It is required to connect active and capacitive reactive mechanical meters that will measure the electrical energy used in a stone crushing quarry that consumes more than 50KVA. Show the connection diagram of these meters to the three-phase line coming from the network by drawing a figure.

Q: The length of a three-phase power transmission line with a nominal operating voltage of 69 kV is…

A:

Q: 1.The primary conductor in the figure is one phase of a three-phase transmission line operating at…

A:

Q: Q5. A symmetrical T-network has a resistance of 750 0 at each series arm and 250 a at the shunt arm.…

A:

Q: A short line having an impedance of (2 + j3) ohm interconnects two power stations A and B both…

A: Without booster, We can draw the power plant as PR=25MWQR=PRtancos-10.8QR=25tancos-10.8…

Q: Q3: Draw the sequence networks for the system shown in Figure below. What are sequence impedances?…

A: There are 3 types of sequence impedances which are positive sequence, negative sequence and zero…

Q: a) A 345 kV, three phase transmission line is 100 km long. The resistance per phase is 0.033 2/km…

A:

Q: What is the steady-state load current (it) in the transmission line circuit shown below?

A: Answer: c 0.3A Explanation: a. It is not a valid option. The total resistance should be 50ohms to…

Q: α=4 β=4 For the adjacent circuit, Vab=(400+5β)V is given and the source part is balanced. Since it…

A: Line voltageVab=420∠0°VVbc=420∠-120°VVca=420∠120°VPhase…

Q: In a three phase overhead system , each line is suspended by a string of three insulator. The…

A:

Q: Draw a single-line positive-sequence network of this simple power system. Use the nominal-n circuit…

A: There will be three sequence networks in the given power system- Positive-sequence network…

Q: Please use NODAL ANALYSIS to solve for the breanch currents thank you. Show clean and complete…

A: The given circuit is as shown below,  We need to find the branch currents I1, I2, I3, I4, and I5.

Q: The single line diagram of a power system is shown below. Load represented as impedance, (13.2) kV…

A: Given: The single line diagram of a power system is shown below: Load represented as impedance,…

Q: Find the equivalent resistance per phase for the following three-phase load-balanced arrangements,…

A:

Q: Phase a of a 3-phase system is given by, ean = 155.56cos(377t)V. There is a balance load comprised…

A: In this question,  Phase a voltage is given. Ean = 155.56 cos(377t) V Balanced Delta load is given…

Q: Find the equivalent impedance for the a-phase, the a-phase current, and the a-phase line voltage for…

A:

Q: A balanced three-phase A-connected supply delivers power through a three-phase wire in an industrial…

A: NOTE: Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: hown below, By using Nodal Analysis, find R,

A:

Q: For the given 3-phase power transfer, a star system is associated with a greater insulation.…

A: The insulation for 3 phase does not depend connection.

Q: . Calculate the line currents for phase a, b and c. 2. Calculate the line-to-neutral voltages at the…

A: From the given circuit  Van = 120 ∠0 V V bn = 120∠-120 V  V cn = 120 ∠-240 V  R a=R b=R c=…

Q: The sample large power system network  data's  are  given below, The total number of buses  is 5…

A: There are two types of symmetrical faults: a) Three-phase short circuit fault. b) Three-phase to…

Q: Q: Prove that the capacitance of 3-ph overhead line (with the effect of ground) is given by: 2πε Cn…

A: Solution- Effect of earth on capacitance- The method of images is used to determine the capacitance.…

Q: A. Measure the current through and voltage across the load on PR1. Calculate also the complex power…

A: Given V= 25 V rms f= 60 Hz ω=2πf =377 rad/sec V=2 ×25 ∠0  =35.355 ∠0°  V   converting inductance and…

Q: With the aid of the table for the formulas in three phase systems, solve the following problems by…

A: According to question: The circuit diagram is drawn as

Q: The sample large power system network data's are given below, The total number of buses is 5…

A: Given data The total number of buses are 5 Three-phase short circuit fault subjected at the bus 5…

