hi tutor plz solve this problem with detailed explanation. In magnetic circuits, the core is often made of laminated magnetic material.What are the benefits of using a laminated magnetic core? Select ALL that apply:1. Laminations reduce the effective cross section of material which eddy currents form in2. Laminations work better for high frequencies3. Eddy current losses are decreased by the inclusion of laminations4. Eddy current losses are increased by the addition of laminations in the core5. Core losses are better reduced by phase shifting the input voltage by 180 degrees

it is asked to select the benefits of using a laminated magnetic core

Answered: In magnetic circuits, the core is often…

In magnetic circuits, the core is often made of laminated magnetic material. What are the benefits of using a laminated magnetic core? Select ALL that apply:

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Related questions

Q: In Y-Y three-phase system, the following loads are served by a balanced source: Load #1: 20 kVA at…

A: This problem is from basic of power system phasor analysis. The solution is given in next step.

Q: A three phase, 50Hz, 66kV overhead line conductors are arranged at the corners of a triangle of…

Q: 3. Define a piecewise formula for the following f(t) signals like you would for solving for the…

A: Given: In this question, the given details are, Here, to define a piecewise formula for the…

Q: Name: EE 206 Test No.3 Make-up Fall 2022 B. Braaten Give complete solutions. Closed book and closed…

Q: Exactly what does a Voltage Event Recorder keep track of?

A: Given: Voltage Event Recorder. Required: what does a Voltage Event Recorder keep track of?

Q: En el circuito de la figura, calcular: a) Tensión en bornas de R3 y R6. b) Potencia en cada…

A: The mesh current can be calculated by using the mesh analysis and the current can be used to derive…

Q: 2. Describe the action of the circuit shown in figure-2 below a. Vin RE -O+Vcc SPEAKER

A: The given circuit diagram is shown below. We need to discuss the action of this circuit.

Q: Use current division principle in getting I1, I2, I3

Q: A 3-4, 50 Hz, synchronous generator has rating 150 MVA. The kinetic energy of the machine at…

A: Given- 3-ϕ, 50 Hz, synchronous generator rating 150 MVA, Kinetic energy KE = 600 MJ, Power P = 40 MW…

Q: A negative unity-feedback LTI system has a forward element consisting of an amplifier with…

A: Given data Magnitude and phase plot of the Bode plot is given in the question. From the above two…

Q: Problem 7.5 (a) The magnitude and phase of X(jw) the Fourier transform of r(t) are shown below. +IX…

Q: 1. For the following circuit assume re 30.6 Ω a. Draw the small signal equivalent circuit. b. Find…

A: It is given that:

Q: 2. A full-wave bridge rectifier is operated from a 50 Hz, 220 V rms line. It has a 100 µF filter…

Q: Suppose that an error occurred during the transmission of the 7/4 Hamming Code 1110111 of a binary…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: a) Explain the operation of the controlled full-wave bridge rectifier shown in figure 3. b) The…

A: Given data Full-wave bridge rectifier contains a source voltage of Vs=120 V. Supply frequency, f=60…

Q: A rectangular loop is moving with constant velocity U, as shown in the two figums below g, 100 and…

A: (a) The circuit is shown below: The current-carrying wire produces a magnetic field around it.…

Q: b) 1) Design (Find R₁, R2, and R3) a voltage-controlled-oscillator (VCO) that has the output change…

A: Since, the question posted by you has multiple sub-parts, we will solve the first three sub-parts…

Q: 2.-Discuss the difference between the terms “sink” and “source” as related to current loading of a…

A: Micro controller: Micro controller is a small or compact integrated circuit which is used to design…

Q: An RC circuit has an emf given (in volts) by 400 cos 2t, a resistance of 100 ohms, and a capacitance…

A: The capacitor is passive element. It store energy in form of electric energy. Capacitor opposes…

Q: Three single phase transformers are connected in a Delta-Wye configuration. Each transformer is…

