The sinusoidal voltage v= 200 sin(2m1000 t -60°) is plotted in the figure. Determine the time f 200

Q: (a) A system consists of two components that can be presented by the respective h₁ (t) =…

A: GIVEN:                  h1(t)=3000e-20th2(t)=t e-10tu(t)                input voltage of the system…

Q: What is the velocity of an electromagnetic wave in free space?

A: In this case, the velocity of an electromagnetic wave in free space is to be determined.

Q: For 3G cellular data networks, what function does the RNC (Radio Network Controller) play?

A: RNC represents Radio Network Controller. The function RNC plays in this architecture is to control…

Q: Vs Rsig CG V₁ G RG O Draw the equivalent circuit. DD Ro S Rs Cs RL Vo

A:

Q: a. What direction does the magnetic field point (cw or ccw) and what is its approximate magnitude…

A:

Q: Q3/ For the circuit shown find (a) Equations for 1₁ and 1₂ with respect to V₂ (b) The value of V₂/Vs…

A: It is given that:

Q: 41) A logic gate draws 10mA when its output is HIGH and 20mA when its output is LOW. When operating…

A: Given data, When output is high current is 10 mA When output is low current is 20 mA Duty cycle D =…

Q: If the loop of wire is repelled by the long, straight wire in the illustration below, what is a true…

A: Given: Loop of wire is repelled by the straight wire

Q: Q1/B/ Sketch the design flow chart for the cooling power electronics microchips.

A: Cooling power electronics microchips : Cooling power electronics microchip is a device which is used…

Q: Apply Norton theorem to calculate the current in 62 resistance for the ircuit in figure 3 2001 55…

A: We need to find out the current through the given resistance by using of Norton Theorm

Q: If two resistors with resistance 6.0 Q and 8.0Q are connected in series with 12.0 volt source, then…

A: Given, Two resistors with 6 Ω and 8 Ω resistance are connected in series. R1=6 ΩR2=8 Ω Source…

Q: Q5] find the current of the resistance 180 if the value of the source is 7.4sin(100ft-44) volt Give…

A: 5) To find the value of current flowing through 18 ohm resistor in the circuit

Q: Determine the I.D.F.T

A:

Q: Find the Current Io. In figure (2). 4mA 2mA II, Ika wm 12₂ lkn Iy 2km m 4 Io lkn Is Fig 2 6V Ikm

A: The circuit has given.

Q: 1. For the network given on Figure 44, determine the IpQ, VGSQ, VDs, and Vs. + VGSQ 18 V 2.2 ΚΩ IDQ…

A: We need to find current and voltage for given circuit

Q: A 6-ohm resistor is connected in parallel with a

A: We can solve this problem using current division rule.

Q: B 36v R₁ MM I C 32 1 arrat 5) Energy passing used 4.22 1+T₂ ww JOV A using Kirchhoff's current and…

A: We need to find out the current through each resistor

Q: Consider the circuit in Fig. 16.12(a). Find the value of the voltage across the capacitor assuming…

A: given data, Vs(t) = 10u(t)

Q: A solenoid coil has a resistance of 30 Ohms and an inductance of 0.5H. If the current flowing…

A: In this question,  We need to determine the voltage V and phase difference between voltage and…

Q: a. Find VL, IL, Iz, and IR if RL is 180ohms. b. Find the value of R₁ that will stablish maximum…

A: We need to find out current and resistor for given circuit

Q: a) Derive the formula for total voltage and impedance for series RL circuit. Find the equation of…

A: Diagram of series RL circuit is given by,

Q: 1. x[n] contains 128-point samples obtained through sampling continuous-time signal x (t) with…

A: Continuous time signal is define the real line time. It is also called a analog signal. that is…

Q: B- Compare between circuit switching, message switching, data gram packet switching and virtual…

A: Switching : Switching techniques involves a specific message which is to be transferred from initial…

Q: A variable capacitor is connected in parallel with an impedance coil having a resistance of 30 ohms…

A: 1) Given a variable capacitor connected in parallel with an impedance coil havin resistance and…

Q: Instructions Draw a double-layer, short-pitch (5/6),distributed lap- winding for a 3-phase, 4-pole.…

A: To Draw a Winding diagram of the given alternator, few points can be discussed as follows, Topmost…

