point in spherical coordinate is located at (2, 60°, 70°). The distance of this point to a point (9, 50°, 17), which is in cylindrical coordinate, is ________ units?

Q: Suppose in any operational amplifier if two input signal are given at 25 volt and 15 volt at…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…

A: Given circuit, To determine the current supplied by each voltage source using superposition.

Q: pply Norton theorem to calculate the current in 6 2 resistance for t rcuit in figure 3 2000 + 55 Jov…

A:

Q: If the unit step response of a network is (1 - e-at), then Find its unit impulse response

A:

Q: If vi(t) is a step voltage in the network shown find the value of the resistor such that a 25%…

A:

Q: calculate the magnetic flux density for the current distribution in free space to be A = (3x²y+yz)…

A: Magnetic flux is the total magnetic field pass through a given area. It is denoted by ϕB and the…

Q: Explain how the value of fault current can be computed for L-L-G fault occurring at the terminals of…

A: Fault current: It is a current that comes into the picture when the fault occurs. The current is the…

Q: 2. A copper rod is 3 m long and 4 mm diameter. Compute its resistance if the resistivity of the…

A:

Q: A separately-excited d.c. motor is supplied via a half-control full-wave single-phase rectifier…

A: Separately excited DC motor:-In this type of motor supply is given to field and armature winding…

Q: Q1/ Find lo for the circuit shown 200,260 502 -130 HE e 120 127 140 I 1022

A:

Q: For the circuits shown in figures 1 and 2:- What is the function of output? 2. Find the max. and…

A:

Q: A saw mill uses 150 MW of thermal power with an electrical conversion efficiency of 18%. The sawmill…

A: The electrical energy is needed for an application to work, if there is no looses the efficiency…

Q: A 3-Phase 10Kva, 400 V, 50Hz star connected alternator supplies a rated load at 0.8 power factor…

A:

Q: connected

A:

Q: 10V, 1kHz signal is applied to a 10mH coil with negligible winding resistance. Determine Q (Reactive…

A: We need to find reactive power for given circuit

Q: 1.1.3 Sketch the signal y(n)= x(n+1)[8(n+3)+8(n)+8(n-3)].

A:

Q: Findi- fouriar series Using 1 Plot the amplitude spectrum Determine the total Power 3 Find the value…

A: Fourier series:

Q: Q1 Plot the amplitude spectrum and the phase spectrum for the signa X(t)= 2+ 3 sin (200m t) + 4…

A:

Q: Show how using p-n-p transistor connected in common-emitter configuration it can be used as an…

A: The Common-Emitter transistor configuration is used as a amplifier in applications like Audio…

Q: A non-linear pressure sensor has an input range of 0 to 10 bar and an output range of 0 to  5 V. The…

A: Input Range           0 to 10 bar Output Range        0 to 5 volt Output voltage @ 4 bar- 2.20 volt…

Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…

A: In this question,  We need to determine the current supplied by the voltage source using the super…

Q: Chimney height is 55 m, Solar Collector diameter is 30 m • Solar energy conversion efficiency into…

A: Given data, Diameter of solar collector=30m The efficiency of the PV module=40% Vmax=12V Imax=4A…

Q: Consider an a.c circuit supplied by 220V at 50Hz. The circuit consists of only two inductors, L1 and…

A: Capacitive reactance inversely propotional to frequency  Inductive reactance directly proportional…

Q: Q1/ Determine the Mesh Currents (1₁ and 1₂) for the circuit shown below

A:

Q: مصدر تیار ma ۸۸ 12kn 10k2 RE = Sk2

A:

Q: find transfer function YS/RS for this blok diagram

A:

Q: In RC circuit if R=2002 and C=50μF, then the time constant T for the circuit is * O 1μs 2μs 2ms 1ms

A: Given data, Resistance R=20 Ω Capacitance C=50 μF

Q: 5. Determine the value of Rs required to self-bias a p-channel JFET with loss =25mA and VGS(off)…

