lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit length of 1μH/m. The load impedance ZL is purely resistive. Both the load impedance and the generator impedance are 50 Ohms.The generator frequency is 12.5MHz. the propagation constant β and wavelength λ equal to? a)π/5 , 10 b)π/5 , 15 c)π/3 , 15 d) π/6 , 8

lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit length of 1μH/m. The load impedance ZL is purely resistive. Both the load impedance and the generator impedance are 50 Ohms.The generator frequency is 12.5MHz. the propagation constant β and wavelength λ equal to? a)π/5 , 10 b)π/5 , 15 c)π/3 , 15 d) π/6 , 8

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem 13.8P

See similar textbooks

Similar questions

A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
One circuit of a single-phase transmission line is composed of three solid 0.12" radius wires. The return circuit is composed of two 0.15" radius wires. Find the inductance of the complete line in mH/mi. The distance between wires are 40" horizontally and 25" vertically. A. 2.54 mH/mi B. 2.478 mH/mi C. 2.488 mH/mi D. 2.567 mH/mi Provide Clear Explaination
Each phase of a transmission line is a bundle of 4 conductors that form a square with all sides equal to d=33 cm. Each conductor is stranded and has GMR = 0.5 cm. Find GMR of the bundle to be used in inductance calculations. Express your answer in cm with 2 digits after decimal point
Paragraph Styles The power factor must be close to in the transmission lines will be reduced To insure that losses D(Ctrl) -
4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLY
A lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit length of 1μH/m. The load impedance ZL is purely resistive. Both the load impedance and the generator impedance are 50 Ohms. the characteristic impedance and the propagation velocity
The 50 ohm transmission line isterminated with an unknown load. The magnitude of the reflection coefficient is R=0.5.Thedistancebetween the voltage maximum and the load is0.15 lambda. What is the imaginary partof the load impedance?
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
Electrical Engineering A lossless transmission line has a capacitance per unit length of 90 uF/m (microFarad/meter) and an inductance per unit length of 1 nH/m. The load impedance ZI is purely resistive. Both the load impedance and the generator impedance are 50 ohms. Source voltage amplitude is unknown at this point. Find the characteristic impedance and the propagation velocity for this transmission line!
q) Phase velocity of voltage wave in a distortion less line having characteristic impedance 0.2 kΩ, velocity 0.5*108 m/s then the value of capacitance per meter?
A 10 km long three phase line having a diameter of 2.5 mm conductors is arranged symmetrically with a spacing of 2 m. So find the inductance per phase and capacitance per phase.
g) Why the Capacitance effect is neglected in Short Transmission Line.