A: Given data Three transformers are connected in ∆-Y. Voltage rating of each transformer,…

Q: QUESTION 1 a) b) c) Define briefly the terms ionization and electron-hole pair (EHP). Draw the…

Q: 4. a) A communications link between two towns 38km apart is required to operate at a bit rate of…

Q: Q-A 500 MW, 21 k V, 50 Hz, 3-phase 2 pole synchronous generator having unity power factor has a…

Q: a) Draw the basic topology of a buck converter. b) Design a buck converter to produce an output…

Q: Three capacitors, a12mf,a 20mf and a 30mf,are connected in series. What is

Q: ries AC circuit is composed of a 75 Ohms resistor, 25 mH inductor and a 0.02 μF capacitor. The…

Q: 7 Let Vab_c be the voltage when R17 is connected and Vab_d when R17 is disconnected, find these…

Q: The typical home uses 10,632 kWh per year. If there are 20,000 homes in the city, how much…

A: Given, A typical home uses of energy, E = 10,632 kWh per year.If the city having N=20000 homesThen…

Q: Problem Statement: A combinational logic circuit is to be designed to implement the multi-function…

Q: Question # 1: For a unity feedback system with a forward transfer function: G(s) = K/[s(s+50)(s +…

A: The required DC gain can be calculated by using the bode plot and the required phase margin can be…

Q: Example 3. The switch in the circuit of Figure 7 has been closed for a long time, and it is opened…

Q: 3. The frequency response magnitude plot for a particular circuit is shown in Figure 3 below, with…

Q: To convert the decimal number 30 to a 8-bit binary number, use the following representation methods:…

A: Binary number is represented by 0 and 1. Decimal number have base 10. The positive signed number is…

Q: INPUTS Maximum Fuel Temperature Bar Pressure Surge Pool Water Level BINARY VALUE 1 0 1 0 1 0 or…

A: Given: To find: The logic circuit showing all situations and truth table.

Q: 3. What is understood by the rotor standstill voltage (U20)? 4. What effect do the starting…

A: Induction motor working Principle When an ac supply is connected to a stator it creates a rotating…

Q: 3. A 10 km copper bundle of 10 mm diameter copper wires must experience a voltage drop of less than…

A: Given: In this question, the given details are, A 10 km copper bundle of 10 mm diameter copper wires…

Q: It is desired make a 1.69 µH solenoid inductor by tightly wrapping a single layer of 22 AWG wire…

A: it us asked to find the length of inductor wonded around straw to get inductance of 1.69*10-6H

Q: Problem 1. A diode has p-side doped with B to a level of 5x10¹7/cm³ and n-side doped with P to a…

A: Given: In this question, the given details are, A diode has p-side doped with B to a level of…

Q: For the circuit below with w1 = 5 rads/sec, f1=200, vg(t) = 60 cos(w1t+f1) V, R1 = 10W, R2 = 20W, C1…

A: Note: Unit of resistance are given as 'W' , we assume it as ohm. Given Vg t =60 cos ω1 t+f1 V ω1 = 5…

Q: 5. Find vo in the circuit below. V10- R₂ + R R₁ V2 R₂ ww Vo

A: Given: an op-amp circuit, To find: Output voltage v0.

Q: Problem 12.14 In the circuit of Fig. P12.14(a), u(t) is given by the waveform displayed in Fig.…

A: ramp input is given to series RLC circuit and it is asked to find current for t>=0

Q: An overhead line having the surge impedance of 400 Q is connected to a short length of cable of…

A: Given- Overhead line- Surge impedance =400 Ω, Cable Surge impedance =50 Ω, Magnitude of travelling…

Q: For the circuit below, use the phasor concept to find the voltage v, (t). isz(t) is1 (t) 10Ω www.…

Q: 5. The load on a 120-V, 60-Hz supply is 6 kW (resistive), 10 kVAR (inductive), and 4 kVAR…

A: Note: As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly repost…

Q: A 20-hp, 240-V, 76-A, 900 r/min series motor has a field winding of 33 turns per pole. Its armature…

A: DC Series motor Utilising DC motors, one can convert electrical energy from direct current sources…

Q: Problem 3C (20 points) Calculate the complex power S for all the four circuit elements. 652…

Q: 1. A 4-pole, d.c. generator has a wave-wound armature with 792 conductors. The flux per pole is…

A: The dc generator emf formula is given below.