A:

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: Given data The RMS voltage 20 V The maximum positive amplitude is 10 V maximum negative amplitude -5…

Q: Problem 7: Consider the following circuit of three resistors (R₁, R2, and R₂), with batteries that…

A: (a) The circuit is shown below:  Applying K.V.L in the top loop,…

Q: The sinusoidal voltage v= 200 sin(2m1000 t -60°) is plotted in the figure. Determine the time f 200

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A three-phase power source delivers a power of 30KVA at a lagging power factor of 0.6 to a…

A: Given:Power, P=30kVAPower factor=0.6Phase voltage, Vph=100V

Q: d the Current Io. In figure (2). IMA 2mA Ika m Ika Iy 2KA m In 12 lkn Is 13 lkn 6mA

A:

Q: For the circuit shown below, derive the amplifier gain. Vo V₂ - V₁ V₁ Find the current I if: V₁-2V,…

A:

Q: ind the Current Io. In figure (2). Чта 2mA IT Iks Iz 31KR IY 2km Slkr 4 Io Is Fig.2 lkn 16 MA

A: The circuit given as

Q: In the RC circuit below, Vs=12, R =43k2, and the capacitor =71 µF. if, initially, the switch is at…

A:

Q: Calculate the phase and line voltages of three phase star-connected 4 pole small alternator having a…

A: Given data, The total flux is 0.30 Wb. The relative speed is 1500 rpm The number of pole is 4. The…

Q: a) Derive the formula for total voltage and impedance for series RL circuit. Find the equation of…

A: Diagram of series RL circuit is given by,

Q: For the circuit shown in the figure, determine the value of RL. What will make the Zener diode reach…

A: The given circuit is

Q: Obtain the control word for the following configuration of the ports of 8255 for: Mode 0 operation…

A:

Q: 3 For the bandpass filter shown in Fig. P14.18, find (a) wo, (b) fo, (c) Q, (d) wc1, (e) fc1, (f)…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: The cable is subjected to a uniform loading of Determine the maximum and minimum tension in the…

A: Given  length L = 80 ft height h= 8 ft weight w= 300 lb/ft

Q: Identify the n-channel D-MOSFET

A: The MOSFET is a power electronic switch. Based on channel it is classified as the N-channel MOSFET…

Q: find the inverse laplance tranformation of s^2/(s^2+9)(s^2+25) using convalutionn theorem

A: In this question,  We need to determine the inverse Laplace transform of the given system.

Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…

A: Given circuit, Determine the current supplied by each voltage source using superposition.

Q: . If a system function has zeros at the origin of the z-plane then the system function is a proper…

A: Inverse Z transform is the process of finding the time domain from its z transform .In the inverse Z…

Q: Find (IR) through resistor R = 2 k ohm.using Norton's theorem.

A:

Q: Q4. A 200KVA single phase transformer with a voltage ratio 6350/660 V has the following winding…

A: As per Bartleby policy we can answer only three subparts. So I am solving first three for you.…

Q: 1- Find the amount of electric flux enclosed in a cylinder with a radius of 8 cm and length of 20.8…

A: σ = 12 nCm2l = 82-12l = 7.937by using gauss low flux enclosed in a cylindrical due to charge sheet…

Q: Determine the value current supply (IT) in figure (1). Fig.1 lon. lons 55 n ·lon Slove IT 24V VT

A: This problem comes under electrical circuit theory . It is  based on star delta conversion of…

Spherical Coordinate System

The spherical coordinate system is a three-dimensional coordinate system for space where the position of a point is specified by three numbers- the radial distance of that point from a fixed source, its polar angle measured from a certain zenith, and the azimuth angle. Its orthogonal projection on the reference plane passes through the source and is measured from the direction of constant reference on that plane which is orthogonal to the highest level. It can be viewed as a three-dimensional version of the polar coordinate system.