Problem 10 A homeowner is trying to decide between a high-efficiency natural gas furnace with an efficiency of 95 percent and a ground-source heat pump with a COP of 3.3. The unit costs of electricity and natural gas are $0.112/kWh and $1.44/therm (1 therm = 105, 500 kJ). Determine which system will have a lower energy cost.

Problem 10 A homeowner is trying to decide between a high-efficiency natural gas furnace with an efficiency of 95 percent and a ground-source heat pump with a COP of 3.3. The unit costs of electricity and natural gas are $0.112/kWh and $1.44/therm (1 therm = 105, 500 kJ). Determine which system will have a lower energy cost.

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter17: Energy Conservation

Section: Chapter Questions

Problem 6P

See similar textbooks

Similar questions

The Energy Efficiency Rating (EER) of an air-conditioning unit is defined asthe ratio of the heat removed in Btu/hr divided by the energy used in watts. Awindow air conditioner is rated at 5,170 Btu. It uses 470 watts of power. Whatis this unit’s EER?
For a building located in Madrid, Spain with annual heating degree-days (dd) of 4654, a heating load (heat loss) of 30,000 kj/h, and a design temperature difference of 30° C (20° C indoor), estimate the annual energy consumption. If the building is heated with a furnace with an efficiency of 92%, how muchgas is burned to keep the home at 20° C? State your assumptions.
A home is heated with propane with a 100,000 BTU furnace size and 95% efficiency. The monthly heating degree days is 5000. Using the energy estimation discussed in this chapter, estimate the monthly and annual gas consumption to heat the building if the home is to be kept 68°F.
A 1000 MW coal fired power plant (30% efficiency). The coal is 75% carbon and has a heat content of 10, 000 BTU/lb. What is the carbon emission (ton carbon per year)?A 1000 MW natural gas plant (45% efficiency). The gas is CH4 with a heat content 800 BTU/mol. What is the carbon emission (ton carbon per year)?Calculate carbon emission reduction if the above natural gas plant is used to replace the coal fired plant.(Here ton is metric ton, 1 ton=2,200 lb)
The Energy Efficiency Rating (EER) of an air-conditioning unit is defined asthe ratio of the heat removed in Btu/h divided by the energy used in watts.The EEI (Edison Electric Institute) names an air-conditioning unit as anEnergy Star unit if it has an EER of 13 or greater. A 21⁄2-ton air-conditioningunit uses 2.41 kilowatts (2,410 watts) of energy. One ton is equivalent to12,000 Btu/h. Can this unit be termed an Energy Star unit?
When 1 cu ft of natural gas is burned, 1,050 Btu of heat are produced. In oneday, a building uses 761,250 Btu of heat. How many cubic feet of gas areburned?
Water falls from a height of 500 m and the mass of water is 50 kg. What is approximately the rise in temperature of water at the bottom if the whole energy is used to heat the water? Specific heat of water is 4.18 kJ/kg-deg C. O 5000 deg C O 1173 deg C O 500 deg C O 0.23 deg C O none of the above
Consider a 400-MW, 32 percent efficient coal-fired power plant that uses cooling water withdrawn from a nearby river (with an upstream flow of 10-m3/s and temperature 20 °C) to take care of waste heat. The heat content of the coal is 8,000 Btu/lb, the carbon content is 60% by mass, and the sulfur content is 2% by mass. How much electricity (in kWh/yr) would the plant produce each year? How many pounds per hour of coal would need to be burned at the plant? Estimate the annual carbon emissions from the plant (in metric tons C/year). If the cooling water is only allowed to rise in temperature by 10 °C, what flow rate (in m3/s) from the stream would be required? What would be the river temperature if all the waste heat was transferred to the river water assuming no heat losses during transfer? Estimate the hourly SO2 emissions (in kg/h) from the plant assuming that all the sulfur is oxidized to SO2 during combustion.
Problem T3 If the shaft power is 82kw and the cost of the electricity is $0.10 kwh; estimate the cost of the electricity for one hour. Answer $8.2
Investigate the size of a gas furnace used in a typical single-family dwelling in upstate New York, and compare that size to the furnaces used in Minnesota and in Kansas.
A 600 MW coal-fired power plant has an overall thermal efficiency of 38%. It is burning coal that has a heating value of 12,000 Btu/lb, an ash content of 5%, a sulfur content of 3,0%, and a CO2 emission factor of 220 IWmillion Bin. Calculate the heat emitted to the environment (Btu/sec), the coal feed rate (tons/day), the degree (%) of sulfur dioxide control needed to meet an emission standard of 0,15 lh SO2/inillion Bin of heat input, and the CO2 emission rate (metric tons/day).
For a building located in London, England with annual heating degree-days (dd) of 5634, a heating load (heat loss) of 42,000 kj/h, and a design temperature difference of 35° C (20° C indoor), estimate the annual energy consumption. If the building is heated with a furnace with an efficiency of 98%, how much gas is burned to keep the home at 20° C? State yourassumptions.