25- W resistor, a 300-mH, and a 40-µF capacitor are connected in parallel across a 120-V, 50-Hz source. Determine the magnitude of the following: (a) admittance; (b) current through resistor, inductor, and capacitor; (c) the total current

25- W resistor, a 300-mH, and a 40-µF capacitor are connected in parallel across a 120-V, 50-Hz source. Determine the magnitude of the following: (a) admittance; (b) current through resistor, inductor, and capacitor; (c) the total current

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: 15 Referring to Fig. 59, determine the phase an- gle between the following phasors and, in each…

A: Phasor is the rotating vector used for the representation of the quantities such as voltage,…

Q: Find the transfer function, Vo(s)/V¡(s), C₂ = V(1) C₁= 6.8 uF www R₁ = 360 ΚΩ R₂= 220 ΚΩ www 0.22 UF

Q: 4. When driven at 1000 r.p.m. with a flux per pole of 0.02 Wb, a d.c. generator has an e.m.f. of 200…

A: We need to find out induced emf for given generator

Q: A resistor of 25 ohm is connected in series with a capacitor of 45μF. Calculate the impedance, and…

Q: /A+B=L A B e A+B=L 2 Dº B 8 0 L

Q: 6) How many Watts is -4.2 dBm?

A: Decibel milliwatt (dBm) is a unit to represent power in decibel (dB) with respect to one mill watt.…

Q: A magnetic ring has reluctance of 1.675 x 106 AT weber. The flux to be produced by the coil is 800 x…

A: Given a magnetic ring has, Reluctance = 1.675×106 ATweber Flux = 800×10-6 weber.

Q: A pipe contains an oil of specific gravity 0.9. A Differential manometer Connected at the two points…

Q: 16 V 510 kQ2 IBQ 7.25V 7.52V 9.25V 9.52 V Ico 1.8 ΚΩ O Vc VCE B=120 VE

A: We need to find out the collector Voltage for the given circuit

Q: A 3-phase star connected 1000 V alternator supplies power to 500 kW delta- connected induction…

A: It had been given that the alternator is star connected and the motor is delta connected. Line to…

Q: Determine vo for the circuit shown Vo

Q: Produce a graph showing current I against the diode voltage VD. - Current (ID) vs Voltage (VD)

A: The above tabular information shows the characteristics of the diode in forward bias condition…

Q: Problem 6 For the following circuit, find the Thevenin equivalent resistance RTH looking into…

Q: A battery is connected to a resistance causing a current of 0.5 A in the circuit. The current drops…

A: Given- i1=0.5 A,i2=0.4 A,i3=0.2 A,R=5 Ω, To Find- The increased resistance.

Q: 1 = 602-40° A E = 120/20⁰ V

A: We need to find out the reactance for given current and voltage

Q: L OD m m 34 1 Fig. 9 Q15) For the circuit shown in Fig. 9, the equivalent inductance Leq is: a) 1/2…

Q: Consider the circuit shown in (Figure 1). Suppose that is = 6.5 A. Figure i, 0 + V130 12 Ω ww 2/20 1…

A: This is a problem of circuits. The solution is given in the next step.

Q: of Fig. 12 for the following questions (Q20 d) 15 V e) 24 V Q20) (0) can be found as: a)30 V b) 12.5…

A: We need to find out the voltage across capacitor

Q: 200v J25A ť ㅇ느 풍 V (E) _ ) VP I Ples= P(t) dt 류 UpIp lavo To 나들 ㅇ avp IDL에 aup Isla-음) 앞ㅋㅋ 외ㅛㅋㄱ죠 옴…

Q: 1) A User uses 361,588 KWh in the 365 days of the year. Your demand for 18 minutes was 118 KW. a.…

A: Given: Number of units consumed in an year= 361588 kWh Consumer demand for 18 minutes was 118 kW

Q: A 500 A/5 A, 50 Hz current transformer has a bar primary. The secondary burden is a pure resistance…

A: We have a current transformer which has a bar primary . CT ratio = 500 / 5 A frequency (f) = 50 Hz…

Q: f(t)=29u(t-1) + t²u(t - 4) - (10-t²) u(t - 9) Sketch the graph of f(t). State any point of…

Q: List 6 parts of Multimeter including each corresponding function.

