Problem 1: Design a high-pass filter with a corner frequency of approximately fc = 200Hz. Your filter must ensure that at least 90% of the incident signal power is attenuated at f = 60 Hz. Verify the proper operation of your filter by using LTspice XVII to plot the magnitude and phase response of the voltage transfer function H(f). Show LTspice XVII Part if possible. DO NOT GIVE AI GENERATED RESPONSE OR I WILL DOWNVOTE.

(c) Design a series RLC bandpass filter with cutoff frequencies fc₁ = 1 KHz, fcz = 20 KHz, using a 100 resistor. Draw the circuit and label all the components, including circuit values, including input and output. Also draw the magnitude and phase plots for the filter. Amplitude [dB] 50 40 30- Phase [°] 10 of- -10... -20... -30- -40- -50 0.1 180 135 90 C 45 of -45- -90 -135- -180 0.1 1 1 10 10 100 100 1000 1000 10,000 Freq. (Hz) 10,000 Freq. (Hz)

1. A) B) Write the transfer function for the RC high-pass filter of Figure 2. First write it in terms of jw (or s) and then write it as its magnitude and phase angle. Determine and record below the cutoff frequencies of the circuit. wwwwww Sketch the straight line approximations of the frequency responses for the RC high-pass filter on Graph Av0.1 0 -10 -20 90° 60* 30° 0⁰ -30° -60° -90° e-2 sin (et) 0.1 0.2 (a) Voltage gain response 0,5 0.2 (b) Phase shift response 0.5 1 C = 0.47 uF R-330 ohms 2 ww 5 10 10 Vout 20 20 50 50 100 f (kHz) 100 (kHz)

I need the full answer with explain please