Q: 1. A MOS capacitor is maintained at T = 300 K, the thickness of the oxide is 100 nm, and the silicon…

A: Given data, Temperature T=300 K No. of silicon atoms NA=1016 per cm3 Thickness of the oxide tox=100…

Q: Solve the current of each branch. R4=12 R5=12 W E1=0,50V R2=12 w R1=22 싸 E2=0.60V till E3=230V R3=22…

Q: Solve for T(s) using Mason's Formula Rish Gy(s) tes Gy(s) Yus

A: In this question We need to determine the transfer function of the given system using the Mason gain…

Question

hi tutor plz solve this problem with detailed explanation.

In magnetic circuits, the core is often made of laminated magnetic material.
What are the benefits of using a laminated magnetic core? Select ALL that apply:
1. Laminations reduce the effective cross section of material which eddy currents form in
2. Laminations work better for high frequencies
3. Eddy current losses are decreased by the inclusion of laminations
4. Eddy current losses are increased by the addition of laminations in the core
5. Core losses are better reduced by phase shifting the input voltage by 180 degrees

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

given data

VIEW

solution

VIEW

incorrect options

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Define electronegative gases and Compare between SF6 and 02 Insulator? Explain the different schemes for cascade connection of transformers for producing very high ac voltages?
For operation at 60 Hz and a given peak flux density, the core loss of a given core is 1W due to hysteresis and 0.5W due to eddy currents. Estimate the core loss for 400-Hz operation with the same peak flux density.
An AC source provides peak output Vi and peak current ii when connected to the coil primary of a transformer. The transformer has Np turns in the primary coil and Ns turns in the secondary coil. A resistance circuit R is connected to the transformer, see figure below. What is the equivalent resistance of the circuit?
Draw the full-wave voltage doubler circuit diagram. When a 1:4 transformer is used in this circuit andIf Vo=12sin(314t) alternative signal is obtained at the output, the frequency of the input signal, maximum and rmsCalculate its value.
UDng a ITIe Core in high frequency transformers. c- Discuss, different applications of iron cores of different hysteresis loops. d- Explain the effect of Inrush current on power transformers.
-4 poles-26 conductors-double layer-simplex wave winding Can you do this in "armature winding"? Thank you.
Q.4/ choose true or false: 1. The reluctance of any core is proportional directly with the length of it and inversely with both the permeability and the cross-section area of it. 2. The number of parallel paths in wave windings is equal to twice of the number of poles. 3. In dc machines with same values of Z, N, Ø, the emf for wave winding type is more than emf of lab winding type. 4. If we insert a current in such a conductor subjected to a constant magnetic field, a movement will achieved giving the principle of electric generator.
2. The below figure shows the results of magnetic particles inspection experiment. What can you conclude from it? d) Discuss which hysteresis is better to be used with the AC generator in the airplane. e) In general, describe the structural, elasticity and electrical properties of copper and the PVC insulator (polymeric) with reference to their material properties. f) How metals and non-metals (ceramics and polymers) could be degraded?
Given a center tapped transformer, plot the output wave form. (Assuming practical model)
Verify the following property of the twiddle factor:
If the core of LVDT is at the middle, then the output voltage will be a. maximum b. minimum c. Output voltage is no relation with core position d. 0
Which of the ff given below is the eddy current loss not proportional to? Square of the frequency Square of the flux density Square of the load current of the laminated core Square of the thickness