engineer isgoing to add long baffles to the tank. The baffles will be 90% of the tank length. If thecurrent HRT is 0.5 d, and the influent concentration is 9 mg/L with an effluent limit of 1.5mg/L, how many baffles need to be added? Assume k=1.98/day
(a) (ii) Following chemical species were reported for water sample from a well. Concentration (milli equivalent)/L 15 15 05 30 12 18 8.8 Species Chloride (CL) Sulphate (SO2-) Carbonate (CO2) Bicarbonte (HCO3) Calcium (Ca²+) Magnesium (Mg2+) pH Find (i) The total hardness (in mg/L) as CaCO3 (ii) Alkalinity present in the water (in mg/L) as CaCO3.