Q: Which of the following loss is the main reason for not using the solid transformer core? O…

A:

Q: Q1] find the current of the inductance 0.04H if the value of the source is: 3sin(100πt+30) volt…

A:

Q: Q2. For the electrical circuit shown in Figure A2, 122 ww 6Ω A Note: The valve P=(Right 16 V RL=652…

A:

Q: Three identical impedances of 15Ð60°W are connected in star to a three-phase, three-wire, 240 volt…

A:

Q: Q5/ For the below system -1 0 21 [x1 ГО 4-6-8- = 3 1 02+0 u 1 1 y = [1 0 0] X₂ [x3. A-Obtain the…

A: Transfer function: It gives the information of the system input and output. With the help of the…

Q: In the RC circuit below, Vs=12, R =43k2, and the capacitor =71 µF. if, initially, the switch is at…

A:

Q: 033 Consdier the following Control System Diagram: a) Where are the Open Loop poles of the system?…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: 8. What is the primary difference between the BJT and the FET? a. current-controlled device and…

A: From the given options we need to determine the primary difference between the BJT and FET. BJT: BJT…

Q: Apply Norton theorem to calculate the current in 6 2 resistance for the circuit in figure 3 2000 +…

A: In this question,  We need to determine the current in the 6 ohm resistance using the Norton theorem…

Q: VD (V) ID (mA) ID as shown in the following table: 0.66 3 0.7 11 0.735 18 a) Determine the statistic…

A: As per the honor code I will do first three parts of the question. Kindly repost the other questions…

Q: In the circuit, find the value of Z that will absorb the maximum average power and the value of the…

A:

Q: (a) For an electron mobility of 500 cm²/V·s, calculate the time between collisions. (Take mn = m0 in…

A: It is given that: μ=500 cm2V.sE=100Vcm

Q: 50........is a photodetector that need lower biased voltage. O a. PIN. O b. Traditional Diode. O c.…

A: Photodetectors

Q: Calculate the phase and line voltages of three phase star-connected 4 pole small alternator having a…

A: Given data, The total flux is 0.30 Wb. The relative speed is 1500 rpm The number of pole is 4. The…

Q: Determine the value current supply (IT) in figure (1). lon { lons Sn ·lon Slov (+1) IT 24V VT

A: To determine the total current (IT) flowing through supply voltage ( VT )

Q: 29. A series R-C circuit takes a current whose equation is i = 0.85 sin (754t + */4) when connected…

A: 29. (a) The current and the voltage of the circuit are known, and the impedance of the circuit is…

Q: Find the Current Io. In figure (2). 4mA 2mA II, Ika wm 12₂ I kn Iy 2km m 4 Io lkn. Is 6V Ik 6mA

A:

Q: A 3-Phase 10Kva, 400 V, 50Hz star connected alternator supplies a rated load at 0.8 power factor…

A:

Q: Q5:- Find the Norton's equivalent circuit for the network external to the resistor R of the networks…

A: This question belongs to circuit theory.  It is based on the concept of Norton's equivalent circuit…

Q: Q1/ For a LTI system, drive the frequency response, if you know that the input is: r(t) = M cos(wt +…

A: (1) When any system is subjected to sinusoidal Input, the output will be Sinusoidal having different…

Q: For the following diagram, match each part of the DC motor to the correct label. Determine the…

A: Dc motor convert the Dc electrical power into the mechanical power.   The circuit of the dc motor is…

Q: 8. Which one of the following pitches is the minimum recommended pitch for a 24-pole motor with 360…

A: Given a motor with, Number of poles = 24 Number of slots = 360

Q: A 10 V, 1.5 kHz AC voltage source is connected to a series RC circuit where R=2.2kΩ & C=0.02 μF. a.…

A: In this question,  We need to draw the phasor domain of the circuit, impedance diagram and phasor…

Q: Figure P14.33 R Vi C L Vo RL The parameters in the circuit in Fig. P14.33 are R = 2.4 k, C = 50 pF,…

A: The quality factor of the parallel RLC circuit is,  QP=R2CL The quality factor of the above-loaded…

Q: I- Q3: 1- How much resistance is required to limit the current to 1.5 mA if the potential drop…

A: 3) (1) To find the value of resistance that limits the current to 1.5 mA if the potential drop…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.