Aluminum pieces inadvertently collect on the filter. a. If left on the filter, will the percent yield of the alum be reported as too high or as too low? Explain. b. If the aluminum pieces are detected on the filter, what steps would be used to remedy the observation? Explain.

Q: A ground water with salinity (TDS) of 2850 mg/L is treated with reverse osmosis desalination process…

A: NOTE: As per our policy, we can solve only the first 3 sub-parts.   Given Data: The groundwater with…

Q: Help solve both of these for my homework. Please

A: Q5Q6

Q: Which of the following statements is true?

A: The design parameters of setting tank includes loading rate of solids, overflow rate, side water…

Q: The dilution water which is to be used for the BOD analysis on an industrial waste was seeded with…

A:

Q: ll Consider the capability of a process that puts pressurized grease in an aerosol can. The design…

A:

Q: Explain how to apply the salinity effect in ANSYS15? The CFRP strengthened RC beam simulated in…

A: ANSYS is very useful to get solutions regarding very complex designs or structures that are not…

Q: In a titration of dilute sulfuric acid, H2SO4, with sodium hydroxide, NaOH, how many milliliters…

A: The chemical reaction is given as  H2SO4 (aq)  +  2NaOH(aq)   -->  Na2SO4(aq)  +  2H2O(l)

Q: Briefly explain about  degradation of azo dyes in wastewater using micro-nano bubble treatment.

A: Micro-nano bubbles (MNB) are bubbles which have diameter between tens of nanometer and micrometer.…

Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…

A: Given: Temperature of carbon tetrachloride = 68°F Avg. diameter = 230 µm = 230*10-6 m Required:…

Q: water goes through the water cycle again and again, the amount of water on Eart A- Increases. C-…

A: 1. C  stays the same 2.   A Decreases with higher altitudes 3. D  Rainfall 4. C  Evaporation,…

Q: Available chlorine in bleaching powder solution is 0.5mg/ml. To obtain a chlorine dose of 0.1 mg/1…

A:

Q: Which of the following is not a cause of energy loss in pipes? O Boundary friction O Changes in pipe…

A: Answer  Option   (d )   pipe temperature   is correct. The explanation is given in next step.

Q: Example 9.36. Design a Zeolite-Softener for an industrial concern, using the following data : (i)…

A:

Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…

A: The diameter of the carbon tetrachloride droplet,To determine the pressure difference between the…

Q: Convert the concentration of SO2 from 80 pg m temperature of 25°C and a pressure of 101.325 kPa. to…

A: ppm = Conversions are needed to calculate the volume of So2  in cubic meters.

Q: Problem 2. A reverse osmosis membrane has a kw values of 2.5-10 L/(m²-s-bar) and an average ks value…

A: Step 1:

Q: Why is it crucial to maintain a liquid water film on all surfaces of the medium in the filter bed…

A: Biofiltration is defined as the biological treatment which is used to treat surface water for…

Q: The sludge produced from the aeration tank of the activated sludge process has a solid content of 2%…

A: This question is related to the Environment Engineering from Civil Engineering.

Q: The slow cooling process can effectively stabilize the components of clinkers produced in the…

A: in this question , we are asked to verify a statement regarding thermal temp control of burning…

Q: 6. To refrain from separation in subsonic nozzles, the expansion angle must not be more than a) 10…

A: To refrain from separation in subsonic  nozzles,  the expansion angle must not be more than ________…

Q: Match the cell type with its function: Parenchyma Vessel Choose... Choose... Libriform fiber…

A: The building blocks of xylem vessels, which make up the majority of the water transport system in…

Q: The second stage nitrification process is presented by the following equation Nitrobacter 2NO2+ 02…

A:

Q: Some wastewater has a BOD, of 180 mg/L at 20°C. The reaction rate K at that temperature has heen…

A:

Q: A treatment plant has been designed to achieve 99 percent inactivation of Giardia Lamblia using…

A: 99% disinfection Present temperature = 20oCNew temperature = 0.5oC

Q: The air in the San Francisco Bay Area has a mercury content of 2.1 mg/m3. This concentration should…

A: Given, mercury content=2.1 mg/m3 Temperature=20˚C=(20+273)K

Q: An Aluminum wire has a ler the wire. Select the correct responsE O 56.2384 milli-ohm O42.6343…

A: L=200m

Q: 0 0 Influent- Influent Influent Anaerobic Aerobic Influent- Return activated sludge Aerobic Anoxic…

A: This question is related to the Environment Engineering from Civil Engineering. In this question ask…

Q: Q1: A conventional ASP is to be used for treatment of 10,000 m³/d of municipal wastewater. The…

A:

Q: (iii) If HOCI (hypochlorous acid) degrades in water per first-order kinetics with a rate constant of…

A:

Q: Condensation occurs when the temperature is the dew point temperature (Td). O less than or equal to…

A:

Q: A water treatment plant treating 100,000 gallons/day has discovered that their source water…

A: According to given data  A water treatment plant treating 100,000 gallons/day has discovered that…

Q: Environmental Engineering: A reaction takes place in aqueous solution and is first order. The…

A: Calculating the rate constant for the reaction,

Q: Condensation occurs when the temperature is the dew point temperature (Td).

A: solution  Less than or equal to due point actually when the falls below the dew point the excess…

Q: The initial concentration of acetic acid is  0.6mM and its concetration is 0.42mM after adsorption…

A:

Q: In a biological wastewater treatment system, which of the following conditions could be considered…

A: Anoxic conditions refer to which conditions in molecular oxygen is absent, which means electron…

Q: The laundry uses 1000 n in laundering oerpations. Mg2+ at 2 meq/L. Their goal is to reduce total…

A: STEP 1 Qreq = 1000m3/daycolumn = 200mg/l as caco3magnesium =100 mg/l as caco3absolute hardness ought…

Q: The most important buffer system in water is the carbon dioxide system of acid/base reactions.…

A: Alkalinity of any solution defined as the ability to neutralise the H+ ions in the solution. here…

Mechanical Processes

In civil engineering, the materials have to undergo a series of manufacturing processes before using them in construction and structural applications. These manufacturing processes form the foundation stone of mechanical processes. Some of the civil engineering materials such as bars, metallic beams, metallic columns, surveying equipment, earthmovers, overhead cranes, structural and construction components, and even cement that is the most fundamental construction component need to undergo different manufacturing processes before they are ready to use. These processes are mechanical.