Q: Derive, for both star- and delta-connected systems, an expression for the total power input for a…

A: For the connected star system, Line voltage is 3 times the phase voltage and lines current, and…

Q: Q2 Two single-phase voltage sources, V1 and V2 are connected by parallel line impedance of Z11 = 1+…

A: In this question we will find current supplied and recieved by voltage sources  and real and…

Q: For the 3-phase, 3 wire system below. Compute for the line currents, total real power, total…

A: Power factor: The power factor tells how much active power is utilized by the circuit from the…

Q: Find the total impedance, total current drawn by the system, total power (apparent) delivered by the…

A:

Q: The reactance diagram of the power system network is shown in figure below, where the impedance is…

A:

Q: A three-phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure…

A: Transposed line: It is an arrangement of conductors. In this conductors are periodic changes its…

Q: In a three phase overhead system, each line is suspended by a string of three insulator. The…

A: In a three phase overhead system, each line is suspended by a string of three insulator. The…

Q: low voltage systems In the circuit given below, single-phase powers connected to the single-phase…

A: V= 220 at angle 0°  Load 1 is capacitor and load 2 is inductor  Then

Q: 5. Determine the value of the IR, ly and Is currents in the circuit shown in the figure using a mesh…

A:

Q: What are the types of connections in three phase load, which connection is best? Justify your…

A: Four types of connection we have for three phase transformer- Y-Y- This is used for small, H.V.…

Q: To demonstrate the theoretical method of transforming delta networks to wye network, or vice-versa.

A: As per company guidelines, only the first question will be solved. If any other solution is needed,…

Q: Note: It is expected from student to develop impedance matrices of three phase power system. Develop…

A:

Q: The sensitivity of a node to real power changes is 100 MW/kV of line voltage and that to reactive…

A:

Q: Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω are…

A: The given data from the question is as follows: Inductance=200mH, Capacity=50μF, Resistance=10 Ω…

Q: Vs 3Ω j4 N Vc 3Ω j4 N VR Is Ic IR 80 Ω j 5-106 siemens j60 N

A: Given that the receiving end end voltage is 154 kV. Therefore, the two port network parameters A and…

Q: Consider the following three Phase balanced Circuit 210 20⁰ Vrms jasn 210/120⁰ Vrms 24-321 jost mm…

A: The three-phase delta connected load is shown below:  The per-phase equivalent load impedance will…

Q: If value of voltage Vs is 20kv and VR is 15 kv with load angle of 20 degrees. Value of line…

A: Given values are - VS=20kVVR=15kVδ=20oX=5Ohm

Q: For the given power transfer, a star system is associated with larger line currents and a delta…

A: Given statement, For the given power transfer a star system is associated with large line currents…

Q: USING NODAL ANALYSIS SOLVE THE CURRENT THROUGH EACH IMPEDANCES.

A: In this question,   We need to determine the current in the each Impedance using the nodal analysis?…

Q: power

A: In this question, we have to answer about reactive power..

Q: Two branches connected in parallel have impedance 120+j180 ohm and 150-j130 oh Determine the branch…

A:

Q: Given the circuit shown below, if Zx = 100<0degrees determine the current in each branch using NODAL…

A: NOTE: Unit of Zx is not given. we assumed it as ohm. We assumed nodes and current directions on the…

Q: A parallel combination of a 24- ohm resistor and a 32-ohm inductor will result to a total impedance…

A: In this question we will find vertical component of impedamce of parallel RL circuit....

Q: The single line diagrams of interconnected power system show: Select one: a. All the network…

A: Choose the correct option The single line diagram of interconnected power system show?

Q: In a three-phase balanced star connected system, the phase relation between the line voltages and…

A: We will draw phasor diagram of the star connected system showing phase voltages and line voltages.…

Q: Assuming the voltage at the utility bus is 13.5 kV and the PV plant supplies 4.8 MW of power at 0.95…

A: