(II) Two masses, mA = 35.0 kg and mB = 38.0 kg, are connected by a rope that hangs over a pulley (as in Fig. 10-59). The pulley is a uniform cylinder of radius 0.381 m and mass 3.1 kg. Initially ma is on the ground and mB rests 2.5 m above the ground. If the system is released, use conservation of energy to deter- mine the speed of mB just before it strikes the ground. Assume the pulley bearing is frictionless. %3D RO mB mA 2.5 m FIGURE 10-59 ba Problem 67. inoni lo (IID) A.

(II) Two masses, mA = 35.0 kg and mB = 38.0 kg, are connected by a rope that hangs over a pulley (as in Fig. 10-59). The pulley is a uniform cylinder of radius 0.381 m and mass 3.1 kg. Initially ma is on the ground and mB rests 2.5 m above the ground. If the system is released, use conservation of energy to deter- mine the speed of mB just before it strikes the ground. Assume the pulley bearing is frictionless. %3D RO mB mA 2.5 m FIGURE 10-59 ba Problem 67. inoni lo (IID) A.

Classical Dynamics of Particles and Systems

5th Edition

ISBN:9780534408961

Author:Stephen T. Thornton, Jerry B. Marion

Publisher:Stephen T. Thornton, Jerry B. Marion

Chapter9: Dynamics Of A System Of Particles

Section: Chapter Questions

Problem 9.16P

See similar textbooks

Similar questions

(II) A rotating uniform cylindrical platform of mass 220 kg and radius 5.5 m slows down from 3.8 rev/s to rest in 16 s when the driving motor is disconnected. Estimate the power output of the motor (hp) required to maintain a steady speed of 3.8 rev/s.
A wheel of mass M has radius R. It is standing vertically on the floor, and we want to exert a horizontal force Fat its axle so that it will climb a step against which it rests (Fig. 8–60). The step has height h, where h < R. What minimum force F is needed? R FIGURE 8-60 Problem 85.
A screwdriver turns a screw an angle of 5.85 radians by applying a torque given by (in Nm) 02 T=2.12 + 6. Calculate the work done, W by the torque. Enter W, measured in Joules, correct to three significant figures:
14-89. When the 6-kg box reaches point A it has a speed of vA = 2 m/s. Determine the angle 0 at which it leaves the smooth circular ramp and the distance s to where it falls into the cart. Neglect friction. VA = 2 m/s 20° B 1.2 m
A light rope was wrapped around the cylinder, which can freely rotate around the axis passing through its center with mass Mand radius R, and passed over a pulley, which is considered to be massless and frictionless, and a mass of 4m was attached to its end and the system was released from the height h from rest. What is the speed of a 4m object when it hits the ground? (nder =Mr?)
(i) How much work must be done to stop it? rotating at 50 rad/s. It must be brought to stop in 10 s.
- (II) Two masses, m. nected by a rope that hangs over a pulley (as in Fig. 8–54). The pulley is a uniform cylinder of radius R = 0.311 m and mass 3.1 kg. Initially ma is on the ground and mg rests 2.5 m above the ground. If the system is released, use conservation of energy to determine the speed of mg just before it strikes the ground. Assume the pulley bearing 32.0 kg and mg = 38.0 kg, are con- R is frictionless. mB 2.5 m FIGURE 8-54 Problem 58.
18) A ball has a mass of 3 kg. It is connected to a spring that is displaced x = 0.5m away from its equilibrium length. The spring has spring constant k = 300N/m. Af- ter the spring is compressed, the ball rolls along a frictionless surface until it reaches an incline with an angle of 30•. What is the maximum height the ball reaches?
(I) The Sun subtends an angle of about 0.5° to us on Earth,150 million km away. Estimate the radius of the Sun.
(II) A potter’s wheel is rotating around a vertical axis through its center at a frequency of 1.5 rev/s. The wheel can be considered a uniform disk of mass 5.0 kg and diameter 0.40 m. The potter then throws a 2.6-kg chunk of clay,approximately shaped as a flat disk of radius 7.0 cm, onto the center of the rotating wheel. What is the frequency of the wheel after the clay sticks to it? Ignore friction.
A small mass m on a string is rotating without friction in acircle. The string is shortened by pulling it through the axisof rotation without any external torque, Fig. 8–39. Whathappens to the tangential velocity of the object?(a) It increases.(b) It decreases.(c) It remains the same.
6) Z. A thin non-condu cting rod of ma ss m and length L = 60cm, slides frictionl essly at a constant speed V = 0.5 m/s along the rails placed on the surface and at the edges of an inclined plane with the effect of an external force. The rails at the edges of the inclined plane are connected with each other via the rail at the bottom edge of the plane, so the rod and rails forms a rectangular closed loop as seen in the figure. The plane of the rails makes an angle 0 = 55° with the horizontal plane (xz plane). Before sliding, the rod stays at the di stan ce S = 4m measured from the bottom edge of the inclined plane. The inclined plane and the rod are under the effect of a uniform magnetic field given by B = 0.40î + 3ĵ + 0.8k(T). After the rod starts to slide, what will be the magnetic flux passing through the surface formed by the rod, the rails at the edges, and the rail at the bottom edge of the inclined plane at t=4s? A) 1.50 Wb B) 7.53 Wb C) 0.083 Wb D) 0.147 Wb E) 1.67 Wb