Q: 9) a. Use DeMorgan's Theorem to simplify the following Boolean equations: Y = ABCD b. Y= ABCDE C.…

Q: In the circuits shown, the directions of current and the polarities of voltage have already been…

A: Given circuit:

Q: Needit ASAP

A: Given that Frequency = 60 Hz Peak Voltage Vm = 250 V Angle θ = 105° We have to determine the…

Q: Write the ST language equivalent of the attached ladder circuit. Stop Start HH Motor HH OverLoad…

Q: What is the capacitance when Q = 60 μ C and V = 12 V? A. 720 μ F Β. C. D. 5 με 50 με 12 μF

A: Given data, Charge Q=60 μC=60×10-6 C Voltage V = 12 V

Q: b- Using physical equations, is the number of photons in one joule of red light greater than, equal…

A: I am answering second part of this question because first part comes in other part. Given that w…

Q: A 3-phase star connected 1000 V alternator supplies power to 500 kW delta- connected induction…

A: Given- 3-Phase star connected 1000 V alternator, motor output=500 kW, motor efficiency=0.9, power…

Q: What is the frqcy of recovered signal? Is is the same with information and carrier signal? Please…

A: According to the question, for the given diagram as shown below, We need to find the frequency of…

Q: Discuss the procedure of installation, direction of testing to be done, and the commissioning of the…

Q: (a) L-1 Determine 7s s² +4 (b) L-1 4s s² - 16

Q: Given a closed-loop single-input single-output system x(t) Ax(t) cTx(t) y(t) The system is…

Q: Q7) The current i(t) of Fig. 4 can be found as (mA): a) 12.5cos(500t - 0.107°) d) 12.5 cos(500t +…

A: Given, The circuit shown in figure 4 is shown below,

Q: A 3 phase, 4 pole, 22 kV 20,000 kVA alternator has neutral earthed through a resistance of 14 km The…

Q: In the circuit shown in Figure, the switch S is closed at time t = 0. the voltage across the…

Q: 8. An 8-pole lap-wound d.c. generator has 120 slots having 4 conductors per slot. If each conductor…

A: Given information about a DC generator is, The number of poles P=8. Number of slots S=120.…

Q: For the magnetic circuit shown, the air gap cross-sectional area is 0.004 m², the air gap length…

Q: List 6 parts of Multimeter including each corresponding function.

A: Multimeter parts and its function.

Q: 1- In an alternator, the armature reaction influences the magnitude of Wave form of generated…

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: Consider the digital controller defined by: Y(s) 2+2.2z¹+0.2z-² X(s) 1+0.42-1-0.12z-² Draw a series…

Q: a) In an alternator, the armature reaction influences the magnitude of Wave form of generated…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 6) How many Watts is -4.2 dBm?

A: We have been given an value of power which is dBm as, -4.2 dBm now, We have been asked to find…

Q: A 6-pole asynchronous motor operating is on a 60Hz network. What will be the rotor speed if slip is…

Q: With reference to the circuit shown in the figure (a) let v, = 40V, 40 and find v; (b) let v, OV, I,…

Q: Q8/Chose the correct data input for 2-1 multiplexer that used to Design the switching network F F(A,…

A: Multiplexer is many to one device, i.e., multiple input lines will be sent by a common output line…

Q: The repeated tripping caused by the tendency of GFCIs and AFCIs to trip frequently due to its…

Q: Two capacitors,a 20uf and a 30uf,are connected in series. What is the total capacitances?

A: We need to find out equivalent capacitance for given capacitor

Q: what is the inverse laplace transform of (2^-s)/[s(s^2+1)] ?

Question

PLEASE SHOW YOUR DETAILED SOLUTION. WILL GET A LIKE

A 25- W resistor, a 300-mH, and a 40-µF capacitor are connected in parallel across a 120-V, 50-Hz source. Determine the magnitude of the following: (a) admittance; (b) current through resistor, inductor, and capacitor; (c) the total current; (d) true power, inductive and capacitive reactive power; (e) apparent power, power factor, and power factor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Follow-up Questions

Read through expert solutions to related follow-up questions below.

Follow-up Question

PLEASE ANSWER LETTERS D & E

A 25- W resistor, a 300-mH, and a 40-µF capacitor are connected in parallel across a 120-V, 50-Hz source. Determine the magnitude of the following:

(a) admittance;

(b) current through resistor, inductor, and capacitor;

(d) true power, inductive and capacitive reactive power;

(e) apparent power, power factor, and power factor.

Solution

by Bartleby Expert

SEE SOLUTION

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor?
A)For the inductive element of Figure 2 , the voltage and current in phasor form is B)the value of impedance and capacitance for capacitor in figure 2 is
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
Step 1 : Show that the voltage division rule for two capacitors in series as in the figure Step 2: For two capacitors in parallel as in the second figure, show that the current division rule is:
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
Find the equivalent inductance as seen from the terminals shown in the figure.